This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Analysis and Control of Transient Flow in the Diesel Injection System Part II - Design Results of Controlled After-Injection
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 01, 1973 by SAE International in United States
Annotation ability available
Event: Fleet Week
After-injection is the introduction of additional fuel to the combustion chamber after the end of the main injection. It is a persistent diesel fuel injection problem which usually results in reduced engine power and economy and increased emissions. After-injection is caused by uncontrolled pressure transients at the injector after the opening of the pump spill port. These pressure transients are related to the wave propagation phenomena in the high-pressure pipeline connecting the pump and injector. Use of experimental trial-and-error methods in attempts to control this phenomenon has met with limited success.
The analytical control method described in another paper is used to determine design means by which after-injection may be controlled. Further investigation and evaluation of two design changes which release the injection system excess elastic energy in a controlled manner are considered herein. One design change is the addition of a control valve in the pump delivery chamber. The other is the modification of the pump spill port. In both cases, pressures and flows are not altered during the main injection period. The ability of both design changes to control after-injection is confirmed by use of a simulation program. Experimental data from a system with the pump spill port modified in accordance with theoretical design calculations provide satisfactory confirmation of the analyses.
CitationEl-Erian, M., Wylie, E., and Bolt, J., "Analysis and Control of Transient Flow in the Diesel Injection System Part II - Design Results of Controlled After-Injection," SAE Technical Paper 730662, 1973, https://doi.org/10.4271/730662.
- Guglielmotti A. “Influence of the Construction Characteristics of the Injection Pumps on Some Phenomena of Instability and Irregularity of Diesel Engine Operation.” Tech. Bulletin IX 3 July-September 1956 Fiat Co. Torino, Italy
- Lustgarten G. Dolenc A. “Development of Injection System for Medium-Speed Diesel Engine with Quiescent-Type Combustion Chamber.” Diesel Combustion Symposium Inst. Mech. Engrs. London April 1970
- El-Erian Mohamed F. Wylie E. Benjamin Bolt Jay A. “Analysis and Control of Transient Flow in the Diesel Injection System, Part I-The Analytical Control Method.” Paper 730661 SAE Combined Commercial Vehicle Engineering and Operations and Powerplant Meetings Chicago June 1973
- El-Erian M. F. “Simulation and Control of Transient Flow in the Diesel Injection System.” The University of Michigan April 1972
- Wylie E. B. Bolt J. A. El-Erian M. F. “Diesel Fuel Injection System Simulation and Experimental Correlation.” SAE Transactions 80 1971 paper 710569
- Bolt Jay A. El-Erian M. F. “Diesel Ignition, Combustion and Emissions.” Progress report No. 19 submitted to the U.S. Army Tank Automotive Command Warren, Michigan September 1972