This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Study of Seat and Head-Support Performance During Full-Scale Rear-End Collisions
Annotation ability available
Sector:
Language:
English
Abstract
Scientific methodology and engineering techniques were applied to the initial 4 of a series of 12 automobile rear-end collision experiments to provide data relating to seat and head support design. Two speeds of impact, three seatback heights, and two seatback strength values were studied. This is a study to evaluate the relative protective merits and the practicality of various seat designs with respect to the many
variables common to rear-end collisions. This basic research data will provide a standard reference system for determining collision performance of seat and head support designs with respect to occupant size, posture, and proximity to injury-producing structures.
IN THIS SERIES OF FOUR COLLISION EXPERIMENTS, a stationary 1967 4-door sedan was rear-ended by an identical striking car for each experiment. In the first experiment, the striking car was traveling at 30 mph; in the second experiment, at 20 mph; and in the remaining two experiments, at 30 mph. Triaxial acceleration data for the heads and chests of the four 95th percentile anthropometric dummies, considered in conjunction with micromotion analysis of body kinematics and related instrumentation, provided information on the relative effectiveness of the head support and seatback designs. For the rear-ended motorist, the forces of collision involuntarily place him in an acutely adverse posture, representing the primary injury problem; the magnitude of force application is secondary. Using high-speed photography, micromotion analysis of the rear-ended motorist provided a basis for correlating relative performances of whiplash restraining systems, with respect to the forced movements and recorded accelerations of occupants. Other factors relating to the rear-end collision problem that were evaluated and quantified include performance of seats, head supports, seat anchorages, seatback deflection and permanent deformation, lap belts, and padding for passenger protection.
Photographic instrumentation included eight high-speed cameras mounted on the collision vehicles to provide close-up, continuous monitoring of occupant movements during these quarter-second collision events. These vehicle cameras were supported by 19 additional photographic units installed on towers and at ground positions about the collision impact area. Data from photographic and electronic instrumentation are presented in this report using techniques designed to facilitate information retrieval and to convey a maximum amount of information with a cursory review of the paper.
Recommended Content
| Technical Paper | Backrest and Head Restraint Design for Rear-End Collision Protection |
| Technical Paper | AUTOMOBILE BARRIER AND REAR-END COLLISION PERFORMANCE |
| Technical Paper | Safer Seat Designs |
Authors
- Derwyn M. Severy - Institute of Transportation and Traffic Engineering, University of California, Los Angeles
- Harrison M. Brink - Institute of Transportation and Traffic Engineering, University of California, Los Angeles
- Jack D. Baird - Institute of Transportation and Traffic Engineering, University of California, Los Angeles
Topic
Citation
Severy, D., Brink, H., and Baird, J., "Study of Seat and Head-Support Performance During Full-Scale Rear-End Collisions," SAE Technical Paper 670921, 1967, https://doi.org/10.4271/670921.Also In
References
- Severy D.M. Mathewson J.H. Bechtol C.O. “Controlled Automobile Rear-End Collisions - An Investigation of Related Engineering and Medical Phenomena, Series I.” Canadian Service Medical Journal XI November 1955 727 759
- Severy D.M. Mathewson J.H. “Automobile Barrier and Rear-End Collision Performance.” SAE Summer Meeting Atlantic City June 1958
- Severy D.M. Brink H.M. Baird Jack D. “School Bus Passenger Protection.” SAE Automotive Engineering Congress Detroit January 1967
- Severy D.M. Brink H.M. Baird J.D. “Collision Performance LM Safety Car.” SAE Mid-Year Meeting Chicago May 1967
- Gay J.R. Abbott K.H. “Common Whiplash Injuries of the Neck.” Jrl. Am. Med. Assoc. 152 1698 1953
- Ommaya Ayub K. Hirsch Arthur E. Martinez John L. “The Role of ‘Whiplash’ in Cerebral Concussion.” proceedings of the Tenth Stapp Car Crash Conference November 1966
- Wickstrom J. Martinez J.L. Johnston D. Tappen N.C. “Acceleration-Deceleration Injuries of the Cervical Spine in Animals.” Proceedings of the Seventh Stapp Car Crash Conference November 1963
- Severy D.M. Mathewson J.H. Siegel A.W. “Automobile Head-On Collisions, Series II.” SAE Transactions 67 1959 238 262
- Severy D.M. Brink H.M. “Safety Glass Breakage by Motorists During Collisions.” Proceedings of the Ninth Stapp Car Crash 1965
- Severy D.M. Brink H.M. Baird J.D. “Backrest and Head Restraint Design for Rear-End Collision Protection.” SAE Automotive Engineering Congress Detroit January 1968