This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Innovative Piston Design Performance for High Efficiency Stoichiometric Heavy Duty Natural Gas Engine
Technical Paper
2023-01-0288
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Internal combustion engines will continue to be the leading power-train in the heavy-duty, on-highway sector as technologies like hydrogen, fuel cells, and electrification face challenges. Natural gas (NG) engines offer several advantages over diesel engines including near zero particle matter (PM) emissions, lower NOx emissions, lower capital and operating costs, availability of vast domestic NG resources, and lower CO2 emissions being the cleanest burning of all hydrocarbons (HC). The main limitation of this type of engine is the lower efficiency compared to diesel counterparts. Addressing the limitations (knock and misfire) for achieving diesel-like efficiencies is key to accomplishing widespread adoption, especially for the US market.
With the aim to achieve high brake thermal efficiency (BTE), three (3) computational fluid dynamics (CFD) optimized pistons with three different compression ratios (CR) have been tested. Tests were carried out using a Cummins ISX-based 2.5-liter single-cylinder heavy-duty engine. A custom exhaust gas recirculation (EGR) system that simulates a high-pressure EGR loop was used to achieve EGR rates from 0 to 35%. The measurements were performed with variable EGR rate, IMEP, and rate of combustion.
Limitations on combustion control and high knock tendency were found on the highest CR piston, as limited heat transfer led to overheating of the piston crown. Higher BTE was achieved for two of the pistons tested, with peak values above 44%, the baseline efficiency of the diesel engine platform used. Controlled end-gas autoignition was achieved, contributing to the increase in peak BTE and expanding the engine load range. The positive results obtained with the CFD-optimized piston designs encourage the continued development of heavy-duty NG engines as feasible alternatives to reduce CO2 and NOx emissions, PM, and diesel fuel dependency.
Authors
Topic
Citation
rodriguez, J., Xu, H., Hampson, G., Bestel, D. et al., "Innovative Piston Design Performance for High Efficiency Stoichiometric Heavy Duty Natural Gas Engine," SAE Technical Paper 2023-01-0288, 2023, https://doi.org/10.4271/2023-01-0288.Also In
References
- Reitz , R.D. Directions in Internal Combustion Engine Research Combustion and Flame 160 2013 1 8
- U.S. Energy Information Administration 2021 https://www.eia.gov/outlooks/ieo/pdf/IEO2021_ReleasePresentation.pdf
- Kalghatgi , G. The Outlook for Fuels for Internal Combustion Engines International Journal of Engine Research 15 2014 383 398
- Kalghatgi , G.T. Developments in Internal Combustion Engines and Implications for Combustion Science and Future Transport Fuels Proceedings of the Combustion Institute 2015 35
- Shukla , P. , Skea , J. , Buendia , E.C. , Masson-Delmotte , V. , Pörtner , H. , Roberts , D. , Zhai , P. , Slade , R. , Connors , S. and Diemen , R.V. 2019
- Liu , J. and Dumitrescu , C.E. Limitations of Natural Gas Lean Burn Spark Ignition Engines Derived from Compression Ignition Engines Journal of Energy Resources Technology 140 12 2020 122308-1-9
- Heywood , J. Internal Combustion Engine Fundamentals New York McGraw-Hill 1998
- Dumitrescu , C. , Padmanaban , V. , and Liu , J. An Experimental Investigation of Early Flame Development in an Optical SI Engine Fueled with Natural Gas Journal of Engineering for Gas Turbines and Power 140 2018 082802
- Mitchell , R.H. and Olsen , D.B. Extending Substitution Limits of a Diesel–Natural Gas Dual Fuel Engine Journal of Energy Resources Technology 140 2018 052202
- Kirkpatrick , A.T. Internal Combustion Engines: Applied Thermosciences Wiley 2020
- Mohr , J. , Zdanowicz , A. , Tryner , J. , Gustafson , K. , Venegas , J. , Windom , B. , Olsen , D. , and Marchese , A. Ignition, Flame Propagation, and End-Gas Autoignition Studies of Natural Gas/EGR Blends in a Rapid Compression Machine 2019 WSSCI Fall Technical Meeting Albuquerque, New Mexico 2019
- Mohr , J. 2020
- Li , F. , Liu , C. , Song , H. , and Wang , Z. Improving Combustion and Emission Characteristics in Heavy-Duty Natural-Gas Engine by Using Pistons Enhancing Turbulence SAE Technical Paper 2018-01-1685 2018 https://doi.org/10.4271/2018-01-1685
- Zdanowicz , A. 2019
- Bestel , D. , Windom , B. , Olsen , D. , Marchese , A. , Bayliff , S. and Xu , H. 3-D Modeling of the CFR Engine for the Investigation of Knock on Natural Gas 2019 Fall Meeting of the Western States Section of The Combustion Institute Albuquerque, New Mexico 2019
- Bayliff , S. , Marchese , A. , Windom , B. and Olsen , D. The Effect of EGR on Knock Suppression, Efficiency, and Emissions in a Stoichiometric, Spark Ignited, Natural Gas Engine 2019 WSSCI Fall Technical Meeting Albuquerque, New Mexico 2019
- Bayliff , S. 2020
- Bestel , D. , Rodriguez , J. , Marchese , A. , Olsen , D. et al. Detection and Onset Determination of End-Gas Autoignition on Spark-Ignited Natural Gas Engines Based on the Apparent Heat Release Rate SAE Technical Paper 2022-01-0474 2022 https://doi.org/10.4271/2022-01-0474
- Woodward Inc https://www.woodward.com/en/shop/woodward44-electronic-controls/fti-family
- Bayliff , S. , Windom , B. , Marchese , A. , Hampson , G. , Carlson , J. , Chiera , D. , and Olsen , D. Controlled End Gas Auto Ignition with Exhaust Gas Recirculation on a Stoichiometric, Spark Ignited, Natural Gas Engine Proceedings of the ASME 2020 Internal Combustion Fall Technical Conference 2020
- MAN Energy Solutions https://www.man-es.com/energy-storage/services/methane-number-calculator
- Fosudo , T. , Kar , T. , Marchese , A. , Windom , B. et al. The Impact of LPG Composition on Performance, Emissions, and Combustion Characteristics of a Pre-mixed Spark-Ignited CFR Engine SAE Technical Paper 2022-01-0476 2022 https://doi.org/10.4271/2022-01-0476
- Bestel , D.B. 2022
- Karnik , A.Y. and Shelby , M.H. Effect of Exhaust Gas Temperature Limits on the Peak Power Performance of a Turbocharged Gasoline Engine Journal of Engineering for Gas Turbines and Power 132 2010 11
- Rodriguez , J.F. , Xu , H. , Hampson , G. , Windom , B. et al. Heavy Duty Natural Gas Single Cylinder Research Engine Installation, Commissioning, and Baseline Testing Energy and Power Engineering 2022 12
- Bestel , D. , Bayliff , S. , Marchese , A. , Olsen , D. , Windom , B. , and Xu , H. Multi-Dimensional Modeling of the CFR Engine for the Investigation of SI Natural Gas Combustion and Controlled End-Gas Autoignition ASME 2020 Internal Combustion Engine Division Fall Technical Conference 2020