This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Numerical Simulation of Non-reacting Ducted Fuel Injection by Means of the Diffuse-Interface Σ-Y Atomization Model
Technical Paper
2022-01-0491
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Ducted Fuel Injection (DFI) is a new technology recently developed with the aim of reducing soot emission formation in diesel compression ignition engines. DFI concept consists of the injection of fuel spray through a small duct located downstream of the injector nozzle leaving a certain gap, the so-called Stand-off distance. Currently, CFD modelers have investigated its performance using classical spray modeling techniques such as the Discrete Drops Method (DDM). However, as discussed in the literature, this type of technique is inappropriate when applied to dense jets as those occurring in diesel sprays, especially in the near-nozzle region (where the duct is placed). Therefore, considering a more appropriate modeling technique for such a problem is mandatory. In this research work, an Eulerian single-fluid diffuse-interface model called Σ-Y and implemented in the OpenFOAM framework is utilized for the simulation of non-reacting conditions. The model relevance is twofold, as it is particularly suited for the dense spray regions existing in the vicinity of the nozzle exit and inside the duct, and because it includes a coupled drift flux model for dilute spray regions. An analysis of free-jet performance against DFI one is presented considering a single diesel jet injected from a 180 μm orifice in a constant volume vessel. In this regard, a 2 mm internal diameter, 14 mm long duct was studied, while the duct sharp inlet was positioned 2 mm downstream of the nozzle orifice. A deep insight into the mixing process is conducted to take advantage of the valuable Eulerian framework tool and thus, enhancing the understanding of DFI process.
Authors
Citation
Pandal, A., Rahantamialisoa, F., Sahranavardfard, N., Postrioti, L. et al., "Numerical Simulation of Non-reacting Ducted Fuel Injection by Means of the Diffuse-Interface Σ-Y Atomization Model," SAE Technical Paper 2022-01-0491, 2022, https://doi.org/10.4271/2022-01-0491.Also In
References
- Mueller , C.J. , Nilsen , C.W. , Ruth , D.J. et al. Ducted Fuel Injection: A New Approach for Lowering Soot Emissions from Direct-Injection Engines Applied Energy 204 2017 206 220
- Gehmlich , R.K. , Mueller , C.J. , Ruth , D.J. , Nilsen , C.W. et al. Using Ducted Fuel Injection to Attenuate or Prevent Soot Formation in Mixing Controlled Combustion Strategies for Engine Applications Applied Energy 226 2018 1169 1186
- Nilsen , C. , Biles , D.E. , Wilmer , B.M. et al. Investigating the Effects of Duct Length and Diameter and Fuel-Injector Orifice Diameter in a Compression-Ignition Engine Equipped with Ducted Fuel Injection Applications in Energy and Combustion Science 7 2021 100030
- Fitzgerald , R. , Svensson , K. , Martin , G. , Qi , Y. et al. Early Investigation of Ducted Fuel Injection for Reducing Soot in Mixing-Controlled Diesel Flames SAE Int. J. Engines 11 6 2018 817 833
- Pickett , L. and Siebers , D. Non-Sooting, Low Flame Temperature Mixing-Controlled DI Diesel Combustion SAE Technical Paper 2004-01-1399 2004 https://doi.org/10.4271/2004-01-1399
- Millo , F. , Piano , A. , Peiretti Paradisi , B. , Postrioti , L. et al. Ducted Fuel Injection: Experimental and Numerical Investigation on Fuel Spray Characteristics, Air/Fuel Mixing and Soot Mitigation Potential Fuel 289 2021 119835
- Fitzgerald , R. , Svensson , K. , and Martin , G. 2021
- Millo , F. , Piano , A. , Peiretti Paradisi , B. , Segatori , C. et al. Ducted Fuel Injection: A Numerical Soot-Targeted Duct Geometry Optimization SAE Int. J. Engines 15 2 2022
- Svensson , K. and Martin , G. Ducted Fuel Injection: Effects of Stand-Off Distance and Duct Length on Soot Reduction SAE Int. J. Adv. & Curr. Prac. in Mobility 1 3 2019 1074 1083
- Pandal , A. , Ningegowda , B.M. , Rahantamialisoa , F.N.Z. , Zembi , J. et al. Development of a Drift-Flux Velocity Closure for a Coupled Σ-Y Spray Atomization Model International Journal of Multiphase Flow 141 2021 103691
- Pandal , A. , Rahantamialisoa , F. , Ningegowda , B.M. , and Battistoni , M. An Enhanced Σ-Y Spray Atomization Model Accounting for Diffusion Due to Drift- Flux Velocities SAE Int. J. Adv. & Curr. Prac. in Mobility 2 5 2020 2681 2690
- Ishii , M. and Hibiki , T. Thermo Fluid Dynamics of Two Phase Flow New York Springer 2006
- Reid , R. , Prausnitz , J. , and Poling , B. The Properties of Gases and Liquids McGraw-Hill 1987
- Pandal , A. , García-Oliver , J.M. , and Pastor , J.M. Eulerian CFD Modeling of Nozzle Geometry Effects on ECN Spray A and D: Assessment and Analysis International Journal of Engine Research 21 1 2020 73 88
- Desantes , J. , García-Oliver , J. , Pastor , J. , Olmeda , I. et al. LES Eulerian Diffuse-Interface Modeling of Fuel Dense Sprays Near- and Far-Field International Journal of Multiphase Flow 127 2020 103272
- Faeth , G.M. Evaporation and Combustion of Sprays Prog. Energy Combust. Sci. 9 1-2 1983 1 76
- Siebers , D.L. Scaling Liquid-Phase Fuel Penetration in Diesel Sprays Based on Mixing-Limited Vaporization Trans. SAE 108 1999 703 728
- Pitzer , K.S. , Lippmann , D.Z. , Curl , R.F. Jr. , Huggins , C.M. et al. The Volumetric and Thermodynamic Properties of Fluids. II. Compressibility Factor, Vapor Pressure and Entropy of Vaporization J Am Chem Soc 77 13 1955 3433 3440
- Vallet , A. and Borghi , R. Modélisation Eulerienne de l’atomisation d’un Jet Liquid C.R. Acad. Sci, Paris 327 1999 1015 1020
- Lebas , R. , Menard , T. , Beau , P.A. , Berlemont , A. et al. Numerical Simulation of Primary Break-Up and Atomization: DNS and Modeling Study International Journal of Multiphase Flow 35 2009 247 260
- Duret , B. , Reveillon , J. , Menard , T. , and Demoulin , F.X. Improving Primary Atomization Modeling Through DNS of Two-Phase Flows International Journal of Multiphase Flow 55 2013 130 137
- Rachakonda , S. , Wang , Y. , and Schmidt , D.P. Flash Boiling: A Parametric Study ILASS Americas 28th Annual Conference on Liquid Atomization and Spray Systems 2016
- Pandal , A. , García-Oliver , J.M. , Novella , R. , and Pastor , J.M. A Computational Analysis of Local Flow for Reacting Diesel Sprays by Means of an Eulerian CFD Model International Journal of Multiphase Flow 99 2018 257 272
- Pandal , A. , Pastor , J.M. , Payri , R. , Kastengren , A. et al. Computational and Experimental Investigation of Interfacial Area in Near-Field Diesel Spray Simulation SAE Int. J. Fuels Lubr. 10 2 2017 10.4271/2017-01-0859
- Manninen , M. , Taivassalo , V. , and Kallio , S. On the Mixture Model for Multiphase Flow VTT 1996
- Simonin , O. Eulerian Formulation for Particle Dispersion in Turbulent Two-Phase Flows Proc. 5th Workshop on Two-Phase Flow Predictions March 19-22 Erlangen 156 166 1990
- Rusche , H. , and Issa , R. The Effects of Voidage on the Drag Force on Particles, Droplets and Bubbles in Dispersed Two-Phase Flow Proc. 2nd Japanese-European Two-Phase Flow Group Meeting 2000 Tsukuba (Japan)
- Desantes , J.M. , Margot , X. , Pastor , J.M. , Chavez , M. et al. CFD- Phenomenological Diesel Spray Analysis Under Evaporative Conditions Energy Fuels 23 8 2009 3919 3929
- Shiller , L. and Naumann , Z. A Drag Coefficient Correlation Zeitschrift des Vereins Deutscher Ingenieure 77 1935 318 320
- Ishii , M. and Zuber , N. Drag Coefficient and Relative Velocity in Bubbly, Droplet or Particulate Flows AIChE J. 25 5 1979 843 855
- Millo , F. , Piano , A. , Paradisi , B. , Segatori , C. et al. Ducted Fuel Injection: A Numerical Soot-Targeted Duct Geometry Optimization SAE Int. J. Engines 15 2 2022 10.4271/03-15-02-0014
- Pope , S. An Explanation of the Turbulent Jet/Plane Jet Anomaly AIAA 16 1978 279 281
- Pandal , A. , Pastor , J.M. , García-Oliver , J.M. , Baldwin , E. et al. A Consistent, Scalable Model for Eulerian Spray Modeling International Journal of Multiphase Flow 83 2016 162 171
- Ningegowda , B.M. , Rahantamialisoa , F.N.Z. , Pandal , A. , Jasak , H. et al. Numerical Modeling of Transcritical and Supercritical Fuel Injections Using a Multi-Component Two-Phase Flow Model Energies 13 2020 5676