This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Numerical Investigation of In-Cylinder Tumble/Swirl Flow on Mixing, Turbulence and Combustion of Methane in SI Engine
Technical Paper
2020-01-2013
ISSN: 0148-7191, e-ISSN: 2688-3627
This content contains downloadable datasets
Annotation ability available
Sector:
Language:
English
Abstract
In the present work, the in-cylinder tumble/swirl flow and its effect on the homogeneity, turbulence, and combustion of methane are investigated in a canted valve engine using ANSYS. The study is focused on the impact of initial swirl and tumble on the charge preparation, turbulent kinetic energy, and combustion of methane. The flow simulation was performed in ANSYS using hybrid mesh for cold flow simulation to study the tumble/swirl flow variation. For combustion simulation, a 2D axisymmetric model was used with an initial swirl and tumble ratio for studying the effect on premixed combustion. The flow simulation was performed for suction and compression to see the variation in the swirl and tumble with crank position and engine speed. The combustion simulation was performed only for compression and power stroke to save the computation time. The results depict that the flow inside the cylinder plays a significant role in the preparation of a homogeneous charge. Tumble/swirl mainly affects the turbulence as the tumble increases, and the peak combustion pressure is shifted few crank angle degrees earlier, which leads to higher dissipation. Turbulent kinetic energy increases rapidly with an increase in swirl and tumble because the disturbance gets amplified with higher flow variation. Thus, more energy is added to the flow at TDC because of increased vortices in the flow due to breakdown in tumble, which leads to proper mixing and smooth combustion.
Authors
Citation
Yadav, N., Saxena, M., and Maurya, R., "Numerical Investigation of In-Cylinder Tumble/Swirl Flow on Mixing, Turbulence and Combustion of Methane in SI Engine," SAE Technical Paper 2020-01-2013, 2020, https://doi.org/10.4271/2020-01-2013.Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 | ||
Unnamed Dataset 2 | ||
Unnamed Dataset 3 | ||
Unnamed Dataset 4 | ||
Unnamed Dataset 5 |
Also In
References
- Maurya , R.K. 2018 Characteristics and Control of Low Temperature Combustion Engines Springer 978-3-319-68507
- Fontana , G. , and Galloni , E. Variable Valve Timing for Fuel Economy Improvement in a Small Spark-Ignition Engine Applied Energy 86 1 96 105 2009
- Merola , S.S. , Sementa , P. , Tornatore , C. , and Vaglieco , B.M. Effect of the Fuel Injection Strategy on the Combustion Process in a PFI Boosted Spark-Ignition Engine Energy 35 2 1094 1100 2010
- Lumsden , G. , Eddleston , D. , and Sykes , R. Comparing Lean Burn and EGR SAE Technical Paper 970505 1997 https://doi.org/10.4271/970505
- Wang , S. , Ji , C. , and Zhang , B. Effects of Hydrogen Addition and Cylinder Cutoff on Combustion and Emissions Performance of a Spark-Ignited Gasoline Engine Under a Low Operating Condition Energy 35 12 4754 4760 2010
- Lumley , J.L. Engines: an Introduction Cambridge University Press 1999
- Söder , M. , Prahl Wittberg , L. , Lindgren , B. , and Fuchs , L. Effect of Swirl/Tumble (Tilt) Angle on Flow Homogeneity, Turbulence and Mixing Properties SAE Technical Paper 2014-01-2579 2014 https://doi.org/10.4271/2014-01-2579
- Chang , H. , Huang , C. , Lin , K. , and Hu , W. Effects of Intake System with Swirl and Tumble Valve on the Combustion in a Small Four Stroke Engine SAE Technical Paper 2013-32-9002 2013 https://doi.org/10.4271/2013-32-9002
- Königsson , F. , Dembinski , H. , and Angstrom , H. The Influence of In-Cylinder Flows on Emissions and Heat Transfer from Methane-Diesel Dual Fuel Combustion SAE Int. J. Engines 6 4 1877 1887 2013 https://doi.org/10.4271/2013-01-250
- Dembinski , H. , and Angstrom , H. Optical Study of Swirl during Combustion in a CI Engine with Different Injection Pressures and Swirl Ratios Compared with Calculations SAE Technical Paper 2012-01-0682 2012 https://doi.org/10.4271/2012-01-0682
- E , J. , and Dhandapani , S. A Comparison of Two Injectors in Mixture Preparation for a High Tumble GDI Engine - A CFD Study SAE Technical Paper 2012-01-0398 2012 https://doi.org/10.4271/2012-01-0398
- Dembinski , H. , and Ångström , H. An Experimental Study of the Influence of Variable In-Cylinder Flow, Caused by Active Valve Train, on Combustion and Emissions in a Diesel Engine at Low Lambda Operation SAE Technical Paper 2011-01-1830 2011 https://doi.org/10.4271/2011-01-1830
- Battistoni , M. , Cancellieri , A. , and Mariani , F. Steady and Transient Fluid Dynamic Analysis of the Tumble and Swirl Evolution on a 4V Engine with Independent Intake Valves Actuation SAE Technical Paper 2008-01-2392 2008 https://doi.org/10.4271/2008-01-2392
- He , Y. , Selamet , A. , Reese , R. , Vick , R. et al. Effect of Intake Primary Runner Blockages on Combustion Characteristics and Emissions with Stoichiometric and EGR-diluted Mixtures in SI Engines SAE Technical Paper 2007-01-3992 2007 https://doi.org/10.4271/2007-01-3992
- Kim , M. , Lee , S. , and Kim , W. Tumble Flow Measurements Using Three Different Methods and its Effects on Fuel Economy and Emissions SAE Technical Paper 2006-01-3345 2006 https://doi.org/10.4271/2006-01-3345
- Schock , H. , Shen , Y. , Timm , E. , Stuecken , T. et al. The Measurement and Control of Cyclic Variations of Flow in a Piston Cylinder Assembly SAE Technical Paper 2003-01-1357 2003 https://doi.org/10.4271/2003-01-1357
- Li , Y. , Zhao , H. , Peng , Z. , and Ladommatos , N. Analysis of Tumble and Swirl Motions in a Four-Valve SI Engine SAE Technical Paper 2001-01-3555 2001 https://doi.org/10.4271/2001-01-3555
- Lee , S. , Tong , K. , Quay , B. , Zello , J. et al. Effects of Swirl and Tumble on Mixture Preparation During Cold Start of a Gasoline Direct-Injection Engine SAE Technical Paper 2000-01-1900 2000 https://doi.org/10.4271/2000-01-1900
- Alger , T. , Hall , M. , and Matthews , R. Effects of Swirl and Tumble on In-Cylinder Fuel Distribution in a Central Injected DISI Engine SAE Technical Paper 2000-01-0533 2000 https://doi.org/10.4271/2000-01-0533
- Hu , X. , and Lokhande , B. Simulation and Validation of IC Engine Swirl/Tumble Using Different Meshing Strategies SAE Technical Paper 2006-01-1195 2006 https://doi.org/10.4271/2006-01-1195
- Alger , T. , Blobaum , E. , McGee , J. , and Wooldridge , S. PIV Characterization of a 4-Valve Engine with a Camshaft Profile Switching (CPS) System SAE Transactions 1066 1078 2003
- Górniak , A. , Midor , K. , Kaźmierczak , J. , and Kaniak , W. Advantages and Disadvantages of Using Methane from CNG in Motor Vehicles in Polish Conditions Multidisciplinary Aspects of Production Engineering 1 1 241 247 2018
- Fluent , A. 2010
- Lumley , J.L. 1999
- https://www.f1technical.net/forum/viewtopic.php?t=18874&start=9330
- Anderson , J.D. Jr. Fundamentals of Aerodynamics 2nd New York McGraw-Hill 1991
- Liepmann , H.W. , and Roshko , A. Elements of Gasdynamics New York Wiley 1957
- Anderson , J.D. Jr. Modern Compressible Flow: With Historical Perspective 2nd New York McGraw-Hill 1990
- Bird , R.B. , Stewart , W.E. , and Lightfoot , E.N. Transport Phenomena 2nd Wiley 2004
- Kutler , P. Computation of Three-Dimensional, Inviscid Supersonic Flows Wirz , H.J. Progress in Numerical Fluid Dynamics Berlin Springer-Verlag 1975 293 374
- Lee , S.W. , Lee , H.S. , Park , Y.J. , and Cho , Y.S. Combustion and Emission Characteristics of HCNG in a Constant Volume Chamber Journal of Mechanical Science and Technology. 25 2 489 494 2011 Feb 1