This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of Quantitative Fuel Film Distribution Measurement by LIEF Technique and Application to Gasoline Spray
Technical Paper
2020-01-1159
ISSN: 0148-7191, e-ISSN: 2688-3627
This content contains downloadable datasets
Annotation ability available
Sector:
Language:
English
Abstract
From the point of global and local environment, internal combustion engine is facing the need for significant improvement of exhaust emission. Especially, important is the reduction of unburned hydrocarbon (HC) from fuel film on liner under cold condition. In this study, at first, quantitative fuel film measurement technique by using Laser Induced Exciplex Fluorescence (LIEF) was developed. For the light source, 4th harmonic pulse yttrium aluminum garnet (YAG) laser (266nm) was used. For the tracer, the combination of N,N-Dimethylaniline (DMA) and naphthalene was used and quantitative concentration was decided by calibration test. With LIEF, the distribution of fuel film can be obtained by measuring the fluorescence only from the liquid phase. In order to evaluate the effect of fuel film on exhaust HC emission from engine, the film distribution was measured using quartz glass liner. For the injector, a prototype 6-hole gasoline injector was used. For the evaluation of total amount of fuel film on liner, the film distribution image was taken from both the exhaust and front side. The effect of fuel pressure (between 20 to 60 MPa) and of temperature was analyzed. Then, the correlation between the measured total amount of fuel film and the unburned HC from the engine was confirmed by the engine test. Additionally, a computer fluid dynamics (CFD) simulation model was validated against the measured results and a design with better flow rate of each hole was proposed. Additionally, the fuel film results were tried to explain from the character of spray. Spray velocity and vaporization rate were decided by direct scattering measurement of spray. And liquid particle diameter was also measured by two methods [phase Doppler particle analyzer (PDPA), combination of Mie scattering and LIEF]. These spray results were compared with theory and confirmed the validity of the results. Finally, the effect of fuel pressure and temperature et al. to fuel film was explained by the measured spray character.
Recommended Content
Authors
Citation
Mori, S., Sakai, H., Nogawa, S., and Nakatani, K., "Development of Quantitative Fuel Film Distribution Measurement by LIEF Technique and Application to Gasoline Spray," SAE Technical Paper 2020-01-1159, 2020, https://doi.org/10.4271/2020-01-1159.Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 | ||
Unnamed Dataset 2 | ||
Unnamed Dataset 3 | ||
Unnamed Dataset 4 |
Also In
References
- Stanglmaier , R. , Li , J. , and Matthews , R. The Effect of In-Cylinder Wall Wetting Location on the HC Emissions from SI Engines SAE Technical Paper 1999-01-0502 1999 https://doi.org/10.4271/1999-01-0502
- Schurov , S. , Summers , T. , and Collings , N. Time Resolved Measurement of Cold Start HC Concentration Using the Fast FID SAE Technical Paper 961926 1996 https://doi.org/10.4271/961926
- Nakagawa , S. , Ichihara , T. , Katogi , K. , Kanetoshi , K. et al. Cold Start HC Reduction with Feedback Control Using a Crank Angle Sensor SAE Technical Paper 2008-01-1010 2008 https://doi.org/10.4271/2008-01-1010
- Sato , K. , Tadokoro , T. , Yamakawa , M. , Yokohata , H. et al. Spray and Evaporation Characteristics of Multi-Hole Injector for DISI Engines - Effect of Diverging Angle Between Neighboring Holes SAE Technical Paper 2009-01-1500 2009 https://doi.org/10.4271/2009-01-1500
- Shen , S. , Che , Z. , Wang , T. , Jia , M. et al. Numerical Study on Flash Boiling Spray of Multi-Hole Injector SAE Int. J. Fuels Lubr 10 2 369 379 2017 https://doi.org/10.4271/2017-01-0841
- Itoh , S. , Toda , S. , Ando , A. , Takahashi , Y. et al. Analysis of Fuel Wetting by Using Infrared Absorption SAE Technical Paper 2019-01-2245 2019
- Zhang , W. , Hara , R. , Fujikawa , T. , Yamakawa , M. et al. Vaporization and Turbulence Characteristics of High Pressure Gasoline Sprays Impinging on a Wall SAE Technical Paper 2019-01-2247 2019
- Kashdan , J. Tracer LIF Visualisation Studies of Piston-Top Fuel Films in a Wall-Guided, Low-NOx Diesel Engine SAE Technical Paper 2008-01-2474 2008 https://doi.org/10.4271/2008-01-2474
- Jüngst , N. and Kaiser , S. Imaging of Fuel-Film Evaporation and Combustion in a Direct-Injection Model Experiment SAE Technical Paper 2019-01-0293 2019 https://doi.org/10.4271/2019-01-0293
- Maligne , D. and Bruneaux , G. Time-Resolved Fuel Film Thickness Measurement for Direct Injection SI Engines Using Refractive Index Matching SAE Technical Paper 2011-01-1215 2011 https://doi.org/10.4271/2011-01-1215
- Luo , H. , Uchitomi , S. , Watanabe , T. , Nishida , K. et al. Effects of Nozzle Hole Diameter and Injection Pressure on Fuel Adhesion of Flat-Wall Impinging Spray SAE Technical Paper 2019-01-2246 2019
- Chen , B. , Feng , L. , Wang , Y. et al. Spray and Flame Characteristics of Wall-Impinging Diesel Fuel Spray at Different Wall Temperatures and Ambient Pressures in a Constant Volume Fuel 235 416 425 2019
- Desantes , J.M. , Pastor , J.V. , Pastor , J.M. , and Julia , J.E. Limitations on the Use of the Planar Laser Induced Exciplex Fluorescence Technique in Diesel Sprays Fuel 84 2301 2315 2005
- Ueki , T. , Goto , M. , Kashiwazaki , T. et al. 2017
- Bai , C. and Gosman , A.D. 1995
- Kawamura , K. , Katsumi , N. , and Ueda , R. 2001