This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Virtual Validation of BHL Dipper Using CAE and Correlation with Test Data
Technical Paper
2020-01-0515
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Use of Computer Aided Engineering (CAE) tools for virtual validation has become an essential part of every product development process. Using CAE tools, accurate prediction of potential failure locations is possible even before building the proto. This paper presents a detailed case study of virtual validation of Backhoe Loader (BHL) dipper arm using CAE tools (MBD: Multi Body Dynamics and FEA: Finite Element Analysis) and comparison of simulation results with test data.
In this paper, we have illustrated the modelling of Backhoe Loader in MSc ADAMS software. The detail ADAMS model was created and validated. The component mass, Center of Gravity (C.G) and Mass Moment of Inertia (MOI) was taken from CAD data. Trenching is simulated by operating the different hydraulic cylinders of the BHL. Loader arm cylinders and stabilizer cylinders are operated to lift the machine tires above the ground level. Boom, Dipper, Swing Arm and Bucket cylinders are operated to simulate the trenching operation. Theoretically calculated Bucket Break-out forces are applied on bucket tip during digging phase of trenching cycle. Hydraulic Cylinder pressure are monitored using ADAMS measures.
Loads exported from ADAMS simulation are used for NASTRAN inertia relief stress analysis. Strain gauge locations are identified on the Dipper arm using the stress tensor plots. BHL vehicle is instrumented to measure the strain and hydraulic cylinder pressure data. CAE results were compared with test data and found to be at acceptable level.
Authors
Topic
Citation
Guduru, S., Kudva, P., Kumar, S., and Gopalkrishna, R., "Virtual Validation of BHL Dipper Using CAE and Correlation with Test Data," SAE Technical Paper 2020-01-0515, 2020, https://doi.org/10.4271/2020-01-0515.Also In
References
- Hobbacher , A.F. Recommendations of Fatigue Design of Welded Joints and Components (International Institute of Welding Collection) Second Springer 2016
- BS 7608:1993
- SAE J31
- SAE J1179
- MSC.Software 2007