This content is not included in your SAE MOBILUS subscription, or you are not logged in.
New High-Pressure Hydroform Tool Design Reduces Springback in Ultra-High Strength Steels
ISSN: 0148-7191, e-ISSN: 2688-3627
Published April 02, 2019 by SAE International in United States
This content contains downloadable datasetsAnnotation ability available
Flexform™ is a high-pressure hydroforming technique using a flexible rubber diaphragm between the liquid pressure medium and the sheet metal. No seal is thus needed between the metal sheet and the pressure medium. Only a lower tool half is required, as the diaphragm will act as a flexible upper tool half. Further, the flexible diaphragm allows for several tools to be used in one and the same forming operation. All kinds of sheet metal and thicknesses may be formed using the technique. Perforated sheets, pre-coated sheets or sheets with sensitive surface are in addition to more traditional materials also suitable for Flexform pressing. Likewise, it is known that the Flexform technique works well with such difficult-to-form sheet materials as ultra-high strength steel, titanium and aluminum. Further, the process may also be simulated with good accuracy using FEM. However, as with any other cold forming method, springback is obtained after forming. Even if high-pressure forming often leads to less springback than conventional stamping, material springback is still a factor to take into consideration and needs to be controlled in some way. A tool design and forming technique is shown which introduces a controlled stretch into the blank during forming, which, combined with the pressure exerted by the flexible diaphragm, contributes to significantly reducing the material springback. This paper will also present a technique to both form and to cut the part to final shape in one and the same forming cycle.
|Technical Paper||Application Study of an Automotive Structural Part with Nitrogen-Alloyed High Strength Austenitic Stainless Steel|
|Technical Paper||Interfacial Fracture in Environmentally Friendly Thermoplastic Composite-Metal Laminates|
CitationCarlsson, B., "New High-Pressure Hydroform Tool Design Reduces Springback in Ultra-High Strength Steels," SAE Technical Paper 2019-01-1084, 2019, https://doi.org/10.4271/2019-01-1084.
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
- 2015 www.sika.de