This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Splashing Criterion and Topological Features of a Single Droplet Impinging on the Flat Plate
Technical Paper
2018-01-0289
ISSN: 0148-7191, e-ISSN: 2688-3627
This content contains downloadable datasets
Annotation ability available
Sector:
Language:
English
Abstract
This paper aims to provide the experimental and numerical investigation of a single fuel droplet impingement on the different wall conditions to understand the detailed impinging dynamic process. The experimental work was carried out at the room temperature and pressure except for the variation of the impinged wall temperature. A high-speed camera was employed to capture the silhouette of the droplet impinging on wall process against a collimated light. Water, diesel, n-dodecane, and n-heptane were considered as four different droplets and injected from a precision syringe pump with the volume flow rate of 0.2 mL/min at various impact Weber numbers. The impingement outcomes after droplet impacting on the wall include stick, spread, rebound and splash, which depend on the controlling parameters of Weber number, Reynolds number, liquid and surface properties, etc. In this paper, the various splashing and non-splashing criteria were summarized based on the earlier research and applied to evaluate the current experimental data. It is found that the experimental results at various conditions overall show good agreement in predicting the splashing and non-splashing phenomena with existing droplet-wall interaction models. A new correlation of deposition-splashing in terms of the current experimental data is developed. Further, the effects of the impact Weber number, surface temperature, and surface roughness on the time evolution of droplet spreading factor, height ratio, the dynamic contact angle, and the contact line velocity were studied to aid in the development of a dynamic contact angle model. Finally, the volume of fluid (VOF) method was considered to characterize the single fuel droplet impinging on the wall and provide a better understanding of the dynamic impingement process in the CONVERGE™ framework. The simulation results of the spreading factor, height ratio, and the contact angle match well with the experimental results during the droplet impingement process.
Recommended Content
Authors
Citation
Zhao, L., Ahuja, N., Zhu, X., Zhao, Z. et al., "Splashing Criterion and Topological Features of a Single Droplet Impinging on the Flat Plate," SAE Technical Paper 2018-01-0289, 2018, https://doi.org/10.4271/2018-01-0289.Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 | ||
Unnamed Dataset 2 | ||
Unnamed Dataset 3 | ||
Unnamed Dataset 4 |
Also In
References
- Zhao , L. , Moiz , A.A. , Lee , S.-Y. , Naber , J. et al. Investigation of Multi-Hole Impinging Jet High Pressure Spray Characteristics Under Gasoline Engine-Like Conditions SAE Technical Paper 2016-01-0847 2016 2016 10.4271/2016-01-0847
- Zhao , L. , Torelli , R. , Zhu , X. , Scarcelli , R. et al. An Experimental and Numerical Study of Diesel Spray Impingement on a Flat Plate SAE Int. J. Fuels Lubr. 10 2 407 422 2017 10.4271/2017-01-0854
- Stanton , D.W. and Rutland , C.J. Modeling Fuel Film Formation and Wall Interaction in Diesel Engines SAE Technical Paper 960628 1996 1996 10.4271/960628
- Drake , M.C. , Fansler , T.D. , Solomon , A.S. , and Szekely , G.A. Piston Fuel Films as a Source of Smoke and Hydrocarbon Emissions from a Wall-Controlled Spark-Ignited Direct-Injection Engine SAE Technical Paper 2003-01-0547 2003 2003 10.4271/2003-01-0547
- Lindagren , R. and Denbratt , I. Influence of Wall Properties on the Characteristics of a Gasoline Spray After Wall Impingement SAE Technical Paper 2004-01-1951 2004 2004 10.4271/2004-01-1951
- Behnia , M. and Milton , B.E. Fundamentals of Fuel Film Formation and Motion in Si Engine Induction Systems Energy Conversion and Management 42 15-17 1751 1768 2001 10.1016/S0196-8904(01)00041-3
- Potham , S. , Zhao , L. , and Lee , S. Numerical Study on Evaporation of Spherical Droplets Impinging on the Wall Using Volume of Fluid (Vof) Model SAE Technical Paper 2017-01-0852 2017 10.4271/2017-01-0852
- Stow , C.D. and H , M.G. An Experimental Investigation of Fluid Flow Resulting from the Impact of a Water Drop with an Unyielding Dry Surface Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences 373 1755 419 1981
- Yarin , A.L. and Weiss , D.A. Impact of Drops on Solid Surfaces: Self-Similar Capillary Waves, and Splashing as a New Type of Kinematic Discontinuity Journal of Fluid Mechanics 283 141 173 1995 10.1017/S0022112095002266
- Mundo , C. , Sommerfeld , M. , and Tropea , C. Droplet-Wall Collisions: Experimental Studies of the Deformation and Breakup Process International Journal of Multiphase Flow 21 2 151 173 1995 10.1016/0301-9322(94)00069-V
- Rioboo , R. , Tropea , C. , and Marengo , M. Outcomes from a Drop Impact on Solid Surfaces 11 2 12 2001 10.1615/AtomizSpr.v11.i2.40
- O'Rourke , P.J. and Amsden , A.A. A Particle Numerical A Particle Numerical Model for Wall Film Dynamics in Port-Injected Engines SAE Technical Paper 961961 1996 10.4271/961961
- Naber , J.D. and Reitz , R.D. Modeling Engine Spray/Wall Impingement SAE Technical Paper 880107 1988 10.4271/880107
- Han , Z. , Xu , Z. , and Trigui , N. Spray/Wall Interaction Models for Multidimensional Engine Simulation International Journal of Engine Research 1 1 127 146 2000 10.1243/1468087001545308
- Bai , C.X. , Rusche , H. , and Gosman , A.D. Modeling of Gasoline Spray Impingement Atomization and Sprays 12 1-3 1 28 2002 10.1615/AtomizSpr.v12.i123.10
- O'Rourke , P.J. and Amsden , A.A. A Spray/Wall Interaction Submodel for the Kiva-3 Wall Film Model SAE Technical Paper 2000-01-0271 2000 10.4271/2000-01-0271
- Han , Z. and Xu , Z. Wall Film Dynamics Modeling for Impinging Sprays in Engines SAE Technical Paper 2004-01-0099 2004 2004 10.4271/2004-01-0099
- Ma , T. , Feng , L. , Wang , H. , Liu , H. et al. A Numerical Study of Spray/Wall Impingement Based on Droplet Impact Phenomenon International Journal of Heat and Mass Transfer 112 401 412 2017 10.1016/j.ijheatmasstransfer.2017.04.110
- Palacios , J. , Hernández , J. , Gómez , P. , Zanzi , C. et al. Experimental Study of Splashing Patterns and the Splashing/Deposition Threshold in Drop Impacts onto Dry Smooth Solid Surfaces Experimental Thermal and Fluid Science 44 571 582 2013 10.1016/j.expthermflusci.2012.08.020
- Wal , R.L.V. , Berger , G.M. , and Mozes , S.D. The Splash/Non-Splash Boundary Upon a Dry Surface and Thin Fluid Film Experiments in Fluids 40 1 53 59 2006 10.1007/s00348-005-0045-1
- James , C.B. , Scott , S.H.T. , and Howard , A.S. Inclined to Splash: Triggering and Inhibiting a Splash with Tangential Velocity New Journal of Physics 11 6 063017 2009
- Pan , K.-L. , Tseng , K.-C. , and Wang , C.-H. Breakup of a Droplet at High Velocity Impacting a Solid Surface Experiments in Fluids 48 1 143 156 2010 10.1007/s00348-009-0697-3
- Hu , J. , Xiong , X. , Xiao , H. , and Wan , K.-t. Effects of Contact Angle on the Dynamics of Water Droplet Impingement 2015
- Vadillo , D.C. , Soucemarianadin , A. , Delattre , C. , and Roux , D.C.D. Dynamic Contact Angle Effects onto the Maximum Drop Impact Spreading on Solid Surfaces Physics of Fluids 21 12 122002 2009 10.1063/1.3276259
- Šikalo , Š. , Wilhelm , H.-D. , Roisman , I.V. , Jakirlić , S. et al. Dynamic Contact Angle of Spreading Droplets: Experiments and Simulations Physics of Fluids 17 6 062103 2005 10.1063/1.1928828
- Schrader , M.E. Young-Dupre Revisited Langmuir 11 9 3585 3589 1995 10.1021/la00009a049
- Malgarinos , I. , Nikolopoulos , N. , Marengo , M. , Antonini , C. et al. Vof Simulations of the Contact Angle Dynamics During the Drop Spreading: Standard Models and a New Wetting Force Model Advances in Colloid and Interface Science 212 1 20 2014
- Roisman , I.V. , Opfer , L. , Tropea , C. , Raessi , M. et al. Drop Impact onto a Dry Surface: Role of the Dynamic Contact Angle Colloids and Surfaces A: Physicochemical and Engineering Aspects 322 1-3 183 191 2008 10.1016/j.colsurfa.2008.03.005
- Schiaffino , S. and Sonin , A.A. Molten Droplet Deposition and Solidification at Low Weber Numbers Physics of Fluids 9 11 3172 3187 1997 10.1063/1.869434
- Yang , B. and Ghandhi , J. Measurement of Diesel Spray Impingement and Fuel Film Characteristics Using Refractive Index Matching Method SAE Technical Paper 2007-01-0485 2007 10.4271/2007-01-0485
- Otsu , N. A Threshold Selection Method from Gray-Level Histograms IEEE Transactions on Systems, Man, and Cybernetics 9 1 62 66 1979
- Richards , K.J. , Senecal , P.K. , and Pomraning , E. Converge Manual (Version 2.3) Madison, WI Convergent Science Inc. 2016
- Stanton , D.W. and Rutland , C.J. Multi-Dimensional Modeling of Thin Liquid Films and Spray-Wall Interactions Resulting from Impinging Sprays International Journal of Heat and Mass Transfer 41 20 3037 3054 1998 10.1016/S0017-9310(98)00054-4
- Geppert , A. , Chatzianagnostou , D. , Meister , C. , Gomaa , H. et al. Classification of Impact Morphology and Splashing/Deposition Limit for N-Hexadecane 26 10 983 1007 2016 10.1615/AtomizSpr.2015013352
- Cossali , G.E. , Coghe , A. , and Marengo , M. The Impact of a Single Drop on a Wetted Solid Surface Experiments in Fluids 22 6 463 472 1997 10.1007/s003480050073
- Bernard , R. , Foltyn , P. , Geppert , A. , Lamanna , G. et al. Generalized Analysis of the Deposition/Splashing Limit for One- and Two-Component Droplet Impacts Upon Thin Films 2017 10.4995/ILASS2017.2017.4810
- Maitra , T. , Tiwari , M.K. , Antonini , C. , Schoch , P. et al. On the Nanoengineering of Superhydrophobic and Impalement Resistant Surface Textures Below the Freezing Temperature Nano Letters 14 1 172 182 2014 10.1021/nl4037092