This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Model Based Approach by Combination of Test and Simulation Methodologies for NVH Investigation and Improvement of a Rear Wheel Drive Vehicle

Journal Article
2017-01-1774
ISSN: 2380-2162, e-ISSN: 2380-2170
Published June 05, 2017 by SAE International in United States
Model Based Approach by Combination of Test and Simulation Methodologies for NVH Investigation and Improvement of a Rear Wheel Drive Vehicle
Sector:
Citation: Marques dos Santos, F., Enault, T., Deleener, J., and Van Houcke, T., "Model Based Approach by Combination of Test and Simulation Methodologies for NVH Investigation and Improvement of a Rear Wheel Drive Vehicle," SAE Int. J. Veh. Dyn., Stab., and NVH 1(2):407-416, 2017, https://doi.org/10.4271/2017-01-1774.
Language: English

References

  1. Mauch Dipl-Ing Andreas , Tophoven Dipl-Ing Jens , Trzebiatowski Dipl-Ing Tobias , and Raatz Ing Thorsten Potentials and limits of downsizing a diesel engine MTZ worldwide eMagazine 72 7-8 4 9 2011
  2. Wellmann , T. , Govindswamy , K. , and Tomazic , D. Integration of Engine Start/Stop Systems with Emphasis on NVH and Launch Behavior SAE Int. J. Engines 6 2 1368 1378 2013 10.4271/2013-01-1899
  3. Stoffels , H. and Schroeer , M. NVH Aspects of a Downsized Turbocharged Gasoline Powertrain with Direct Injection SAE Technical Paper 2003-01-1664 2003 10.4271/2003-01-1664
  4. Leone , T. and Pozar , M. Fuel Economy Benefit of Cylinder Deactivation - Sensitivity to Vehicle Application and Operating Constraints SAE Technical Paper 2001-01-3591 2001 10.4271/2001-01-3591
  5. Abe , H. , Tsuruoka , M. , Muto , A. , Kato , M. et al. Development of Super Ultra Flat Torque Converter with Multi Plate Lock-up Clutch SAE Int. J. Engines 2 1 48 55 2009 10.4271/2009-01-0141
  6. Hage , A. , Szatkowski , A. , and Li , Z. Improving Low Frequency Torsional Vibrations NVH Performance through Analysis and Test SAE Technical Paper 2007-01-2242 2007 10.4271/2007-01-2242
  7. Wellmann , T. , Govindswamy , K. , Braun , E. , and Wolff , K. Aspects of Driveline Integration for Optimized Vehicle NVH Characteristics SAE Technical Paper 2007-01-2246 2007 10.4271/2007-01-2246
  8. Auweraer Herman Van der , Anthonis Jan , Bruyne Stijn De , and Leuridan Jan Virtual engineering at work: the challenges for designing mechatronic products Engineering with Computers 29 3 389 408 2013
  9. Cai Wei , Pillay Pragasen , Tang Zhangjun , and Omekanda Avoki M Low-vibration design of switched reluctance motors for automotive applications using modal analysis Industry Applications, IEEE Transactions on 39 4 971 977 2003
  10. Ozdoganlar O Burak , Hansche Bruce D , and Carne Thomas G Experimental modal analysis for microelectromechanical systems Experimental Mechanics 45 6 498 506 2005
  11. Samin Jean-Claude , Brüls O , Collard Jean-François , Sass Laurent , and Fisette Paul Multiphysics modeling and optimization of mechatronic multibody systems Multibody System Dynamics 18 3 345 373 2007
  12. Naets Frank , Cuadrado Javier , and Desmet Wim Stable force identification in structural dynamics using kalman filtering and dummy-measurements Mechanical Systems and Signal Processing 50 235 248 2015
  13. Hwang Jae-Seung , Kareem Ahsan , and Kim Wha-jung Estimation of modal loads using structural response Journal of Sound and Vibration 326 3 522 539 2009
  14. Haddow Alan G and Shaw Steven W Centrifugal pendulum vibration absorbers: an experimental and theoretical investigation Nonlinear Dynamics 34 3-4 293 307 2003
  15. Wedin Anders Reduction of vibrations in engines using centrifugal pendulum vibration absorbers Master’s thesis Chalmers University of Technology 2011

Cited By