This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of Fuel Cell System Control for Sub-Zero Ambient Conditions
Technical Paper
2017-01-1189
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Toyota Motor Corporation (TMC) has been developing fuel cell vehicles (FCVs) since 1992. As part of a demonstration program, TMC launched the FCHV-adv in 2008, which established major technical improvements in key performance areas such as efficiency, driving range, durability, and operation in sub-zero conditions. However, to encourage commercialization and widespread adoption of FCVs, further improvements in performance were required. During sub-zero operating conditions, the FC system output power was lower than under normal operating conditions. The FC stack in the FCHV-adv needed to dry the electrolyte membrane to remove unneeded water from the stack. This increased the stack resistance and caused low output power. In December 2014, TMC launched the world’s first commercially available FCV named the Mirai, which greatly improved output power even after start-up in sub-zero conditions. To enable start-up in sub-zero temperatures under high water content conditions, oxygen diffusion through the cell was enhanced and a 3D fine mesh cathode flow channel was developed to improve the drainage control. In addition, control countermeasures were incorporated, including a water content measurement technique and water purge control during parking (parking purge). The water content measurement technique uses low-frequency impedance, which accurately measures high water content levels. The parking purge was developed to purge liquid water that migrates from the cathode to the anode while the vehicle is parked. Without the purge, the water may clog the anode channel. As a result, the FC stack in the Mirai improved output power after start-up at sub-zero conditions.
Recommended Content
| Technical Paper | Synchrotron X-Ray Visualization and Simulation for Operating Fuel Cell Diffusion Layers |
| Journal Article | Study of Oxide Supports for PEFC Catalyst |
Authors
Topic
Citation
Maruo, T., Toida, M., Ogawa, T., Ishikawa, Y. et al., "Development of Fuel Cell System Control for Sub-Zero Ambient Conditions," SAE Technical Paper 2017-01-1189, 2017, https://doi.org/10.4271/2017-01-1189.Also In
References
- Hasegawa , T. , Watanabe , N. , Naganuma , Y. , Nada , M. , Umayahara , K. , Nonobe , Y. Development of the Fuel Cell System in the Mirai FCV Toyota Technical Review 61 15 20 2015
- Toida , M. , Ogawa , T. Naganuma , Y. , Nonobe , Y. Development of Control System for Freeze Start-Up at New FCV presented at the JSAE Annual Congress (spring) Japan 2015
- Patterson , T. , Darling , R. Damage to the Cathode Catalyst of a PEM Fuel Cell Caused by Localized Fuel Starvation Electrochemical and Solid-State Letters 9 4 A183 A185 2006 10.1149/1.2167930
- Kitamura , N. , Manabe , K. , Nonobe , Y. , and Kizaki , M. Development of Water Content Control System for Fuel Cell Hybrid Vehicles Based on AC Impedance SAE Technical Paper 2010-01-1088 2010 10.4271/2010-01-1088
- Konno , N. , Mizuno , S. , Nakaji , H. , and Ishikawa , Y. Development of Compact and High-Performance Fuel Cell Stack SAE Int. J. Alt. Power. 4 1 123 129 2015 10.4271/2015-01-1175
- Yuji , I. Fuel Cell Monitor Japanese Patent, No 2014-203562 October 27 2014
- Yuji , I. Fuel Cell Monitor Japanese Patent, No 2015-99727 May 28 2015
- Yoshiaki , N. The drainage method of the fuel cell and fuel cell system Japanese Patent, No 2016-96058 May 26 2016
- Toida , M. Fuel Cell System and Purge Method of Fuel Cell System Japanese Patent, No 2016-96018 May 26 2016