This content is not included in your SAE MOBILUS subscription, or you are not logged in.

The Effect of Near-Zero Aromatic Fuels on Internal Diesel Injector Deposit Test Methods

Journal Article
2017-01-0807
ISSN: 1946-3952, e-ISSN: 1946-3960
Published March 28, 2017 by SAE International in United States
The Effect of Near-Zero Aromatic Fuels on Internal Diesel Injector Deposit Test Methods
Sector:
Citation: de Goede, S., Barbour, R., Velaers, A., Sword, B. et al., "The Effect of Near-Zero Aromatic Fuels on Internal Diesel Injector Deposit Test Methods," SAE Int. J. Fuels Lubr. 10(1):163-183, 2017, https://doi.org/10.4271/2017-01-0807.
Language: English

Abstract:

Internal diesel injector deposits (IDID) are now a well understood phenomenon and a standard test procedure has been developed and partially approved by the Coordinating European Council (CEC). The engine test procedure has been approved for simulation of sodium soap deposits by dosing the test fuel with a sodium salt and dodecenyl succinic acid (DDSA), whilst amide lacquer deposits simulation by dosing the test fuel with a low molecular weight (MWt) polyisobutylene succinimide (PIBSI) is still under development. The solubility of these contaminants in the base fuel should be reasonably constant to achieve consistent results. With the introduction of diesel from varying sources, this study focused on the effect of near-zero aromatics EN 15940 compliant gas-to-liquids GTL diesel, very similar to hydrotreated vegetable oil (HVO), on IDID severity across two different engine platforms, and the response of a modern deposit control additive.
The test results showed that, with the same level of contaminants, IDID severity did differ significantly when comparing GTL diesel to a petroleum diesel reference fuel. The IDID effects also differed across engine platforms. In a previous study, it was found that the effect of zinc solvency in the base fuel had a dramatic effect on the CEC F-98-08 DW10 injector nozzle fouling test results. For the IDID test procedure used in this study, the effect of base fuel solvency was less pronounced on IDID formation. It was also found that some degree of nozzle fouling does take place with typical IDID contaminants. The deposit control additive tested proved to be effective in preventing both IDID formation and nozzle fouling for GTL diesel and petroleum diesel.
In conclusion, it was highlighted again that base fuel solvency can influence the results of a test procedure where contaminants are dosed into the fuel, and these effects need to be considered where such fuels are tested.