This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Simultaneous Improvement of Vehicle Under-Hood Airflow and Cooling Drag Using 3D CFD Simulation
Technical Paper
2016-01-0200
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The radiator is the key component of a vehicle’s cooling system. The cooling effectiveness of a radiator largely depends on the flow of fresh air through it. Thus, at high vehicle speeds, the mass flow rate and flow-distribution or flow-uniformity over the radiator surface are the major operating parameters influencing the performance of a radiator. Additionally, the mass of air coming from the front grille plays an important role on the total drag of the vehicle. This paper presents computational studies aiming at improving simultaneously the efficiency of a radiator and reducing the total drag of the vehicle; this is achieved using passive aerodynamic devices that alter the flow pattern approaching the radiator. The vehicle model considered is a Hyundai Veloster and all analyses were carried out using a commercial CFD code Star-CCM+ version 10.04 by CD-adapco. The baseline model used in this study has a vertical radiator with no air-duct where most of the incoming air from the grille blows over the bottom part of the radiator, which makes the upper part of the radiator ineffective. An air-duct introduced between the front grille and the radiator helps the airflow uniformity over the radiator surface by directing the flow towards the upper part of the radiator. This also resulted in an increased mass flow through the radiator due to faster flow induced by the air-duct. Since only the airflow going through the air-duct is useful for cooling the radiator, one could seal both sides of the front grille to remove excessive airflow going under the hood which reduces the cooling and total drag of the vehicle. Several design iterations involving a variety of air-duct geometries and front grille openings were investigated. The results were compared in terms of airflow uniformity, total mass flow rate through the radiator and total vehicle drag to determine the combination that gives the best performance.
Recommended Content
Authors
Topic
Citation
Zhang, C., Uddin, M., Song, X., Fu, C. et al., "Simultaneous Improvement of Vehicle Under-Hood Airflow and Cooling Drag Using 3D CFD Simulation," SAE Technical Paper 2016-01-0200, 2016, https://doi.org/10.4271/2016-01-0200.Also In
References
- Littlewood , R. Novel methods of drag reduction for squareback road vehicles Ph. D. Thesis Loughborough University 2013
- Sawyer , S.R. Experimental Investigation of Drag Reduction by Trailing Edge Tabs on a Square Based Bluff Body in Ground Effect Master Thesis Aerospace Engineering, California Polytechnic State University San Luis Obispo 2015
- Altaf , A. , Omar , A.A. , and Asrar , W. REVIEW OF PASSIVE DRAG REDUCTION TECHNIQUES FOR BLUFF ROAD VEHICLES IIUM Engineering Journal 15 1 2014
- Patten , J. , McAuliffe , B. , Mayda , W. , and Tanguay , B. Review of aerodynamic drag reduction devices for heavy trucks and buses National Research Council Canada NRC Technical Report CSTT-HVC-TR-205 2012
- D’Hondt , M. , Gilliéron , P. , and Devinant , P. Aerodynamic drag and flow rate through engine compartments of motor vehicles 28th AIAA Applied Aerodynamics Conference 2010-4955 2010 10.2514/6.2010-4955
- Song , X. , Fortier , R. , and Sarnia , S. Underhood Air Duct Design to Improve A/C System Performance by Minimizing Hot Air Recirculation SAE Int. J. Passeng. Cars - Mech. Syst. 8 1 338 345 2015 10.4271/2015-01-1689
- Alajbegovic , A. , Xu , B. , Konstantinov , A. , Amodeo , J. et al. Simulation of Cooling Airflow under Different Driving Conditions SAE Technical Paper 2007-01-0766 2007 10.4271/2007-01-0766
- Kubokura , T. , Uno , T. , Evans , N. , Kuroda , H. et al. Study of Cooling Drag Reduction Method by Controlling Cooling Flow SAE Technical Paper 2014-01-0679 2014 10.4271/2014-01-0679
- Mathur , G. Performance Enhancement of Mobile Air Conditioning System With Improved Air Management for Front End SAE Technical Paper 2005-01-1512 2005 10.4271/2005-01-1512
- Saab , S. , Hetet , J. , Maiboom , A. , and Charbonnelle , F. Impact of the Underhood Opening Area on the Drag Coefficient and the Thermal Performance of a Vehicle SAE Technical Paper 2013-01-0869 2013 10.4271/2013-01-0869
- Chometon , F. and Gilliéron , P. Assessment of Engine Cooling Performance by Measurement of Cooling Airflow Drag in Aerodynamic Wind Tunnels SAE Technical Paper 980428 1998 10.4271/980428
- Barnard , R. Theoretical and experimental investigation of the aerodynamic drag due to automotive cooling systems Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering 214 8 919 927 2000 10.1177/095440700021400810
- Williams , J. , Karanth , D. , and Oler , W. Cooling Inlet Aerodynamic Performance and System Resistance SAE Technical Paper 2002-01-0256 2002 10.4271/2002-01-0256
- Gilliéron , P. and Chometon , F. Reduction of Cooling Air Drag of Road Vehicles: An Analytical Approach SAE Technical Paper 2001-01-1266 2001 10.4271/2001-01-1266
- Ivanić , T. and Gilliéron , P. Reduction of the Aerodynamic Drag Due to Cooling Systems: An Analytical and Experimental Approach SAE Technical Paper 2005-01-1017 2005 10.4271/2005-01-1017
- Tesch , G. , Demuth , R. , and Adams , N. A New Approach to Analyzing Cooling and Interference Drag SAE Int. J. Passeng. Cars - Mech. Syst. 3 1 339 351 2010 10.4271/2010-01-0286
- Williams , J. Aerodynamic Drag of Engine-Cooling Airflow With External Interference SAE Technical Paper 2003-01-0996 2003 10.4271/2003-01-0996
- Wickern , G. , Wagner , A. , and Zoerner , C. Cooling Drag of Ground Vehicles and Its Interaction with Ground Simulation SAE Technical Paper 2006-01-0339 2006 10.4271/2006-01-0339
- Christoffersen , L. , Löfdahl , L. , and Jönson , A. Interference between Engine Bay Flow and External Aerodynamics of Road Vehicles SAE Technical Paper 2010-01-0288 2010 10.4271/2010-01-0288
- Baeder , D. , Indinger , T. , Adams , N. , and Unterlechner , P. Aerodynamic Investigation of Vehicle Cooling-Drag SAE Technical Paper 2012-01-0170 2012 10.4271/2012-01-0170
- Kuthada , T. and Wiedemann , J. Investigations in a Cooling Air Flow System under the Influence of Road Simulation SAE Technical Paper 2008-01-0796 2008 10.4271/2008-01-0796
- Wittmeier , F. and Kuthada , T. Open Grille DrivAer Model - First Results SAE Int. J. Passeng. Cars - Mech. Syst. 8 1 252 260 2015 10.4271/2015-01-1553
- Manna , S. and Kushwah , Y. Optimization of a Vehicle Under Hood Airflow Using 3D CFD Analysis SAE Technical Paper 2015-01-0349 2015 10.4271/2015-01-0349
- Jahani , K. and Beigmoradi , S. Under-Hood Air Flow Evaluation of Pedestrian-Friendly Front-End Style Using CFD Simulation SAE Int. J. Passeng. Cars - Mech. Syst. 7 2 787 792 2014 10.4271/2014-01-0762
- Regin , F. A Numerical Analysis on Air-cooling Performance of Passenger Cars SAE Technical Paper 2010-01-0554 2010 10.4271/2010-01-0554