This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Development of Piston and Piston Ring Lubrication Analysis
ISSN: 0148-7191, e-ISSN: 2688-3627
Published September 01, 2015 by SAE International in United States
Annotation ability available
The reduction of CO2 emissions has become an imperative duty in order to cope with environmental compliance. For car manufacturers, CO2 emission has been set by regulation and many consumers prefer a fuel efficient car because of the increasing fuel price. In such a situation, reducing engine friction is an effective way of improving fuel efficiency. Among engine parts, the piston counts for a large percentage of the friction losses. In this study, we established a calculation model for estimating piston and piston ring friction. This paper shows how the accuracy of the calculation model was improved by validating against measurements.
|Journal Article||Compact Engine Architecture for Best Fuel Efficiency and High Performance - Challenge or Contradiction|
|Technical Paper||Improving Heavy-Duty Engine Efficiency and Durability: The Rotating Liner Engine|
CitationKimura, Y., Murakami, M., Bouassida, H., Tanguy, Y. et al., "Development of Piston and Piston Ring Lubrication Analysis," SAE Technical Paper 2015-01-2039, 2015, https://doi.org/10.4271/2015-01-2039.
- Ito , Y. et al. Analysis of Piston Friction on Firing Conditions by 3-component Force Sensor Method Transactions of the Society of Automotive Engineers of Japan 37 163 169 1988
- Excite Power Unit User Manual
- Modelling the performance of piston ring pack in internal combustion engines Tian T. 1997 Massachusetts Institute of Technology PhD thesis
- Modelling the lubrication, dynamics, and effects of piston dynamic tilt of twin land oil control rings in internal combustion engines Tian T. and Wong V. ASME Journal of Engineering for Gas Turbines and Power 2000 122 119 129
- Application of average flow model to lubrication between rough sliding surfaces Patir N. and Cheng H.S. ASME Journal of Lubrication Technology 1979 101 220 230
- The Contact of nominally flat surfaces Greenwood J.A. and Williamson J.P.B. 1966 Proceedings of the Royal Society, London A 295 300
- The Contact of two nominally flat rough surfaces Greenwood J.A. and Tripp J. 1970 Proceedings of the Institution of Mechanical Engineers 1970 185 625 633
- Analysis of Lubrication of a Piston Ring Package (Effect of Oil Starvation on Oil Film Thickness) SANDA Shuzou , MURAKAMI Motoichi , NODA Takashi and KONOMI Toshiaki JSAE International Journal, Series B 40 3 1997
- Determination of fundamental parameters for the cross-hatched cylinder liner micro-geometry Biboulet N. , Bouassida H. , Cavoret J. and Lubrecht A.A. Proceeding of the Institution of Mechanical Engineers Part J - Journal of Engineering Tribology 10.1177/1350650114548202 2014
- Piston ring load carrying capacity: influence of cross-hatching parameters Bouassida H. , Biboulet N. , Sainsot P. and Lubrecht A.A. Proceeding of the Institution of Mechanical Engineers Part J - Journal of Engineering Tribology 10.1177/1350650114522779 228 642 648 2014
- Cross hatched texture influence on the load carrying capacity of oil control rings Biboulet N. , Bouassida H. and Lubrecht A.A. Tribology International 10.1016/j.triboint.2014.09.024 82 12 19 2015