This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Application of Road Load Prediction Technique for Suspension Durability Input Condition
Technical Paper
2014-01-0863
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The aim discussed in this paper is to show a technique to predict loads input to the wheels, essential to determining input conditions for evaluation of suspension durability, by means of full vehicle simulations using multi body analysis software Adams/Car.
In this process, model environments were built to enable reproduction of driving modes, and a method of reproducing the set-up conditions of a durability test vehicle was developed.
As the result of verification of the accuracy of the simulations in the target driving modes, good correlation for waveforms can be confirmed. And also confirm a good correlation in relation to changes of input load due to changes in suspension specifications.
Recommended Content
Technical Paper | Evaluation of Cold Start Technologies on a 3L Diesel Engine |
Technical Paper | Comparison of Vehicle Durability Testing Methods |
Technical Paper | Development and Use of Laboratory Flat Surface Roadway Technology |
Authors
Topic
Citation
Shimodaira, T., "Application of Road Load Prediction Technique for Suspension Durability Input Condition," SAE Technical Paper 2014-01-0863, 2014, https://doi.org/10.4271/2014-01-0863.Also In
References
- Haga , H. Evaluation of Road Load Prediction by Multi-body Simulation Including Flex-Body-Load Prediction for Durability Using a Tire Model- 2006 JSAE Annual Congress Proceedings, No. 21-06 9 12
- Haga , H. Evaluation of Road Load Prediction by Multi-body Simulation Including Flex-Body (Second Report) - Load Prediction for Durability Using a Tire Model -, 2006 JSAE Annual Congress Proceedings, No.136-06 11 14
- Haga , H. Evaluation of Road Load Simulation on Rough Road Using Full Vehicle Model (The Second Report)-Load Prediction for Durability Using a Tire Model- 2008 JSAE Annual Congress Proceedings, No. 123-08 23 26
- Nimiya , Y. , Sawa , N. , Honma , K. , lysubo , T. Rough Road Load Prediction Method coupled with Suspension Control System 2009 SAE Annual Congress Proceedings, No. 116-09 9 14 2009
- Katsuno , M. , Sano , M. , Tachikawa , K. Development of a Prediction Method of Curb Impact Load 1994 JSAE Annual Congress Proceedings, No.944 145 148
- Sakai , E. , Tominaga , H. , Kato , Y. , Yamamoto N. , Matsuki , H. Development of Technique for Estimating Suspension Input Force During Endurance Run on Rough Road Mitsubishi Motors Technical Review 17 45 48 2005
- Hauke , M. Simulation of Full Vehicle Misuse Behavior SAE Technical Paper 2004-01-0192 2004 10.4271/2004-01-0192
- http://www.mscsoftware.com/events/vpd2006/na/presentations/53.pdf
- http://www.cosin.eu/literature