This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Experimental Study of a Pre-Chamber Jet Igniter in a Turbocharged Rotax 914 Aircraft Engine
Technical Paper
2013-01-1629
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
An experimental study is performed to investigate the possibility of relaxing the octane requirement of a Rotax 914 engine equipped with a pre-chamber jet ignition system. A pre-chamber jet igniter with no auxiliary fuel addition is designed to replace the spark plug in cylinder two of the test engine and is evaluated across engine speeds ranging from 2500 to 5500 RPM. Experiments are performed across both normally aspirated and boosted configurations using regular 87 AKI gasoline fuel. Normally aspirated results at 98 kPa manifold absolute pressure show a 7-10° burn rate improvement with the jet ignition combustion system. Tests to determine the maximum load at optimal combustion phasing (no spark retard) are then conducted by increasing boost pressure up to maximum knock limits. Boosted jet ignition results demonstrate that 17 bar IMEPn can be achieved using 87 AKI gasoline fuel, which is the highest documented load achieved with this combustion system at stoichiometric conditions without dilution. A ~ 3 bar IMEPn increase over spark ignition combustion is also observed in the same test engine, corresponding to a ~25 kPa boost pressure increase across the speed range. When comparing the 87 AKI jet ignition results to those of the baseline spark ignition OEM engine which requires 100 low lead (≻ 99.5 MON) aviation gasoline, experimental results highlight that peak torque at 4500 RPM can be matched, however peak power is slightly reduced by 9% at 5500 RPM. Hence, it is estimated that this particular jet igniter offers a ≻ 10 octane number improvement over the baseline spark ignition system. This demonstrates that retrofitted pre-chamber jet igniter technology offers the general aviation industry a potential means of relaxing engine octane requirement. Experimental burn rate results and visual evidence of the jet impingement on the piston crown confirm that further pre-chamber nozzle and jet optimization are required to achieve the full knock limit benefits of this combustion system as demonstrated in the literature. However, results thus far are very encouraging for future lead-free gasoline aviation engines as well as boosted automotive powertrains as engine downsizing grows in popularity.
Recommended Content
Authors
Topic
Citation
Anderson, E., Attard, W., Brown, A., Litke, P. et al., "Experimental Study of a Pre-Chamber Jet Igniter in a Turbocharged Rotax 914 Aircraft Engine," SAE Technical Paper 2013-01-1629, 2013, https://doi.org/10.4271/2013-01-1629.Also In
References
- Unmanned Systems Integrated Roadmap FY2011-2036 Department of Defense 2011
- Attard , W. , Blaxill , H. , Anderson , E. , and Litke , P. Knock Limit Extension with a Gasoline Fueled Pre-Chamber Jet Igniter in a Modern Vehicle Powertrain SAE Int. J. Engines 5 3 1201 1215 2012 10.4271/2012-01-1143
- Ricardo , H. Recent Research Work on the Internal-Combustion Engine SAE Technical Paper 220001 1922 10.4271/220001
- Turkish , M. 3 - Valve Stratified Charge Engines: Evolvement, Analysis and Progression SAE Technical Paper 741163 1974 10.4271/741163
- Toulson , E. , Schock , H. , and Attard , W. A Review of Pre-Chamber Initiated Jet Ignition Combustion Systems SAE Technical Paper 2010-01-2263 2010 10.4271/2010-01-2263
- Anderson , R. and Asik , J. Lean Air-Fuel Ignition System Comparison in a Fast-Burn Engine SAE Technical Paper 850076 1985 10.4271/850076
- Edwards , C. , Oppenheim , A. , and Dale , J. A Comparative Study of Plasma lgnition Systems SAE Technical Paper 830479 1983 10.4271/830479
- Noguchi , M. , Sanda , S. , and Nakamura , N. Development of Toyota Lean Burn Engine SAE Technical Paper 760757 1976 10.4271/760757
- Brandstetter , W. , Decker , G. , and Reichel , K. The Water-Cooled Volkswagen PCI-Stratified Charge Engine SAE Technical Paper 750869 1975 10.4271/750869
- Date , T. , Yagi , S. , Ishizuya , A. , and Fujii , I. Research and Development of the Honda CVCC Engine SAE Technical Paper 740605 1974 10.4271/740605
- Attard , W. , Bassett , M. , Parsons , P. , and Blaxill , H. A New Combustion System Achieving High Drive Cycle Fuel Economy Improvements in a Modern Vehicle Powertrain SAE Technical Paper 2011-01-0664 2011 10.4271/2011-01-0664
- Attard , W. and Blaxill , H. A Single Fuel Pre-Chamber Jet Ignition Powertrain Achieving High Load, High Efficiency and Near Zero NOx Emissions SAE Int. J. Engines 5 3 734 746 2012 10.4271/2011-01-2023
- Attard , W. and Blaxill , H. A Lean Burn Gasoline Fueled Pre-Chamber Jet Ignition Combustion System Achieving High Efficiency and Low NOx at Part Load SAE Technical Paper 2012-01-1146 2012 10.4271/2012-01-1146
- Attard , W. and Blaxill , H. A Gasoline Fueled Pre-Chamber Jet Ignition Combustion System at Unthrottled Conditions SAE Int. J. Engines 5 2 315 329 2012 10.4271/2012-01-0386
- Attard , W. , Kohn , J. , and Parsons , P. Ignition Energy Development for a Spark Initiated Combustion System Capable of High Load, High Efficiency and Near Zero NOx Emissions SAE Int. J. Engines 3 2 481 496 2010 10.4271/2010-32-0088
- Attard , W. and Parsons , P. A Normally Aspirated Spark Initiated Combustion System Capable of High Load, High Efficiency and Near Zero NOx Emissions in a Modern Vehicle Powertrain SAE Int. J. Engines 3 2 269 287 2010 10.4271/2010-01-2196
- Attard , W. and Parsons , P. Flame Kernel Development for a Spark Initiated Pre-Chamber Combustion System Capable of High Load, High Efficiency and Near Zero NOx Emissions SAE Int. J. Engines 3 2 408 427 2010 10.4271/2010-01-2260
- Attard , W. , Fraser , N. , Parsons , P. , and Toulson , E. A Turbulent Jet Ignition Pre-Chamber Combustion System for Large Fuel Economy Improvements in a Modern Vehicle Powertrain SAE Int. J. Engines 3 2 20 37 2010 10.4271/2010-01-1457
- Attard , W. , Toulson , E. , Huisjen , A. , Chen , X. et al. Spark Ignition and Pre-Chamber Turbulent Jet Ignition Combustion Visualization SAE Technical Paper 2012-01-0823 2012 10.4271/2012-01-0823
- Watson , H.C. and Gledhill , M.P. Comparison of Knock in a Jet Assisted Ignition and Normal SI Engine APAC15-225 2008
- Gledhill , M. Using Hydrogen Assisted Jet Ignition to Extend the Knock Limit Thesis (M.Eng.Sc.) Department of Mechanical and Manufacturing Engineering, University of Melbourne 2010
- Amann , C. Cylinder-Pressure Measurement and Its Use in Engine Research SAE Technical Paper 852067 1985 10.4271/852067
- Lancaster , D. , Krieger , R. , and Lienesch , J. Measurement and Analysis of Engine Pressure Data SAE Technical Paper 750026 1975 10.4271/750026
- Hamori , F. Exploring the limits of Hydrogen Assisted Jet Ignition Thesis (Ph.D.) Department of Mechanical and Manufacturing Engineering, University of Melbourne 2006
- Watson , H.C. , Milkins , E.E. , and Goldsworthy , L.C. Optimising the S.I Engine Pre-Chamber Geomtery including Spark Plug Configuration for Minimum NOx Emissions and Maximum Efficiency 19th Fisita Congress Melbourne, Australia 1982