This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Prestrain Effect on the Sheared Edge Flangeability of Dual Phase 780 Steels
Technical Paper
2012-01-0533
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Edge flanging represents one of the forming modes employed in multistage forming, and advanced high strength steels (AHSS) are more prone to edge cracking during sheared edge flanging than the conventional high strength steels (HSS) and mild steels. The performance of the sheared edge in flanging operation depends on the remaining ductility of the material in the sheared edge after the work hardening (WH) and damage produced by blanking and subsequent forming operations. Therefore, it is important to analyze the effect of work hardening produced by blanking and subsequent forming operations prior to edge flanging on the edge flanging performance. In this study, the effect of different forming operation sequences prior to edge flanging on the edge flanging performance was analyzed for a dual phase 780 steel. Sheared edge flanging performance was evaluated by hole expansion testing of specimens produced by the following forming operation sequences:
- Punching and flanging
- Uniaxial stretching, punching and flanging
- Biaxial stretching, punching and flanging
- Punching, biaxial stretching and flanging
The results show that the hole expansion limit is not affected by uniaxial or biaxial prestraining prior to hole punching. Therefore, work hardening in multistage forming prior to edge trimming should have little or no effect on edge flangeability
Recommended Content
Authors
Citation
Chiriac, C., Shi, M., and Link, T., "The Prestrain Effect on the Sheared Edge Flangeability of Dual Phase 780 Steels," SAE Technical Paper 2012-01-0533, 2012, https://doi.org/10.4271/2012-01-0533.Also In
References
- Chiriac, C. Chen, G. “Local Formability Characterization of AHSS - Digital Camera Based Hole Expansion Test Development,” IDDRG 2008 81 91
- Held, C. Schleich, R. Sindel, M. Liewald, M. “Investigation on Advanced Forming Limit Prediction Technique for High Strength Steels,” IDDRG 2009 461 469
- Hua-Chu, S. Chiriac, C. Shi, M. F. “The Effects of AHSS Shear Edge Condition on Edge Fracture,” MSEC2010-34062
- Seo, Y. “Improving Blank Conditions in Progressive Stamping: Reducing Edge Defects Improves Subsequent Forming,” Stamping Journal 15 2003 38 40
- Chiriac, C. “Sheared Edge Performance of DP780 Steels- Conventional vs. Improved Bending and Flanging (IBF) Steels,” MS&T 2010 Conference
- Chiriac, C. Hua-Chu, S. “Investigations on Sheared Edge Damage of Dual Phase 780 Steel,” MS&T 2011 Conference