This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Integration of Real and Virtual Tools for Suspension Development
Technical Paper
2011-26-0115
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SIAT 2011
Language:
English
Abstract
Suspension development is one of the key steps in a complete vehicle development program. Computer simulation and analysis tools such as Multi Body Dynamics (MBD) simulation are used to refine initial concept and suspension parameters. Later on when a physical prototype is available the suspension system can be experimentally optimized at vehicle level.
In this paper a new methodology is proposed which integrates virtual and experimental tools so that design, development and validation of the suspension system is carried out in the early phase of the vehicle development cycle with actual suspension components and without the need of a vehicle prototype.
With this new approach, the design of any critical suspension components such as dampers can be optimized at the vehicle level.
The new approach consists of combining the actual physical components on loading rig in closed loop with vehicle dynamic model running in real time. This technique is known as “Mechanical Hardware in the Loop” (mHIL).
This paper presents results of application of mHIL techniques for evaluation of SUV damper. It is observed that having the real damper in loop with simulated vehicle model improves the accuracy of the simulation results. This is because the effect of hysteresis as well as use of bush at damper ends are considered, which is not the case in use of simplified damper properties during virtual simulation.
As a result of this breakthrough technique, vehicle development teams can optimize suspension designs in the early concept stage and perform fewer and faster iterations during the detailed development stage. This allows OEMs to eliminate weak spots and potential problems in key attribute areas such as ride and handling early in the validation process, before the creation of detailed CAE models and full vehicle prototypes.
Recommended Content
Technical Paper | Automation of Adams/Car K&C Correlation using MATLAB |
Technical Paper | Development of a Vehicle Animation Tool Using Matlab Virtual Reality Toolbox |
Technical Paper | Controller of Magneto-Rheological Semi-Active Car Suspension |
Authors
- M. R. Saraf - The Automotive Research Association of India
- Medha S. Jambhale - The Automotive Research Association of India
- Prashant R. Pawar - The Automotive Research Association of India
- Ameen Shaikh - The Automotive Research Association of India
- Shivani Dwivedi - The Automotive Research Association of India
- Ford Boone - MTS Systems Corp.
- Juan Garcia - MTS Systems Corp.
- Tom Stachel - MTS Systems Corp.
Topic
Citation
Saraf, M., Jambhale, M., Pawar, P., Shaikh, A. et al., "Integration of Real and Virtual Tools for Suspension Development," SAE Technical Paper 2011-26-0115, 2011, https://doi.org/10.4271/2011-26-0115.Also In
References
- “Vehicle Dynamics: Technologies and Trends to 2015” An Automotive World Publication 14 Great College Street Westminster, London SW1P 3RX
- Reimpell, J Stoll, H “The Automotive Chassis” Arnold 338 Euston Road, London NW1 3BH
- Determination of Centre of Gravity of the Vehicle Annex 3, E/ECE/324, E/ECE/TRANS/505, Regulation No.66 23 27