This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Investigating Mode Switch from SI to HCCI using Early Intake Valve Closing and Negative Valve Overlap
Technical Paper
2011-01-1775
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This study investigates mode switching from spark ignited operation with early intake valve closing to residual gas enhanced HCCI using negative valve overlap on a port-fuel injected light-duty diesel engine.
A mode switch is demonstrated at 3.5 bar IMEPnet and 1500 rpm. Valve timings and fuel amount have to be selected carefully prior to the mode switch. During mode transition, IMEPnet deviates by up to 0.5 bar from the set point. The time required to return to the set point as well as the transient behavior of the engine load varies depending on which control structure that is used. Both a model-based controller and a PI control approach were implemented and evaluated in experiments. The controllers were active in HCCI mode. The model-based controller achieved a smoother transition and while using it, the transition could be accomplished within three engine cycles.
The initial deviation in load is unacceptable but can most likely be improved with a predictive mode transition model compared to empirically selected mode transition parameters. Changing the fuel injection method to direct injection instead of port injection is another possible improvement.
Recommended Content
Authors
Citation
Widd, A., Johansson, R., Borgqvist, P., Tunestal, P. et al., "Investigating Mode Switch from SI to HCCI using Early Intake Valve Closing and Negative Valve Overlap," SAE Technical Paper 2011-01-1775, 2011, https://doi.org/10.4271/2011-01-1775.Also In
References
- Bengtsson, J. Strandh, P. Johansson, R. Tunestål, P. Johansson, B. “Hybrid Modelling of Homogeneous Charge Compression Ignition (HCCI) Engine Dynamics-A Survey” Int. Journal of Control 80 11 1814 1848 2007
- Bengtsson, J. Strandh, P. Johansson, R. Tunestål, P. Johansson, B. Hybrid Control of Homogeneous Charge Compression Ignition (HCCI) Engine Dynamics Int. Journal of Control 79 5 422 448 2006
- Willand, J. Nieberding, R-G. Vent, G. Enderle, C. “The knocking Syndrome - Its Cure and its Potential” SAE 982483
- Koopmans, L. Ström, H. Lundgren, S. Backlund, O. Denbratt, I. “Demonstrating a SI-HCCI-SI Mode Change on a Volvo 5-Cylinder Electronic Valve Control Engine” SAE 2003-01-0753
- Milovanovic, N. Blundell, D. Gedge, S. Turner, J. “SI-HCCI-SI Mode Transition at Different Engine Operating Conditions” SAE 2005-01-0156
- Kakuya, H. Yamaoka, S. Kumano, K. Sato, S. “Investigation of a SI-HCCI Combustion Switching Control Method in a Multi-Cylinder Gasoline Engine” SAE 2008-01-0792
- Kitamura, T. Takanashi, J. Urata, Y. Ogawa, K. “A Study on Ignition Timing and Combustion Switching Control of Gasoline HCCI Engine” SAE 2009-01-1128
- Zhang, Y. Xie, H. Zhao, H. ”Investigation of SI-HCCI Hybrid Combustion and Control Strategies for Combustion Mode Switching in a Four-stroke Gasoline Engine” Combustion Science and Technology 181 5 782 799
- Roelle, M. Shaver, G. M. Gerdes, J. C. “Tackling the transition: a multi-mode combustion model of SI and HCCI for mode transition control” IMECE2004-62188, Proc. IMECE'04 CA, USA Nov 2004
- Law, D. Kemp, D. Allen, J. Kirkpatrick, G. Copland, T. “Controlled Combustion in an IC-Engine with a Fully Variable Valve Train” SAE 2000-01-0251
- Zhao, H. Li, J. Ma, T. Ladommatos, N. “Performance and Analysis of a 4-Stroke Multi-Cylinder Gasoline Engine with CAI Combustion” SAE 2002-01-0420
- Wolters, P. Salber, W. Geiger, J. Duesmann, M. “Controlled Auto Ignition Combustion Process with an Electromechanical Valve Train” SAE 2003-01-0032
- Fuerhapter, A. Piock, W. F. Fraidl, G. K. “CSI - Controlled Auto Ignition - the Best Solution for the Fuel Consumption - Versus Emission Trade-Off?” SAE 2003-01-0754
- Cao, L. Zhao, H. Jiang, X. Kalian, N. “Effects of Intake Valve Timing on Premixed Gasoline Engine with CAI Combustion” SAE 2004-01-2953
- Borgqvist, P. Tunestål, P. Johansson, B. “Investigation and Comparison of Residual Gas Enhanced HCCI using Trapping (NVO HCCI) or Rebreathing of Residual Gases” JSAE 20119058
- Trajkovic, S. Milosavljevic, A. Tunestål, P. Johansson, B. “FPGA Controlled Pneumatic Variable Valve Actuation” SAE Paper 2006-01-0041
- Tomoda, T. Ogawa, T. Ohki, H. Kogo, T. Nakatani, K. Hashimoto, E. “Improvement of Diesel Engine Performance by Variable Valve Train System” Int. J. Engine Research 11 5 2010 331 344
- Johansson, R. “System Modeling and Identification” Prentice Hall Englewood Cliffs, New Jersey 1993
- Johansson, R. “Predictive and Adaptive Control” Lecture Notes Lund University August 2010
- Widd, A. Ekholm, K. Tunestål, P. Johansson, R. “Experimental Evaluation of Predictive Combustion Phasing Control in an HCCI Engine using Fast Thermal Management and VVA” Proc. 2009 IEEE Multi-Conference on Systems and Control St Petersburg, Russia July 2009 334 339