This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Smoothing HCCI Heat Release with Vaporization-Cooling-Induced Thermal Stratification using Ethanol

Journal Article
2011-01-1760
ISSN: 1946-3952, e-ISSN: 1946-3960
Published August 30, 2011 by SAE International in United States
Smoothing HCCI Heat Release with Vaporization-Cooling-Induced Thermal Stratification using Ethanol
Sector:
Citation: Sjoberg, M. and Dec, J., "Smoothing HCCI Heat Release with Vaporization-Cooling-Induced Thermal Stratification using Ethanol," SAE Int. J. Fuels Lubr. 5(1):7-27, 2012, https://doi.org/10.4271/2011-01-1760.
Language: English

References

  1. Sjöberg, M. Dec, J.E. Cernansky, N.P. “Potential of Thermal Stratification and Combustion Retard for Reducing Pressure-Rise Rates in HCCI Engines, based on Multi-Zone Modeling and Experiments,” SAE Paper 2005-01-0113 2005
  2. Olsson, J.-O. Tunestål, P. Johansson, B. Fiveland, S. Agama, J.R. Assanis, D.N. “Compression Ratio Influence on Maximum Load of a Natural Gas-Fueled HCCI Engine” SAE Paper 2002-01-0111 2002
  3. Sjöberg, M. Dec, J.E. “Comparing Late-cycle Autoignition Stability for Single- and Two-Stage Ignition Fuels in HCCI Engines,” Proceedings of the Combustion Institute 31 2895 2902 2007
  4. Dec, J. Yang, Y. “Boosted HCCI for High Power without Engine Knock and with Ultra-Low NOx Emissions - using Conventional Gasoline,” SAE Int. J. Engines 3 1 750 767 2010 10.4271/2010-01-1086
  5. Christie, M. Fortino, N. Yilmaz, H. “Parameter Optimization of a Turbo Charged Direct Injection Flex Fuel SI Engine,” SAE Int. J. Engines 2 1 123 133 2009 10.4271/2009-01-0238
  6. Sjoberg, M. Dec, J. “Ethanol Autoignition Characteristics and HCCI Performance for Wide Ranges of Engine Speed, Load and Boost,” SAE Int. J. Engines 3 1 84 106 2010 10.4271/2010-01-0338
  7. US Environmental Protection Agency http://www.epa.gov/otaq/fuels/renewablefuels/index.htm
  8. Sjöberg, M. Dec, J.E. “Effects of Engine Speed, Fueling Rate, and Combustion Phasing on the Thermal Stratification Required to Limit HCCI Knocking Intensity,” SAE Transactions 114 1472 1486 SAE Paper 2005-01-2125 2005
  9. Dec, J.E. Sjöberg, M. “A Parametric Study of HCCI Combustion - the Sources of Emissions at Low Loads and the Effects of GDI Fuel Injection,” SAE Paper 2003-01-0752 2003
  10. Heywood, J.B. “Internal Combustion Engine Funda-mentals,” McGraw-Hill New York 13: 9780070286375 1988
  11. Dec, J. Sjöberg, M. Hwang, W. Davisson, M. et al. “Detailed HCCI Exhaust Speciation and the Sources of Hydrocarbon and Oxygenated Hydrocarbon Emissions,” SAE Int. J. Fuels Lubr. 1 1 50 67 2009 10.4271/2008-01-0053
  12. Sjöberg, M. Dec, J.E. “Effects of EGR and Its Constituents on HCCI Autoignition of Ethanol,” Proceedings of the Combustion Institute 33 3031 3038 2011 10.1016/j.proci.2010.06.043
  13. Lutz, A. E. Kee, R. J. Miller, J. A. “Senkin: A FORTRAN Program for Predicting Homogeneous Gas Phase Chemical Kinetics with Sensitivity Analysis,” Sandia National Laboratories Report No. SAND87-8248
  14. Lutz, A.E. “Multi-zone Model for Homogeneous Ignition,” Sandia National Laboratories, Internal Report July 8 2002
  15. Curran, H. Serinyel, Z. Metcalfe, W. Combustion Chemistry Centre at NUI Galway, Ireland 2010
  16. Mehl, M. Pitz, W.J. Sjöberg, M. Dec, J.E. “Detailed Kinetic Modeling of Low-Temperature Heat Release for PRF Fuels in an HCCI Engine,” SAE Paper 2009-01-1806 2009
  17. Marinov, N.M. “A Detailed Chemical Kinetic Model for High Temperature Ethanol Oxidation,” International Journal of Chemical Kinetics 31 3 183 220 1999 10.1002/(SICI)1097-4601(1999)31:3<183::AID-KIN3>3.0.CO;2-X
  18. Li, J. Kazakov, A. Chaos, M. Dryer, F.L. “Chemical Kinetics of Ethanol Oxidation,” Paper C26, 5th US Combustion Meeting San Diego 2007
  19. Hawkes, E. University of New South Wales, Australia 2010
  20. Hwang, W. Dec, J.E. Sjöberg, M. “Spectroscopic and Chemical-Kinetic Analysis of the Phases of HCCI Autoignition and Combustion for Single- and Two-Stage Ignition Fuels” Combustion and Flame 154 3 387 409 2008
  21. Konno, M. Chen, Z. Miki, K. “Computational and Experimental Study on the Influence of Formaldehyde on HCCI Combustion Fueled with Dimethyl Ether” JSAE Paper 20030283 SAE 2003-01-1826 2003
  22. Yamaya, Y. Furutani, M. Ohta, Y. “Premixed compression ignition of formaldehyde-doped lean butane/air mixtures in a wide range of temperature” SAE Paper 2004-01-1977 2004
  23. Grandin, B. Denbratt, I. Bood, J. Brackmann, C. Bengtsson, P.-E. “A Study of the influence of exhaust gas recirculation and stoichiometry on the heat release in the end-gas prior to knock using rotational coherent anti-Stokes Raman spectroscopy thermometry,” Int. J. of Engine Research 3 4 209 221 2002
  24. NIST Chemistry WebBook “Standard Reference Database Number 69,” March 2009 http://webbook.nist.gov/chemistry/
  25. Flowers, D.L. Aceves, S.M. Martinez Frias, J. “Improving Ethanol Life Cycle Energy Efficiency by Direct Utilization of Wet Ethanol in HCCI Engines” JSAE Paper 20077037 SAE 2007-01-1867 2007
  26. Sjöberg, M. Dec, J.E. “An Investigation of the Relationship between Measured Intake Temperature, BDC Temperature, and Combustion Phasing for Premixed and DI HCCI Engines,” SAE Paper 2004-01-1900 2004
  27. Anderson, R.W. Yang, J. Brehob, D.D. Vallance, J.K. Whiteaker, R.M. “Understanding the Thermodynamics of Direct-Injection Spark-Ignition (DISI) Combustion Systems: An Analytical and Experimental Investigation” SAE Paper 962018 1996
  28. Dec, J.E. Sjöberg, M. “Isolating the Effects of Fuel Chemistry on Combustion Phasing in an HCCI Engine and the Potential of Fuel Stratification for Ignition Control,” SAE Paper 2004-01-0557 2004
  29. Sjöberg, M. Dec, J. E. “An investigation into lowest acceptable combustion temperatures for hydrocarbon fuels in HCCI engines,” Proceedings of the Combustion Institute 30 2719 2726 2005
  30. Sjöberg, M. Dec, J.E. “Smoothing HCCI Heat-Release Rates using Partial Fuel Stratification with Two-Stage Ignition Fuels” SAE Paper 2006-01-0629 2006
  31. Hwang, W. Dec, J. E. Sjöberg, M. 2007 “Fuel Stratification for Low-Load HCCI Combustion: Performance and Fuel-PLIF Measurements SAE Transactions 116 3 1437 1460 paper 2007-01-4130
  32. Brakora, J. Engine Research Center at University of Wisconsin - Madison 2010
  33. Yang, Y. Dec, J.E. Dronniou, N. Sjöberg, M. “Tailoring HCCI Heat Release Rates with Partial Fuel Stratification: Comparison of Two-Stage and Single-Stage Ignition Fuels” Proceedings of the Combustion Institute 33 2011 3047 3055 10.1016/j.proci.2010.06.114
  34. Dec, J. Hwang, W. “Characterizing the Development of Thermal Stratification in an HCCI Engine Using Planar-Imaging Thermometry,” SAE Int. J. Engines 2 1 421 438 2009 10.4271/2009-01-0650
  35. Sjöberg, M. Dec, J.E. Babajimopoulos, A. Assanis, D. “Comparing Enhanced Natural Thermal Stratification against Retarded Combustion Phasing for Smoothing of HCCI Heat-Release Rates,” SAE Paper 2004-01-2994 2004
  36. De Zilwa, S. Steeper, R. “Predicting NO x Emissions from HCCI Engines Using LIF Imaging,” SAE Paper 2006-01-0025 2006
  37. Yang, Y. Dec, J. Dronniou, N. Sjöberg, M. et al. “Partial Fuel Stratification to Control HCCI Heat Release Rates: Fuel Composition and Other Factors Affecting Pre-Ignition Reactions of Two-Stage Ignition Fuels,” SAE Int. J. Engines 4 1 1903 1920 2011 10.4271/2011-01-1359
  38. Dec, J. Yang, Y. Dronniou, N. “Boosted HCCI - Controlling Pressure-Rise Rates for Performance Improvements using Partial Fuel Stratification with Conventional Gasoline,” SAE Int. J. Engines 4 1 1169 1189 2011 10.4271/2011-01-0897
  39. Inagaki, K. Fuyuto, T. Nishikawa, K. Nakakita, K. Sakata, I. “Dual-Fuel PCI Combustion Controlled by In-Cylinder Stratification of Ignitability” SAE Paper 2006-01-0028 2006
  40. Splitter, D. Hanson, R. Kokjohn, S. Reitz, R. “Reactivity Controlled Compression Ignition (RCCI) Heavy-Duty Engine Operation at Mid-and High-Loads with Conventional and Alternative Fuels” SAE Paper 2011-01-0363 2011

Cited By