This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Time-Domain Source Contribution Analysis Method for In-Room Pass-By Noise
Technical Paper
2011-01-1609
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper presents a new time-domain source contribution analysis method for in-room pass-by noise. The core of the method is a frequency-domain ASQ model (Airborne Source Quantification) representing each noise generating component (engine, exhaust, left and right tyres, etc.) by a number of acoustic sources. The ASQ model requires the measurement of local FRF's and acoustic noise transfer functions to identify the operational loads from nearby pressure indicator responses and propagate the loads to the various target microphones on the sides of the vehicle. Once a good ASQ model is obtained, FIR filters are constructed, allowing a time-domain synthesis of the various source contributions to each target microphone. The synthesized target response signals are finally recombined into a pass-by sound by taking into account the speed profile of the vehicle. This allows several useful analyses such as: i) analysis and ranking of the source contributions during a pass-by, ii) comparison of the summed path contributions with the measurement data, iii) in-depth time and frequency analyses, iv) auralization and sound quality evaluations. A large in-room test campaign was carried out to validate the proposed method. The tests were performed on a passenger car in a chassis dyno semianechoic room. Several operational tests were conducted including run-up, coast-down and constant speed experiments in different throttles and gears, tests on smooth and tarmac road profiles, measurements with the powertrain switched off and tests according to the ISO 362 standard (2007). A reduced ASQ model was utilized shortening the total measurement time. The test results were very satisfying, exposing physically realistic source contributions and a sound quality accurate synthesis up to 8 kHz.
Recommended Content
Authors
Citation
Janssens, K., Aarnoutse, P., Gajdatsy, P., Britte, L. et al., "Time-Domain Source Contribution Analysis Method for In-Room Pass-By Noise," SAE Technical Paper 2011-01-1609, 2011, https://doi.org/10.4271/2011-01-1609.Also In
References
- Verheij, J.W. 1997 “Inverse and reciprocity methods for machinery noise source characterization and sound path quantification, part 1: sources” International Journal of Acoustics and Vibration 2 1 1997 11 20
- Verheij, J.W. Hopmans, L.J.M. 1996 “Use of a new acoustical source descriptor for designing quieter heavy road vehicles” Proc. ISMA 21 Leuven, Belgium Sept. 18 - 20 1996
- Fleszar, A. van der Linden, P. Johnson, J. Grimmer, M. “Combining Vehicle and Test-Bed Diagnosis Information to Guide Vehicle Development for Pass-By Noise,” SAE Technical Paper 2001-01-1565 2001 10.4271/2001-01-1565
- Van der Linden, P. Floetke, H. 2001 “Comparing inverse force identification and mount stiffness force identification methods for noise contribution analysis” Proc. ISMA 2004 Conf. Sept. 2001 Leuven, Belgium
- Smith, S 2003 “Digital signal processing: a practical guide for engineers and scientists” Elsevier Science 2003 0-750674-44-X