This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Cold-Start Emissions Model of an Engine and Aftertreatment System for Optimisation Studies
Technical Paper
2010-01-1274
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The minimisation of tail-pipe emissions and fuel consumption during cold-start can be viewed as a constrained optimisation problem involving many parameters. Examining this problem mathematically first requires an accurate and computationally practical model of the engine and exhaust system. This paper proposes such a model for use during the cold-start of a conventional spark ignition engine. This model uses as much physics-based modelling as is computationally practical for optimisation and control studies. It takes a given set of engine control inputs to simulate tailpipe
CO
,
HC
and
NO
emissions, and is both calibrated and validated using detailed measurements obtained on a transient engine dynamometer following the New European Drive Cycle (NEDC).
Recommended Content
Authors
Citation
Andrianov, D., Keynejad, F., Dingli, R., Voice, G. et al., "A Cold-Start Emissions Model of an Engine and Aftertreatment System for Optimisation Studies," SAE Technical Paper 2010-01-1274, 2010, https://doi.org/10.4271/2010-01-1274.Also In
References
- Pfalzgraf B. Rieger M. Ottowitz G. "Close-Coupled Catalytic Converters for Compliance with LEV/ULEV and EGIII Legislation - Influence of Support Material, Cell Density and Mass on Emission Results SAE Techncial Paper 960261 1996
- Henein N.A. Tagomori M.K. Cold-Start Hydrocarbon Emissions in Port-Injected Engines Progress in Energy and Combustion Science 25 563 593 1999
- Engler B.H. Lindner D. Lox E.S. Ostgathe K. et al. "Reduction of Exhaust Gas Emissions by Using Hydrocarbon Adsorber Systems SAE Techncial Paper 930738 1993
- Lafyatis D.S. Ansell G.P. Bennett S.C. Frost J.C. Millington P.J. Rajaram R.R. Walker A.P. Ballinger T.H. Ambient Temperature Light-Off for Automobile Emission Control Applied Catalysis B: Environmental 18 123 135 1998
- Ma T. Collings N. Hands T. "Exhaust Gas Ignition (EGI) - A New Concept for Rapid Light-Off of Automotive Exhaust Catalyst SAE Technical Paper 920400 1992
- Kanada Y. Hayasi M. Akaki M. Tsuchikawa S. et al. "Hydrogen Added After-Burner System SAE Technical Paper 960346 1996
- Oh S.H. Bissett E.J. Battiston P.A. Mathematical Modeling of Electrically Heated Monolith Converters: Model Formulation, Numerical Methods, and Experimental Verification Industrial & Engineering Chemistry Product Research and Development 32 1560 1567 1993
- Kirchner T. Eigenberger G. Optimization of the Cold-Start Behaviour of Automotive Catalysts Using an Electrically Heated Pre-Catalyst Chemical Engineering Science 51 10 2409 2418 1996
- Fiengo G. Glielmo L. Santini S. Serra G. Control-Oriented Models for TWC-equipped Spark Ignition Engines During the Warm-Up Phase Proceedings of the American Control Conference 1761 1766 2002
- Sanketi P.R. Zavala J.C. Hedrick J.K. Automotive Engine Hybrid Modelling and Control for Reduction of Hydrocarbon Emissions International Journal of Control 79 5 449 464 2006
- Cho D. Hedrick J.K. Automotive Powertrain Modeling for Control ASME Journal of Dynamic Systems, Measurement, and Control 111 568 576 1989
- Hendricks E. Sorenson S. Mean Value SI Engine Model for Control Studies Proceedings of the American Control Conference 1882 1887 1990
- Manzie C. Keynejad F. Andrianov D.I. Dingli R.J. Voice G. A Control-Oriented Model for Cold Start Operation of Spark Ignition Engines IFAC Workshop on Engine and Powertrain Control, Simulation and Modeling 2009
- Sandoval D. Heywood J.B. "An Improved Friction Model for Spark-Ignition Engines SAE Technical Paper 2003-01-0725 2003
- Lumsden G. "Characterizing Engine Emissions with Spark Efficiency Curves SAE Technical Paper 2004-01-3055 2004
- Guzzella L. Onder C.H. Introduction to Modeling and Control of Internal Combustion Engine Systems Springer 2004
- Heywood J.B. Internal Combustion Engine Fundamentals McGraw-Hill 1988
- Heck R.H. Wei J. Katzer J.R. Mathematical Modeling of Monolithic Catalysts AIChE Journal 22 3 1976
- Oh S.H. Cavendish J.C. Transients of Monolithic Catalytic Converters: Response to Step Changes in Feedstream Temperature as Related to Controlling Automobile Emissions Industrial & Engineering Chemistry Product Research and Development 21 1 29 37 1982
- Groppi G. Belloli A. Tronconi E. Forzatti P. A Comparison of Lumped and Distributed Models of Monolith Catalytic Combustors Chemical Engineering Science 50 17 2705 2715 1995
- Siemund S. Leclerc J.P Schweich D. Prigent M. Castagna F. Three-Way Monolithic Converter: Simulations Versus Experiments Chemical Engineering Science 51 15 3709 3720 1996
- Pontikakis G.N. Stamatelos A.M. Identification of Catalytic Converter Kinetic Model Using a Genetic Algorithm Approach Proceedings Institution of Mechanical Engineers 218 1455 1472 2004
- Holder R. Bollig M. Anderson D.R. Hochmuth J.K. A Discussion on Transport Phenomena and Three-Way Kinetics of Monolithic Converters Chemical Engineering Science 61 8010 8027 2006
- Hayes R.E. Kolaczkowski S.T. Mass and Heat Transfer Effects in Catalytic Monolith Reactors Chemical Engineering Science 49 21 3587 3599 1994
- Wanker R. Raupenstrauch H. Staudinger G. A Fully Distributed Model for the Simulation of a Catalytic Combustor Chemical Engineering Science 55 4709 4718 2000
- Jeong S.J. Kim W.S. A New Strategy for Improving the Warm-Up Performance of a Light-Off Auto-Catalyst for Reducing Cold-Start Emissions Proceedings Institution of Mechanical Engineers 215 1179 1196 2001
- Brandt E.P. Wang Y. Grizzle J.W. Dynamic Modeling of a Three-Way Catalyst for SI Engine Exhaust Emission Control IEEE Transactions on Control Systems Technology 8 5 2000
- Shaw B.T. Fischer G.D. Hedrick J.K. A Simplified Coldstart Catalyst Thermal Model to Reduce Hydrocarbon Emissions Proceedings of 15th Triennial World Congress of the International Federation of Automatic Control 2002
- Khalil H.K. Nonlinear Systems Prentice-Hall, Inc. 2002
- Annand W.J.D. Heat Transfer in the Cylinders of Reciprocating Internal Combustion Engines Proceedings Institution of Mechanical Engineers 177 36 973 990 1963
- Balenovic M. Modeling and Model-Based Control of a Three-Way Catalytic Converter Technical University of Eindhoven 2002
- Andrianov D.I. Dingli R.J. Brear M.J. Manzie C. The Effect of Grid Resolution and Oxygen Storage in a One-Dimensional Monolithic Three-Way Catalyst Model IFAC Workshop on Engine and Powertrain Control, Simulation and Modeling 2009
- Hawthorn R.D. Afterburner Catalysts Effects of Heat and Mass Transfer Between Gas and Catalyst Surface American Institute of Chemical Engineers Symposium Series 70 428 438 1974
- Fuller E.N. Schettler P.D. Giddings J.C. A New Method for Prediction of Binary Gas-Phase Diffusion Coefficients Industrial and Engineering Chemistry 58 5 1966
- Petzold L.R. A Description of DASSL: A Differential/Algebraic System Solver IMACS World Congress 1982