This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Characterisation of Diesel Engine Transient Pumping-loss and Control Methodology for Transient Specific Fuel Consumption (SFC)
Technical Paper
2009-01-2748
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This study measures, during various transients of speed and load, in-cylinder-, intake-/exhaust- (manifold) pressures and engine torque. The tests were conducted on a typical high power-density, passenger car powertrain (common-rail diesel engine, of in-line 4-cylinder configuration equipped with a Variable Geometry Turbocharger). The objective was to quantify the deterioration (relative to a steady-steady condition) in transient Specific Fuel Consumption (SFC) that may occur during lagged-boost closed-loop control and thus propose an engine control strategy that minimises the transient SFC deterioration. The results, from transient characterisation and the analysis method applied in this study, indicate that transient SFC can deteriorate up to 30% (function of load transient) and is primarily caused by excessive engine pumping-loss. The results are used to create an empirical model to estimate SFC online and a control methodology is proposed that restricts turbocharger-vanes closure as a function of SFC deviation from the steady-state calibration, thus reducing pumping-loss during transients.
Recommended Content
Authors
Topic
Citation
Tufail, K., Winstanley, T., Karagiorgis, S., Hardalupas, Y. et al., "Characterisation of Diesel Engine Transient Pumping-loss and Control Methodology for Transient Specific Fuel Consumption (SFC)," SAE Technical Paper 2009-01-2748, 2009, https://doi.org/10.4271/2009-01-2748.Also In
References
- Alain, C. Stephane, G. Claude, L. Patrice, H. Saulnier, S. “Advanced Diesel Powertrain for Reduced Fuel Consumption and C02 Emissions” SAE Paper No. 2004-05-0152 2004
- Chandran, V. Madhavan, K. “Impact of charging and downsizing on CO2 emissions – Strategic bird’s eye view” Achieving the optimum level of downsizing – Combining charging and downsizing advantages – Optimising hybridisation of downsized engine, 2nd Annual Conference Advanced Charging and Downsizing Concepts 2009
- Rakopoulos, C. D. Giakoumis, E. G. Hountalas, D. T. Rakopoulos, D. C. “The Effect of Various Dynamic, Thermodynamic and Design Parameters on the Performance of a Turbocharged Diesel Engine Operating under Transient Load Conditions” SAE Paper No. 2004-01-0926 2004
- Rakopoulos, C. D. Giakoumis, E. G. “Parametric Study of Transient Turbocharged Diesel Engine Operation from the Second-Law Perspective” SAE Paper No. 2004-01-1679 2004
- Pettiti, M. Pilo, L. Millo, F. “Development of a New Mean Value Model for the Analysis of Turbolag Phenomena in Automotive Diesel Engines” SAE Paper No. 2007-01-1301 2007
- Galindo, J. Serrano, J. R. Climent, H. Tiseira, A. “Experiments and modelling of surge in small centrifugal compressor for automotive engines” Experimental Thermal and Fluid Science 32 2008 818 826
- Rakopoulas, C. D. Giakoumis, E. G. “Diesel Engine Transient Operation, Principles of Operation and Simulation Analysis” Springer-Verlag London Ltd 2009
- Stas, M. J. “Effect of Exhaust Blowdown Period on Pumping Losses in a Turbocharged Direct Injection Diesel Engine” SAE Paper No. 1999-01-0188 1999
- Hawley, J. G. Wallace, F. J. Cox, A. Horrocks, R. W. Bird, G. L. 1999 “Variable geometry turbocharging for lower emissions and improved torque characteristics” IMechE, Proc Instn Mech Engrs 213 Part D 145 159
- Wijetunge, R. S. Hawley, J. G. Vaughan, N. D. “Application of Alternative EGR and VGT Strategies to a Diesel Engine” SAE Paper No. 2004-01-0899 2004
- Guzzella, L. Onder, C. H. “Introduction to Modeling and Control of Internal Combustion Engine System” Springer-Verlag Berlin Heidelberg 2004
- Wang, E. Xia, S. Ouyang, M. Li, J Li, X “Control System Design for Variable Nozzle Turbocharger” SAE Paper No. 2009-01-1668 2009
- Arnold, S. Groskreutz, M. Shahed, S. M Slupski, K. Advanced Variable Geometry Turbocharger for Diesel Engine Applications” SAE Paper No. 2002-01-0161 2002
- Benajes, J. Lujan, J. M. Bermudez, V Serrano, J. R. 2002 “Modelling of turbocharged diesel engines in transient operation. Part 1: insight into the relevant physical phenomena” Proc. IMechE Part D: Journal of Automobile Engineering 216 4 431 441
- Payri, F. Benajes, J. Galindo, J. Serrano, J. R. 2002 “Modelling of turbocharged diesel engines in transient operation. Part 2: wave action models for calculating the transient operation in a high speed direct injection engine” Proc. IMechE Part D: Journal of Automobile Engineering 216 4 479 493
- Osako, K. Higashimori, H. Mikogami, T. “Study on the internal flow of radial turbine rotating blades for automotive turbocharging” SAE Paper No. 2002-01-0856 2002
- Martinez-Botas, R. F. 2001 “Mixed-flow Turbine: Steady and Unsteady performance with detailed flow measurements in Thermofluid dynamic processes in diesel engines” Whitelaw, J.H. Payri, F. Desantes, J. Springer Verlag 239 263
- Jain, D. 1990 “Using an electronically controlled VGT to improve engine transient performance” IMechE Seminar on Engine Transient Performance 7 November 27 30
- Fieweger, K. Paffrath, H. Schorn, N. 2002 “Drivability assessment of an HSDI diesel engine with electrical assisted boosting systems” 7 th International Conference on Turbochargers and Turbocharging C602 009
- Black, J. Eastwood, P. G. Tufail, K. Winstanley, T. Hardalupas, Y. Taylor, A. M. K. P. “The effect of VGT vane control on pumping losses during full-load transient operation of a common-rail diesel engine” SAE Paper No. 2007-24-0063 2007