This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Braking Systems Creep Groan Noise: Detection and Evaluation
Technical Paper
2009-01-2103
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
“Creep groan” is a braking systems noise that is observed when a vehicle is starting to move from a stopped condition with brake pressure applied. Motion takes place when brake pressure is reduced while a motive force, such as an idling engine through an automatic transmission, or gravity due to the vehicle being on a slope, is present. The vibration causing the sound is commonly thought to result from friction force variation in stick-slip mode. Detection and evaluation of “creep groan” noise has been a challenge for NVH test groups. First, this sound typically is not purely tonal like the more common brake squeal, although ultimately it may produce a tonal subjective impression. In this work the authors study different methods that may be applied to “creep groan” detection and evaluation. A method for pre-filtering time-data signals to enhance detectability of “creep groan” events is documented, and methods for evaluating and quantifying this noise related to its time-varying behavior, subjective impression and annoyance are also presented.
Recommended Content
Technical Paper | Mechanisms of Brake Creep Groan |
Technical Paper | Diagnosis of Off-Brake Performance Issues with Low Range Pressure Distribution Sensors |
Ground Vehicle Standard | Hydrodynamic Drive Test Code |
Citation
Abdelhamid, M. and Bray, W., "Braking Systems Creep Groan Noise: Detection and Evaluation," SAE Technical Paper 2009-01-2103, 2009, https://doi.org/10.4271/2009-01-2103.Also In
References
- Abdelhamid, M.K. “Creep Groan of disc brakes” SAE Paper 951282 1995
- Donley, M. Riesland, Dave “Brake Groan Simulation for a McPherson Type Suspension” SAE Brake Colloquium, Paper 03NV-234 2003
- Crowther Ashley R. Singh Rajendra “Analytical investigation of stick-slip motions in coupled brake-driveline systems” Nonlinear Dyn 2007 50 463 481
- Bettelia, M. Harrison, M.F. Sharp, R.S. “Investigation of Automotive Creep Groan Noise with a Distributed-Source Excitation Technique” Journal of Sound and Vibration 2002 255 3 531 547
- Genuit, Klaus A New Approach to Objective Determination of Noise Quality Based on Relative Parameters Proc. InterNoise 1996 Liverpool, U. K.
- DIN 45681 Acoustics Determination of tonal components of noise and determination of a tone adjustment for the assessment of noise immissions 2005 Deutsche Institut für Normung e. V.
- Aures, W. 1985a Berechnungsverfahren für den sensorischen Wohlklang beliebiger Schallsignale Acustica 59 130 141
- Inoue, Mitsuhiro Ronbunshu Nihon K.G. The stick Slip Motion of Disc Brake Pads 56 521 1990
- DIN 45631/A1 Berechnung des Lautstärkepegels und der Lautheit aus dem Geräuschspektrum - Verfahren nach Zwicker E. - Änderung 1 April 2007 Deutsche Institut für Normung e. V.
- Thompson, James “A Status Report on the Work of the SAE Brake NVH Standards Committee” 2007 SAE Brake Colloquium.