This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Lubricating Condition of Piston Ring and Cylinder for Significantly Reducing Piston Friction Loss (Lubricating Condition of Plateau-Honing and Single-Honing Cylindersduring Break-in)
Technical Paper
2009-01-0188
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The relationship between piston ring and out side of diameter (hereon referred to as OD) wear of ring has not been fully analyzed. In this study, the relationship between the ring OD wear and ring friction force during the break-in period, where ring OD wear occurs in a short period of time, was analyzed. After 20 hours of firing test, Friction mean effective Pressure (hereon referred to as FMEP) of nitrided ring having OD wear was 1.6kPa higher than that of Physical Vapor Deposition (hereon referred to as PVD) ring having little amount of wear (hereon referred to as “no OD wear”).
In addition, lubricating condition of piston system during break-in period was also analyzed in this study.
When plateau-honing cylinder was used, the FMEP showed an increasing trend over a 20-hour period of firing test. The cause of this increasing trend is the deterioration of lubricating condition of the piston skirt.
Recommended Content
Authors
Topic
Citation
Wakabayashi, R., Mochiduki, K., and Yoshida, H., "Lubricating Condition of Piston Ring and Cylinder for Significantly Reducing Piston Friction Loss (Lubricating Condition of Plateau-Honing and Single-Honing Cylindersduring Break-in)," SAE Technical Paper 2009-01-0188, 2009, https://doi.org/10.4271/2009-01-0188.Also In
References
- Wakabayashi Ryo et al. “The Effects of Piston Rings and Liner Break-in on Lubricating Condition” SAE 2007-01-1250 2007
- Saito Junichi et al. “Mamougairon 6 Journal of the JIME 37 7 2002
- Yamada Takeshi et al. ”Research Concerning Deterioration of the Amount of Oil Consumption in Diesel Engines” JSAE 38 6 2007
- Bryzik Walter et al. “A Model for Wear and Friction in Cylinder Liners and Piston Rings” Tribology Transactions 49 2006
- Sugai Takashi et al. ”Friction Reduction Effects of Narrow Width and Low-tension Piston Ring Pack,” JSAE, No. 20055181 2005
- Iijima Naoki et al. “Cylinder Honing Angle and Friction of Piston and Piston Rings” JSAE 06 8 2006
- Patir, N. Cheng, H.S ”An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic Lubrication, “Trans ASME, Ser. F 100 1 12 17 1978
- Patir, N. Cheng, H.S “Application of Average Flow Model to Lubrication Between rough Sliding Surfaces,”Trans” ASME, Ser. F 101 2 220 230 1979
- Greenhood, J.A. Tripp, J.H. Proc.Instn Mech. Enger 185 1971 625
- Rohde, S.M. ”Proc. of the 7th Leeds-Lyon Symp.on Trib., Friction and Traction, “( 1980 51