This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Design and Validation of a New 13L Heavy-Duty Diesel Engine Using Analysis-Led Design
Technical Paper
2008-01-2673
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The paper covers the design and development of a new 13L heavy-duty diesel engine. It describes in detail some of the design techniques that were used.
To meet these exacting requirements, extensive use was made of Analysis-Led Design, which allows components, sub-systems and the entire engine, aftertreatment and vehicle system to be modeled before designs are taken to prototype hardware. This enables a level of system and sub-system optimization not previously available.
The engine was designed primarily for on-highway use in China, and the paper describes the emissions strategy for China, and the physical design strategy for the new engine, and provides some engine performance robustness details.
The engine architecture is discussed and the paper details the analysis of the major components - cylinder block, head, head seal, power cylinder, bearings and camshaft drive. Special focus is given to head, block and gasket assembly analysis to produce a higher level of design robustness with high cylinder pressures. The design, analysis and validation of an unusual camshaft gear drive system are discussed. The design of the cylinder head for use at high pressure using gray iron is described. The measures taken to ensure a robust small end bearing are covered, and an assessment is made of thermal heat flux to combustion chamber, and the measures that have been taken as a result of this.
Recommended Content
Authors
Citation
Jackson, P., Addis, B., and Thakare, S., "Design and Validation of a New 13L Heavy-Duty Diesel Engine Using Analysis-Led Design," SAE Technical Paper 2008-01-2673, 2008, https://doi.org/10.4271/2008-01-2673.Also In
References
- Dollmeyer. T et al Meeting the US 2007 Heavy-Duty Diesel Emission Standards∼Designing for the Customer SAE Commercial Vehicle Engineering Congress 2007
- Hoag, K. Norris, P. Experimental and analytical studies of cylinder head cooling SAE Vehicle Thermal Management Systems Conference Columbus 1993
- French, C.C.J Problems arising from the water cooling of engine components I Mech E 184 29
- Pfeiffer, F. Prestl, W. Hammering in Diesel Engine Driveline Systems Non-Linear Dynamics 475 492 1994