This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Reformer Gas Composition Effect on HCCI Combustion of n-Heptane, iso-Octane, and Natural Gas
Technical Paper
2008-01-0049
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Although HCCI engines promise low NOx emissions with high efficiency, they suffer from a narrow operating range between knock and misfire because they lack a direct means of controlling combustion timing. A series of previous studies showed that reformer gas, (RG, defined as a mixture of light gases dominated by hydrogen and carbon monoxide), can be used to control combustion timing without changing mixture dilution, (λ or EGR) which control engine load. The effect of RG blending on combustion timing was found to be mainly related to the difference in auto-ignition characteristics between the RG and base fuel.
The practical effectiveness of RG depends on local production using a fuel processor that consumes the same base fuel as the engine and efficiently produces high-hydrogen RG as a blending additive. Depending on the base fuel, the reforming technique and the reformer operating condition, the molar ratio of hydrogen to carbon monoxide in the RG may vary from more than 3/1 down to around 1/1. One possible barrier to using RG for combustion control is the variation of H2/CO ratio in the RG composition for practical small-scale reformers.
This paper reports on a series of experimental studies using RG blending to control ignition timing with three base fuels: n-Heptane (representing diesel fuel), iso-octane (representing gasoline), and natural gas (commonly used for industrial SI engines). These fuels were tested in a CFR engine operating in the HCCI mode with blends of two different simulated RG compositions characterized by H2/CO ratios of 3/1 and 1/1 to cover a range of actual fuel processor output.
It was found that, for all three fuels, RG blending could provide combustion timing control despite the wide range of reformer gas composition. Taking the n-Heptane case as an example, RG blending retards combustion timing for both RG compositions but the retardation is less for the low H2 fraction RG (1/1) than for the high H2 fraction RG (3/1). It can be concluded, (and modeling supports), that the lower H2 fraction RG has less capability to suppress the radical pool between 1st and 2nd stage ignition. The study results support the possibility of RG blending for HCCI timing control. They also illustrate a trade-off between RG quality, (measured by H2 concentration), and RG quantity required for effective timing control.
Recommended Content
Topic
Citation
Hosseini, V. and Checkel, M., "Reformer Gas Composition Effect on HCCI Combustion of n-Heptane, iso-Octane, and Natural Gas," SAE Technical Paper 2008-01-0049, 2008, https://doi.org/10.4271/2008-01-0049.Also In
References
- Iida, M. Hayashi, M. Foster, D.E. Martin, J.K. Characteristics of Homogeneous Charge compression Ignition (HCCI) Engine Operation for Variations in Compression Ratio, Speed, and Intake Temperature While Using n-Butane as a Fuel Transaction of the ASME 125 472 478 2003
- Sjöberg, M. Dec, J.E. Combined Effects of Fuel-Type and Engine Speed on Intake Temperature Requirements and Completeness of Bulk-Gas Reactions for HCCI Combustion SAE Paper, 2003-01-3173 2003
- Persson, H. Agrell, M. Olsson, J.-O. Johansson, B. Volvo, H.S. The effect of intake temperature on HCCI operation using negative valve overlap SAE Paper, 2004-01-0944 2004
- Haraldsson, G. Tunestål, P. Johansson, B. Hyvönen, J. HCCI closed-loop combustion control using fast thermal management SAE Paper, 2004-01-0943 2004
- Haraldsson, G. Tunestål, P. Johansson, B. Hyvönen, J. HCCI Combustion Phasing in a Multi Cylinder Engine Using Variable Compression Ratio SAE Paper, 2002-01-2858 2002
- Haraldsson, G. Tunestål, P. Johansson, B. Hyvönen, J. HCCI combustion phasing with closed-loop combustion control using variable compression ratio in a multi-cylinder engine SAE Paper, 2003-01-1830 2003
- Haraldsson, G. Tunestål, P. Johansson, B. Hyvönen, J. Transient Control of a Multi Cylinder HCCI Engine During a Drive Cycle SAE Paper, 2005-01-0153 2005
- Hyvönen, J. Haraldsson, G. Johansson, B. Operating range in a multi-cylinder HCCI engine using variable compression ratio SAE Paper, 2003-01-1829 2003
- Hyvönen, J. Haraldsson, G. Johansson, B. Supercharging HCCI to extend the operating range in a multi-cylinder VCR-HCCI engine SAE Paper, 2003-01-3214 2003
- Zhao, H. Peng, Z. Williams, J. Ladommatos, N. Understanding the effects of recycled burnt gases on the controlled autoignition (CAI) combustion in four-stroke gasoline engines SAE Paper, 2001-01-3607 2001
- Christensen, M. Johansson, B. Influence of Mixture Quality on Homogeneous Charge Compression Ignition SAE Paper, 982454 1998
- Aroonsrisopon, T. Sohm, V. Werner, P. Foster, D.E. Morikawa, T. Iida, M. An Investigation Into the Effect of Fuel Composition on HCCI Combustion Characteristics SAE Paper, 2002-01-2830 2002
- Olsson, J.-O. Tunestål, P. Haraldsson, G. Johansson, B. A turbocharged dual-fuel HCCI engine SAE Paper, 2001-01-1896 2001
- Stanglmaier, R.H. Ryan, T.W. Souder, J.S. HCCI operation of a dual-fuel natural gas engine for improved fuel efficiency and ultra-low NOxemissions at low-to-moderate engine loads SAE Paper, 2001-01-1897 2001
- Strandh, P. Bengtsson, J. Johansson, R. Tunestål, P. Johansson, B. Cycle-to-cycle control of a dual-fuel HCCI engine SAE Paper, 2004-01-0941 2004
- Jamal, Y. Wyszynski, M.L. On-board generation of hydrogen-rich gaseous fuels-a review International Journal of Hydrogen Energy 19 7 557 572 1994
- Dicks, A.L. Hydrogen generation from natural gas for the fuel cell systems of tomorrow Journal of Power Sources 61 113 124 1996
- Docter, A. Lamm, A. Gasoline fuel cell systems Journal of Power Sources 84 194 200 1999
- Pereira, C. Wilkenhoener, R. Ahmed, S. Krumpelt, M. Liquid fuel reformer development Proceedings of the 1999 U.S DOE Hydrogen Program Review 1999
- Pereira, C. Bae, J.-M. Ahmed, S. Krumpelt, M. Liquid Fuel Reformer Development: Autothermal Reforming of Diesel Fuel Proceedings of the 2000 Hydrogen Program Review 2000
- Ogden, J.M. Review of small stationary reformers for hydrogen production Princeton University Princeton
- Shudo, T. Ono, Y. Takahashi, T. Influence of hydrogen and carbon monoxide on HCCI combustion of dimethyl ether SAE Paper, 2002-01-2828 2002
- Shudo, T. Ono, Y. Takahashi, T. Ignition control by DME-reformed gas in HCCI combustion of DME SAE Paper, 2003-01-1824 2003
- Shudo, T. An HCCI combustion engine system using on-board reformed gases of methanol with waste heat recovery: ignition control by hydrogen International Journal of Vehicle Design 41 206 225 2006
- Peucheret, S. Wyszynski, M.L. Exhuast Gas Reforming of methane to aid natural gas HCCI combustion: Experimental results of open loop hydrogen production and basic thermodynamic analysis 7th Biennial Conference on Engineering Systems Design and Analysis Manchester, UK 2004
- Peucheret, S. Wyszynski, M.L. Lehrle, R.S. Golunski, S. Xuc, H. Use of catalytic reforming to aid natural gas HCCI combustion in engines: experimental and modelling results of open-loop fuel reforming International Journal of Hydrogen Energy 30 1583 1594 2005
- Yap, D. Megaritis, A. Peucheret, S. Wyszynski, M.L. Xu, H. Effect of hydrogen addition on natural gas HCCI combustion SAE Paper, 2004-01-1972 2004
- Yap, D. Peucheret, S.M. Megaritis, A. Wyszynski, M.L. Xu, H. Natural gas HCCI engine operation with exhaust gas fuel reforming International Journal of Hydrogen Energy 31 587 595 2006
- Xu, H. Wyszynski, M.L. Megaritis, A. Yap, D. Wilson, T. Qiao, J. Richardson, S. Golunski, S. Peucheret, S. Research on expansion of operating windows of controlled homogeneous auto-ignition engines International Journal of Engine Research 8 1 29 40 2007
- Eng, J.A. Leppard, W.R. Sloane, T.M. The effect of POx on the autoignition chemistry of n- heptane and isooctane in an HCCI engine SAE Paper, 2002-01-2861 2002
- Hosseini, V. Checkel, M.D. Using Reformer Gas to Enhance HCCI Combustion of CNG in a CFR Engine SAE Paper, 2006-01-3247 2006
- Hosseini, V. Checkel, M.D. Effect of Reformer Gas on HCCI Combustion- Part I: High Octane Fuels SAE Paper, 2007-01-0208 2007
- Hosseini, V. Checkel, M.D. Effect of Reformer Gas on HCCI Combustion- Part II: Low Octane Fuels SAE Paper, 2007-01-0206 2007
- Hosseini, V. Checkel, M.D. Intake pressure effect on HCCI combustion in a CFR engine Combustion Institute/Canadian Section, Spring technical meeting Banff, Alberta,Canada 2007
- Mueller, C.J. The Quantification of Mixture Stoichiometry When Fuel Molecules Contain Oxidizer Elements or Oxidizer Molecules Contain Fuel Elements SAE Paper, 2005-01-3705 2005
- Heywood, J.B. Internal Combustion Engine Fundamentals McGraw-Hill, Inc. 1988
- Kongsereeparp, P. Kashani, B. Checkel, M.D. A stand-alone multi-zone model for combustion in HCCI engines Fall Technical Conference of the ASME Internal Combustion Engine Division Ottawa, Canada 2005
- Kongsereeparp, P. Checkel, M.D. Novel Method of Setting Initial Conditions for Multi-zone HCCI Combustion Modeling SAE Paper, 2007-01-0674 2007
- Kongsereeparp, P. Checkel, M.D. Investigating the Effects of Reformed Fuel Blending in a Methane- or n-Heptane-HCCI Engine Using a Multi-Zone Model SAE Paper, 2007-01-0205 2007
- Shudo, T. Takahashi, T. Influence of reformed gas composition on HCCI combustion of onboard methanol-reformed gases SAE Paper, 2004-01-1908 2004
- Shudo, T. Yamada, H. Hydrogen as an ignition-controlling agent for HCCI combustion engine by suppressing the low-temperature oxidation International Journal of Hydrogen Energy International Conference on Materials for Hydrogen Energy: Solar Hydrogen (ICMHE 2004) 32 14 3066 3072 2007
- Golovichev, V. Semi-reduced n-Heptane autoignition mechanisms Chalmers Institute of Technology Sweden http://www.tfd.chalmers.se/∼ valeri/MECH.html February 2007
- Subramanian, G. Da Cruz, A.P. Bounaceur, R. Vervisch, L. Chemical impact of CO and H2 addition on the auto-ignition delay of homogenous n-Heptane/air mixtures Combustion Science and Technology 179 9 1937 1962 2007