This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Control of the Start/Stop of a Diesel Engine in a Parallel HEV with a Belted Starter/Alternator
Technical Paper
2007-24-0076
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The matching of a starter alternator and an internal combustion engine is an easily realizable hybrid electric vehicle (HEV) configuration to achieve significant fuel economy savings in urban driving. Many examples are found today in production or near-production gasoline hybrid vehicles, with implementation through either belted starter/alternators or integrated starter/alternators. One of the key factors in the successful implementation of the starter alternator technology is the ability to start and stop the engine quickly and smoothly, without compromising the Noise, Vibration and Harshness (NVH) vehicle signature. This issue becomes even more critical in case of Diesel hybrids, as the peak compression torque is much larger than any Spark Ignition (SI) engine.
The paper presents modeling and experimental results on a recent production, 1.9l Common-Rail Diesel engine belt-coupled to a 10.6kW permanent magnet motor. A model of the Diesel engine dynamics, estimating the instantaneous torque and speed, was developed and identified with experimental data from an engine and BSA system implemented in a midsize prototype SUV. The validated model is then used to design a closed loop controller for starting and stopping the engine following a prescribed speed trajectory.
Recommended Content
Authors
- M. Canova - Center for Automotive Research (CAR), The Ohio State University, USA
- K. Sevel - Center for Automotive Research (CAR), The Ohio State University, USA
- Y. Guezennec - Center for Automotive Research (CAR), The Ohio State University, USA
- S. Yurkovich - Center for Automotive Research (CAR), The Ohio State University, USA
Topic
Citation
Canova, M., Sevel, K., Guezennec, Y., and Yurkovich, S., "Control of the Start/Stop of a Diesel Engine in a Parallel HEV with a Belted Starter/Alternator," SAE Technical Paper 2007-24-0076, 2007, https://doi.org/10.4271/2007-24-0076.Also In
References
- Jaybalan R. Emadi A. “ Acceleration Support by Integrated Starter/Alternator for Automotive Applications ” Journal of Automobile Engineering 218 9 2004
- Schmidt M. Isermann R. Lenzen B. Hohenberg G. “ Potential of Regenerative Braking Using an Integrated Starter Alternator ” SAE Technical Paper 2000-01-1020 2000
- Tamai G. Hoang T. Taylor J. Skaggs C. Downs B. “ Saturn Engine Stop-Start System with an Automatic Transmission ” SAE Technical Paper 2001-01-0326 2001
- Kusumi H. Yahi K. Ny Y. Abo S. “ 42v Power Control System for Mild Hybrid Vehicle (MHV) ” SAE Technical Paper 2002-01-0519 2002
- Kuang M. “ An Investigation of Engine Start-Stop NVH in a Power Split Powertrain Hybrid Electric Vehicle ” SAE Technical Paper 2006-01-1500 2006
- Canova M. Sevel K. Guezennec Y. Yurkovich S. “ Control of the Start/Stop of a Diesel Engine in a Parallel HEV: Modeling and Experiments ” Proceeding of the ASME International Mechanical Engineering Congress and Exposition 2006
- Heywood J. “ Internal Combustion Engine Fundamentals ” McGraw-Hill 1988
- Watson N. Janota M. “ Turbocharging the Internal Combustion Engine ” McMillan Press 1982
- Liu H. Chalhoub N. Henein N. “ Simulation of a Single Cylinder Diesel Engine Under Cold Start Conditions Using Simulink ” ASME Journal of Engineering for Gas Turbines and Power 123 2001
- Filipi Z. Assanis D. “ A Nonlinear, Transient, Single Cylinder Diesel Engine Simulation for Predictions of Instantaneous Engine Speed and Torque ” ASME Journal of Engineering for Gas Turbines and Power 123 2001
- Zweiri Y. Whidborne J. Seneviratne L. “ Detailed Analytical Model of a Single Cylinder Diesel Engine in the Crank Angle Domain ” Journal of Automobile Engineering 215 11 2001
- Moskwa J. Wang W. Bucheger D. “ A New Methodology for Use in Engine Diagnostics and Control, Utilizing “Synthetic” Engine Variables: Theoretical and Experimental Results ” ASME Journal of Dynamic Systems, Measurement and Control 123 2001
- Canova M. Garcin R. Midlam-Mohler S. Guezennec Y. Rizzoni G. “ A Control-Oriented Model of Combustion Process in a HCCI Diesel Engine ” Proceedings of the IEEE American Control Conference 2005
- Woschni G. “ Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion engine ” SAE Technical Paper 670931 1967
- Chen S. Flynn P. “Development of Single Cylinder Compression Ignition Research Engine” SAE Technical Paper 650733 1965
- Davis R. Lorenz R. “ Engine Torque Ripple Cancellation with an Integrated Starter Alternator in a Hybrid Electric Vehicle: Implementation and Control ” IEEE Transactions on Industry Applications 39 6 2003