This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Feasibility Demonstration of a Solid Oxide Electrolyzer with an Embedded Sabatier Reactor for Oxygen Regeneration
Technical Paper
2007-01-3158
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Solid Oxide Electrolysis (SOE) with an embedded Sabatier reactor is an innovative and efficient concept for regenerative air revitalization. The concept safely eliminates handling of hydrogen, and works regardless of gravity and pressure environments with no moving parts and no multi-phase flows. It also is efficient because it requires no expendables from Earth while being compact with minimal impact on mass. The consequence is significant because SOE is an inherently suitable technology (and possibly the only technology) for enabling 100% oxygen regeneration from carbon dioxide and water vapor, two byproducts of crew activity that must be managed. To investigate the feasibility of this concept, a Sabatier reactor was successfully embedded into a single SOE cell. Experiments were conducted by inputting into the cell a mixture of CO2, water vapor, CO and hydrogen in ratios indicative of a pre-electrolyzed stream of metabolically produced byproducts (CO2 and H2 O) of nominal crew activity. The cell successfully produced methane in both Sabatier and electrolysis modes. Further, results suggest that, depending upon flow rate, methane production can be increased if simultaneous electrolysis is performed in the embedded Sabatier reactor. Finally, results suggest that the electrolysis performance of the embedded Sabatier reactor achieves the same magnitude of common SOE cells.
Recommended Content
Authors
Citation
Iacomini, C., Lund, L., and MacCallum, T., "Feasibility Demonstration of a Solid Oxide Electrolyzer with an Embedded Sabatier Reactor for Oxygen Regeneration," SAE Technical Paper 2007-01-3158, 2007, https://doi.org/10.4271/2007-01-3158.Also In
References
- Iacomini, C. Sridhar, K. R. “Electrolyzer Power Requirements for Oxidizer Production On Mars” AIAA Paper 2004-1334, 42nd AIAA Aerospace Sciences Meeting and Exhibit Reno, NV 2004
- Lin, C. H. Duffield, B. E. Hanford, A. J. Lange, K. E. “Advanced Life Support Requirements Document” Doc. # JSC-38571C / CTSD-ADV-245C February 2003
- Sullivan, T. A. Linne, D. Bryant, L. Kennedy, K. “In-Situ-Produced Methane and Methane/Carbon Monoxide Mixtures for Return Propulsion from Mars” Journal of Propulsion and Power 11 5 September - October 1995 1056 1062
- Wieland, P. O. “Living Together in Space: The Design and Operation of the Life Support Systems on the International Space Station” 1 NASA MSFC January 1998
- Iacomini, C. S. “Combined H 2 O/CO 2 Solid Oxide Electrolysis” Ph.D. Dissertation Aerospace and Mechanical Engineering Department, The University of Arizona Tucson, AZ 2004