This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Critical Review of Different Experimental Approaches to Calibrate Numerical Sheet Forming Simulations
Technical Paper
2007-01-1685
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The calibration of yield functions for numerical sheet forming simulations is done using different experimental approaches such as the uniaxial tensile test, the bulge test, etc. How accurately the material behavior of dedicated aluminum, conventional and high strengths steel grades subjected to various loading conditions can be modeled is investigated using e.g. uniaxial tensile test data only. Different formulations of yield functions that are widely used in industry (e.g. Hill'48, Hosford'79, Hill'90) are considered. It is shown that tensile test data is insufficient to successfully calibrate yield functions for numerical sheet forming simulations especially for aluminum and pronounced anisotropic steel. The use of improved formulations of yield functions is emphasized.
Recommended Content
Authors
Citation
Ofenheimer, A., Kitting, D., Iadicola, M., and Foecke, T., "A Critical Review of Different Experimental Approaches to Calibrate Numerical Sheet Forming Simulations," SAE Technical Paper 2007-01-1685, 2007, https://doi.org/10.4271/2007-01-1685.Also In
Steel Innovations, Fatigue Research, Sheet/Hydro/Gas Forming Technology & Advanced High Strength Steel Development
Number: SP-2103; Published: 2007-04-16
Number: SP-2103; Published: 2007-04-16
References
- Keemola, H.J. Ranta-Eskola, A.J. “Comparison of the strain hardening parameters of sheet metals in uniaxial and biaxial tension” Metallurgical Trans. A 7A 1976 595 599
- Foecke, T. Iadicola, M. A. Lin, A. Banovic, S. W. “A method for direct measurement of multiaxial stress-strain curves in sheet metal” Metallurgical and Materials Trans. A (In press)
- Marciniak, Z. Kuczynski, K. “Limit strains in the processes of stretch-forming sheet metal” Int. J. of Mech. Sci. 9 1967 609 620
- Mises v, R. “Mechanik der plastischen Formänderungen von Kristallen” Nachr. Königl. Ges. Wiss. Göttingen, Math.-phys. Kl 1913 582 592
- Vegter, H. Horn, C. An, Y. Atzema, E. Pijlman, H. Boogaard van den, T. Huétink, H. “Characterisation and modeling of the plastic material behaviour and its application in sheet metal forming simulation” 7 th Int. Conf. on Computational Plasticity Barcelona 2003
- Hill, R. “A theory of the yielding and plastic flow of anisotropic metals” Proc of Roy. Soc. London A 193 1948 281 291
- Hill, R. “Constitutive modeling of orthotropic plasticity in sheet metals” J. Mech. Phys. Solids 38 1990 405 417
- Hosford, W. F. “On yield loci of anisotropic cubic metals” 7th North American Metalworking Conference (NMRC) 1979 Dearborn MI 1979 191 197
- Wagoner, R.H. “Measurement and analysis of plane-strain work hardening” Met. Trans A 11 1980 165 175
- Lin, S.B. Ding, J.L. “Experimental study of the plastic yielding of rolled sheet metals with the cruciform plate specimen” Int. J. Pla. 11 5 1995 583 604