This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Optimization of Position Where In-Vehicle Reception Antenna is Set Up
Technical Paper
2007-01-0362
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Studies on setting a 300MHz band reception antenna have been made. A center panel was determined as a setting position based on measurement results of the reception level. A method of analyzing actuator noise which is a problem in setting the position of the center panel, and the solution thereof will be reported.
Recommended Content
Technical Paper | A Case Study on Road Noise Source Identification and Reduction Measures in a Compact SUV |
Technical Paper | CAE-based Design of Active Noise Control Solutions |
Technical Paper | Power Electronic Noise-Simulation Measurement Comparison |
Authors
Citation
Ishiko, S., Kamemura, A., and Sasamoto, T., "Optimization of Position Where In-Vehicle Reception Antenna is Set Up," SAE Technical Paper 2007-01-0362, 2007, https://doi.org/10.4271/2007-01-0362.Also In
References
- Kaoru Gotoh Shinobu Ishigami Yasushi Matsumoto Takashi Shinozuka Yukio Yamanaka “4-1 Measurement of interference electromagnetic wave width probability distribution and protection of digital wireless communication” Seasonal report of National Institute of Information and Communication Technology 52 1 2006
- Kazama “Proposal of new design methods against electromagnetic noise in EMC measures for wireless devices” Nikkei Electronics Feb 13 2006 919 115 122
- Gotoh K. et al. “APD Measurement for Evaluating Disturbances Related to the Performance of Digital Communication System” IEICE Transactions on communication 88 8 3235 3241 Aug 2005