This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
New Design Formula for Bolted Joints under Tensile Loads
Technical Paper
2006-01-0989
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
A new method for estimating the value of the load factor (the ratio of the additional bolt force to the load) is proposed by introducing the spring constant kpt . The value of kpt is analyzed by using an axisymmetric theory of elasticity. For verification of the proposed method, experiments were carried out to measure the load factor. A fairly good agreement is seen between the analytical and the experimental results. The effects of some factors on the load factor were discussed.
Recommended Content
Citation
Sawa, T., "New Design Formula for Bolted Joints under Tensile Loads," SAE Technical Paper 2006-01-0989, 2006, https://doi.org/10.4271/2006-01-0989.Also In
References
- Bickford John H. “An introduction to the design and behavior of bolted joints” Marcel Dekker New York 1981 43
- Sawa, T. Maruyama, K. Bulletin of the JSME 19 128 1976-2 203
- Shibahara, M. Oda, J. Jour. Japan Soc. Mech. Engrs. (in Japanese) 72 611 1969-12 9
- Thum, A. Debus, F. Steigigkeit und Dauerhaltbarkeit von Schrauben-verbindungen 1935 Springer
- Junker, G.H. Draht-Welt 50 8 1964-8 527
- Kryachikin 47 12 1962 27
- Shibahara, M. Oda, J. Trans. Japan Soc. Mech. Engrs. (in Japanese) 34 259 1968-3 388
- Gould, H. et al Trans. ASME 94-B-3 1972-8 864