This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
An Experimental Study of Active Regeneration of an Advanced Catalyzed Particulate Filter by Diesel Fuel Injection Upstream of an Oxidation Catalyst
Technical Paper
2006-01-0879
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Passive regeneration (oxidation of particulate matter without using an external energy source) of particulate filters in combination with active regeneration is necessary for low load engine operating conditions. For low load conditions, the exhaust gas temperatures are less than 250°C and the PM oxidation rate due to passive regeneration is less than the PM accumulation rate. The objective of this research was to experimentally investigate active regeneration of a catalyzed particulate filter (CPF) using diesel fuel injection in the exhaust gas after the turbocharger and before a diesel oxidation catalyst (DOC) and to collect data for extending the MTU 1-D 2-layer model to include the simulation of active regeneration.
The engine used in this study was a 2002 Cummins ISM turbo charged 10.8 L heavy duty diesel engine with cooled EGR. The exhaust after-treatment system consisted of a Johnson Matthey DOC and CPF (a CCRT®). Steady-state loading experiments at 20% load at rated speed were performed for different times in order to achieve three particulate matter loadings of 1.1, 2.2 and 4.1 grams of particulate/liter of filter. Active regeneration was carried out at three CPF-inlet temperatures of 500, 550 and 600°C to cover a range of temperatures and filter loadings for thermal regeneration.
The dependent data of fuel usage, time of regeneration, mass of PM oxidized and maximum substrate temperature are presented as a function of mass loading and inlet CPF temperature. The results show that higher CPF-inlet temperature and particulate matter mass loading are more effective for regeneration of the CPF and lower fuel usage in grams of PM oxidized per gallon of fuel used whereas low temperatures and lower mass loadings were not as effective due to lower reaction rates. 90% of the HC from the diesel fuel injection were oxidized across the DOC while the other 10% were oxidized across the CPF under the test conditions.
Recommended Content
Technical Paper | Diesel Exhaust Particle Size Distributions - Fuel and Additive Effects |
Technical Paper | The Influence of Speciated Diesel Fuel Composition on Speciated Particulate SOF Emissions |
Authors
Topic
Citation
Singh, P., Thalagavara, A., Naber, J., Johnson, J. et al., "An Experimental Study of Active Regeneration of an Advanced Catalyzed Particulate Filter by Diesel Fuel Injection Upstream of an Oxidation Catalyst," SAE Technical Paper 2006-01-0879, 2006, https://doi.org/10.4271/2006-01-0879.Also In
References
- http://www.dieselnet.com/standards/us/hd.html
- Pattas K. Kyriakis N. Samaras Z. Mustel W. Rouveirolles P. “The Effect of Size and Positioning of Ceramic DPFs on the Regeneration Induced by a Cerium Based Additive” SAE 970184 1997
- Hiranuma Satoshi Takeda Yoshinaka Kawatani Toru Doumeki Reiko Nagasaki Kazuhiro Ikeda Tatsuya “Development of DPF System for Commercial Vehicle - Basic Characteristic and Active Regenerating Performance” SAE Paper 2003-01-3182 2003
- Matthias Bouchez Dementhon Jean Baptise “Strategies for the Control of Particulate Trap Regeneration” SAE 2000-01-0472 2000
- Singh Nishant Johnson John H. Parker Gordon G. Yang Song-Lin “Vehicle Engine Aftertreatment System Simulation (VEASS) Model: Application to a Controls Design Strategy for Active Regeneration of a Catalyzed Particulate Filter” SAE Paper 2005-01-0970 2005
- Mohammed Hasan Lakkireddy Venkata R. Johnson John H. Bagley Susan T. “An Experimental and Modeling Study of a Diesel Oxidation Catalyst and a Catalyzed Diesel Particulate Filter Using a 1-D 2-Layer Model” SAE Paper 2006-01-0466 2006
- Lakkireddy Venkata R. Hasan Mohammed Johnson John H. Bagley Susan T “The Effect of a Diesel Oxidation Catalyst and a Catalyzed Particulate Filter on the Emissions from a Heavy Duty Diesel Engine” SAE Paper 2006-01-0875 2006
- Lakkireddy Venkata R. Hasan Mohammad Johnson John H. “The Effect of a Diesel Oxidation Catalyst and a Catalyzed Particulate Filter on Particle Size Distribution from a Heavy Duty Diesel Engine” SAE Paper 2006-01-0877 2006
- Noirot R. Gilot P. Gadiou R. Prado G. “Control of Soot Emission by Filtration and Post-Combustion. A Laboratory Study of the Regeneration of an Organic Particulate Trap Assisted by Hydrocarbon Injection” Combustion Science and Technology 95 139 160 1994
- Gou Gang Xu Ning Laing Paul M. Hammerle Robert H. Maricq M. Matti “Performance of a catalyzed Diesel Particulate Filter System during Soot Accumulation and Regeneration” SAE 2003-01-0047 2003
- Allansson R. Blakeman Philip G. Cooper Barry J. Hess Howard Silcock Peter J. Walker Andrew P. “Optimizing the Low Temperature Performance and Regeneration Efficiency of the Continuously Regenerating Diesel Particulate Filter (CR-DPF) System” SAE Paper 2002-01-0428 2000
- Nakane T. Ikeda M. Hori M. Bailey O. Mussmann L. “Investigation of the Aging Behavior of Oxidation Catalysts Developed for Active DPF Regeneration Systems” SAE Paper 2005-01-1759 2005
- Yaws Carl L. “Chemical Properties Handbook: Physical, Thermodynamic, Environmental, Transport, Safety and Health related Properties for Organic and Inorganic Materials” 1999
- Daubert, T.E. Danner R.P. Sibul H.M. Stebbins C.C. “Physical and Thermodynamic Properties of Pure Chemicals” Design Institute for Physical Property Data, AICE Taylor and Francis Publication 1995
- Devore Jay Farnum Nicholas “Applied Statistics for Engineers and Scientists” Textbook 395 1999