This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Effect of a Diesel Oxidation Catalyst and a Catalyzed Particulate Filter on Particle Size Distribution from a Heavy Duty Diesel Engine
Technical Paper
2006-01-0877
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The effect of a Johnson Matthey catalyzed continuously regenerating technology™ (CCRT®) filter on the particle size distribution in the raw exhaust from a 2002 Cummins ISM-2002 heavy duty diesel engine (HDDE) is reported at four loads. A CCRT® (henceforth called DOC-CPF) has a diesel oxidation catalyst (DOC) upstream (UP) of a catalyzed particulate filter (CPF). The particle size data were taken at three locations of UP DOC, downstream (DN) DOC and DN CPF in the raw exhaust in order to study the individual effect of the DOC and the CPF of the DOC-CPF on the particle size distribution. The four loads of 20, 40, 60 and 75% loads at rated speed were chosen for this study. Emissions measurements were made in the raw exhaust chosen to study the effect of nitrogen dioxide and temperature on particulate matter (PM) oxidation in the CPF at different engine conditions, exhaust and carbonaceous particulate matter (CPM) flow rates. This data was used for calibrating the MTU 1-D 2-layer filter model. Further results from these tests are reported in Reference [1]. Results for both particle number and volume concentrations in nuclei and accumulation-mode particles are discussed in this paper. The DOC had a small effect on the particle number and volume concentrations but the CPF or the DOC-CPF reduced the particle number and volume concentrations by two orders of magnitude. The CPF had higher filtration efficiency for accumulation-mode particles while the DOC had similar effect on nuclei and accumulation-mode particles. As expected, the filtration efficiency of the CPF increases with time during the deep bed filtration due to the blocking of the pores in the wall and is nearly constant for later times during the cake filtration period.
Recommended Content
Authors
Topic
Citation
Lakkireddy, V., Mohammed, H., and Johnson, J., "The Effect of a Diesel Oxidation Catalyst and a Catalyzed Particulate Filter on Particle Size Distribution from a Heavy Duty Diesel Engine," SAE Technical Paper 2006-01-0877, 2006, https://doi.org/10.4271/2006-01-0877.Also In
References
- Mohammed, H Lakkireddy, V R Johnson, J H Bagley, S T “An Experimental and Modeling Study of a Diesel Oxidation Catalyst and a Catalyzed Diesel Particulate Filter Using a 1-D 2-Layer Model” SAE, 2006-01-0466
- DieselNet Technology Guide http://www.dieselnet.com/tg.html
- Kittelson, D B “Engines and Nanoparticles: A Review” Journal of Aerosol Science 29 5-6 Jun-Jul 1998 575 588
- Baumgard K J Johnson, J H “The Effect of Fuel and Engine Design on Diesel Exhaust Particle Size Distributions” SAE 960131 1996
- Warner, J R Huynh, C T Janakiraman, G Johnson, J H Bagley, S T “Oxidation Catalytic Converter and Emulsified Fuel Effects on Heavy-Duty Diesel Engine Particulate Matter Emissions” SAE 2002-01-1278 2002
- Abdul-Khalek, I S Kittelson, D B Graskow, B R Wei, Q Brear, F “Diesel Exhaust Particle Size: Measurement Issues and Trends” SAE 980525 1998
- Heywood, J B “Internal Combustion Engine Fundamentals” McGraw-Hill New York 1988
- Kittelson, D B Johnson, J H “Variability in Particle Emission Measurements in the Heavy-Duty Transient Test” SAE 910738 1991
- Lakkireddy, V R Mohammed, H Johnson, J H Bagley, S T “The Effect of a Diesel Oxidation Catalyst and a Catalyzed Particulate Filter on the Emissions from a Heavy Duty Diesel Engine” SAE 2006-01-0875 2006
- Konstandopoulos, A G “An Experimental and Theoretical Study of Ceramic Monolith Traps in Conjunction with a Manganese-Copper Fuel Additive for Diesel Particulate Emissions Control” MTU 1987
- Wiczynski, P D “A Study of the Effect of Engine Load and a Porous Ceramic Particulate Trap on the Hydrocarbons and the Particle Size Distributions within Diesel Engine Exhaust” MTU 1985
- Baumgard, K J “The Effect Of Fuel And Engine Design On Diesel Exhaust Particle Size Distributions” MTU 1995
- Abdul-Khalek, I S Kittelson, D B Brear, F “Diesel Trap Performance: Particle Size Measurements and Trends” SAE 982599 1998