This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Thermal Studies in the Exhaust Manifold of a Turbocharged V6 Diesel Engine Operating Under Steady-State Conditions
Technical Paper
2006-01-0688
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This study employs experimental and computational methods to investigate the thermal state of the exhaust manifold of a multi-cylinder turbocharged diesel engine operating under steady-state conditions. The local skin temperatures and surface heat fluxes varied significantly throughout the external surface of the manifold. The augmentation of the local heat flux with increasing load and engine speed may be represented solely by the increase in the fuel mass flow rate. The results of the 1D simulation are in good agreement with the measurements of the exit gas temperatures, skin temperatures, and surface heat fluxes.
Recommended Content
Authors
Citation
He, Y., Battiston, P., and Alkidas, A., "Thermal Studies in the Exhaust Manifold of a Turbocharged V6 Diesel Engine Operating Under Steady-State Conditions," SAE Technical Paper 2006-01-0688, 2006, https://doi.org/10.4271/2006-01-0688.Also In
References
- Wendland, D, W. ‘Automobile Exhaust-System Steady-State Heat Transfer,’ Vehicle Thermal Management Alkidas A.C. SAE PT-46, SAE Paper 931085 1993
- Shayler, P. J. Harb, C. M. Ma, T. ‘Time-Dependent Behaviour of Heat Transfer Coefficients for Exhaust Systems,’ VTMS 2 Conference, Paper C496/046/95 195 206 1995
- Imabeppu, S. Shimonosono, H. Yamamoto, S. ‘Analysis of Convective Heat Transfer in the Exhaust System of Gasoline Engines,’ JSAE, Technical Paper # 9638671 1996
- Shimizu, T. Ohtani, M. ‘Numerical Simulation of Heat Transfer and Fluid Flow Applied to Exhaust Manifold,’ JSAE Review 17 17 23 1996
- Noda, Y. Mamiya, N. Hosoya, M. ‘Predicting Thermal Distribution of Exhaust Manifold under Actual Operating Conditions JSAE, Technical Paper # 20015432 (SAE Paper 2001-08-0263) 9 12 2001
- Sachdev, R. ‘An Investigation of Instantaneous Heat Transfer Rates in the Exhaust Port of an Internal Combustion Engine’ Department of Mechanical and Industrial Engineering, University of Illinois Urbana, IL 1981
- Meisner, S. Sorenson, S. C. ‘Computer Simulation of Intake and Exhaust Manifold Flow and Heat Transfer,’ SAE Paper 860242 1986
- Benajes, J. Torregrosa, A. Reyes, M. ‘Heat Transfer Model for I.C. Engine Exhaust Manifolds,’ EUROTHERM 15 189 194 1991
- Rahopoulos, C. D. Mavropoulos, G, C. ‘Experimental Instantaneous Heat Fluxes in the Cylinder Manifold of an Air Cooled Diesel Engine,’ Energy Conversion & Management 41 1265 1281 2000
- Rahopoulos, C. D. Mavropoulos, G, C. Hountalas, D.T. ‘Measurements and Analysis of Load and Speed Effects on the Instantaneous Wall Heat Fluxes in a Direct Injection Air-Cooled Diesel Engine,’ International Journal of Energy Research 24 587 604 2000
- Incropera, F. P. DeWitt, D, P, Fundamentals of Heat and Mass Transfer 2nd 379 398 John Wiley & Sons New York 1985
- Battiston, P. Alkidas, A. C. Kapparos, D. ‘Temperature and Heat Transfer Measurements in the Exhaust System of a Diesel-Powered Light-Duty Vehicle VTMS6 Conference, IMEchE Paper 2003
- Alkidas, A. C. Battiston, P. A. Kapparos, D. J. ‘Thermal Studies in the Exhaust System of a Diesel Powered Light-Duty Vehicle SAE Paper 2004-01-0050 2004
- Gamma Technologies GT-Power User Manual, Version 5.2 December 2001
- Alcock, J. F. Robson, J. B. V. Mash, C. ‘Distribution of Heat Flow in High-Duty Internal Combustion Engines,’ Congr. Int. Mach. Combust. Zurich 723 749 1957
- Brock, E. K. Glasspoole, A. J. ‘The Thermal Loading of Cylinder Heads and Pistons on Medium-Speed Oil Engines,’ Proc Instn Mech. Engrs 179 3 18 1964-65
- French, C. C. J. Hartles, E. R. ‘Engine Temperatures and Heat Flows Under High Load Conditions,’ Proc Instn. Mech. Engrs 179 126 135 1964-65
- French, C. C. J. Norris-Jones, S. ‘Optimisation of Engine Parameters for Operation of Four Cycle Diesel Engines at High Ratings,’ 9 th International Congress of Combustion Engines , Paper A-17 Stockholm 1971
- Alkidas, A. C. ‘Thermal Loading of the Cylinder Head of a Spark-Ignition Engine,’ Heat Transfer Engineering 3 3-4 66 75 1982
- Alkidas, A. C. Cole, R. M. ‘Thermal Loading of the Cylinder Head of a Divided-Chamber Diesel Engine,’ SAE Paper 831325 1983
- Alkidas, A. C. “Effects of Operational Parameters on Structural Temperatures and Coolant Heat Rejection of a S. I. Engine,” SAE Transactions - J. Materials & Manufacturing 102 931124 1119 1134 1993 1993 Vehicle Thermal Management Systems Conference Proceedings 443 458 1993
- White, M. W. Fluid Mechanics McGraw-Hill publishing Co. 308 320 1986
- Fox, R. W. McDonald, A. T. Introduction to Fluid Mechanics 2nd John Wiley & Sons 361 368 1978
- Welty, J.R. Wicks, C. E. Wilson, R. E. Rorrer, G. L. Fundamentals of Momentum, Heat and Mass Transfer John Wiley &Sons, Inc. 183 190 2001
- He, Y. “Development and Validation of a 1D Model of a Turbocharged V6 Diesel Engine under Steady-State and Transient Conditions,” SAE Paper 2005-01-3857 2005
- Buyuktur Selim Private Communication Gamma Technologies 2004
- Caton, J.A. “Comparisons of Thermocouple, Time-Averaged and Mass-Averaged Exhaust Gas Temperatures for a Spark-Ignited Engine,” SAE Paper 820050 1982
- Imabeppu, S. Hirano, Y. Shimonosono, H. ‘An Analysis of Heat Release to the Coolant in the Cylinder Head,’ JSAE Review 11 3 16 22 1990