This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Automatic Model Calibration for Engine-Process Simulation with Heat-Release Prediction
Technical Paper
2006-01-0655
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The development of powertrains with DI diesel Engines as primary drive demands accurate analytic specification of the cylinder process, with sufficient consideration taken of gas-exchange, turbo charging, and - especially - combustion. Until now, engine-process simulation has proved to be a powerful tool for satisfaction of these requirements. In addition to simple modeling of the heat-release rate with Vibe functions, complex heat-release models based on injection-rate profiles have been developed and implemented in existing simulation tools such as GT Power. To calibrate the parameters to achieve satisfactory agreement between experimental data and three-dimensional Computational Reactive Fluid Dynamics Models (CRFD) simulations, an appreciable amount of expertise and time is required.
This paper deals with a universal method that automatically identifies and calibrates the relevant model parameters to the experimental data. This technique simplifies and accelerates the application of engine-process simulation with more accurate heat-release models, which, however, allow heat-release prediction only with certain constraints. This approach allows intensification of the interface between engine-process simulation and combustion-rate development at the test bench or in CRFD simulation.
A comprehensive cylinder process analysis represents the core of this method. It can additionally analyze transient operating points, and offers an algorithm that optimizes the model parameters. Comprehensive cylinder-process analysis provides the following from the plotted cylinder-pressure curve: the reference-input variable, the heat-release rate, as well as required model specific-input variables such as gas composition, cylinder temperature, and thermodynamic gas properties. The optimizer must be able, in stable operation, to optimize a system with many degrees of freedom.
Recommended Content
Authors
Topic
Citation
Friedrich, I., Pucher, H., and Offer, T., "Automatic Model Calibration for Engine-Process Simulation with Heat-Release Prediction," SAE Technical Paper 2006-01-0655, 2006, https://doi.org/10.4271/2006-01-0655.Also In
References
- Woschni, G. Anisits, F. MTZ 34 4 1973
- Oberg, H.-J. 1976
- Schreiner, K. MTZ 54 11 1993
- Urlaub, A. Springer-Verlag Berlin 1994
- Barba, C. 2001
- Chmela, F.G. Orthaber, G.C. Rate of Heat Release Prediction for Direct Injection Diesel Engines Based on Purely Mixing Controlled Combustion SAE 1999-01-0186 1999
- Constien, M. Bestimmung von Einspritz- und Brennverlauf eines direkteinspritzenden Dieselmotors Technische Universität München 1991
- Morel, T. Wahiduzzaman, S. Modeling of Diesel Combustion and Emission FISITA 1996
- Wolfer, H. H. VDI-Verlag Berlin 1938
- Sitkei, G. MTZ 24 6 1963
- Hardenberg, H. Wagner, W. MTZ 32 7 1971
- Friedrich, I. Grigoriadis, P. Pucher, H. Full-cycle thermodynamic analysis - an efficient tool for engine process development Performance and Emissions Conference IMechE London 2004
- Hiroyasu, H. Miao, H. Hiroyasu, T. Miki, M. Kamiura J. Watanabe, S. Reduction of Heavy Duty Diesel Engine Emission and Fuel Economy with Multi-Objective Genetic Algorithm and Phenomenological Model SAE paper 2003-01-1853 2003