This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Measurement and Simulation of Intake Port and In-Cylinder Air Flow of Diesel and Gasoline Engines
Technical Paper
2005-24-072
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Detailed knowledge of in-cylinder flow and directed air charge motion is particularly important for the development and optimization of combustion chamber and intake port design.
This knowledge can be obtained through flow measurement and three-dimensional CFD analysis. Both methods are applied at the Institute for Measurement Technology and Reciprocating Machines at Otto von Guericke University Magdeburg. A unique flow test bench delivers results from three-dimensional flow measurement. The widely used software tool AVL FIRE® is employed for 3D CFD analysis.
This publication presents the results of research projects that employ both methods. The first project is investigating intake valve masking in a gasoline engine with port fuel injection. Attention is focused on the effect of intake valve masking on short-circuit scavenging and the cylinder wall film.
The second project is dealing with the influence of intake port manufacturing tolerances on the in-cylinder flows of a diesel engine and a gasoline engine with direct injection. The primary focus is the directed air charge motion essential for these combustion systems.
Finally, the limitations of and prospects for flow measurement and CFD analysis are summarized.
Recommended Content
Authors
Topic
Citation
Tschöke, D., Naumann, D., and Hartkopf, D., "Measurement and Simulation of Intake Port and In-Cylinder Air Flow of Diesel and Gasoline Engines," SAE Technical Paper 2005-24-072, 2005, https://doi.org/10.4271/2005-24-072.Also In
References
- Pischinger, R. Klell, M. Sams, T. Thermodynamik der Verbrennungskraftmaschine Zweite, überarbeitete Auflage/Der Fahrzeugantrieb Springer-Verlag Vienna 2002
- FIRE Manual April 2000
- Jaros, K. Anemometric Tester 24TV manual
- Müller, C. Einfluss der Oberflächenrauigkeit von Einlasskanälen eines PKW-Dieselmotors auf den Ladungswechsel und die Strömungsausbildung im Zylinder Magdeburg 2004 Diplom thesis Otto von Guericke University
- Tschöke, H. Hieber, D. Raab, F. Hartkopf, L. SULEV-Potenzial FVV Project durch Variabiltät des Einlassventilspaltes No. 790
- Dingel, O. Seidel, T. Schodl, R. Willert, C. Messung der Zylinderinnenströmung mit Doppler Global Velocimetry Haus der Technik 2002
- Chen, H. Simulation des Einflusses der Kanalrauigkeiten und–lageabweichungen auf die Diplom thesis Otto von Guericke University Magdeburg 2005
- Tschöke, H. Blodig, G. Schmidt, M. Einfluss der Mikro- und Makrogeometrie von Kanälen im Zylinderkopf unter besonderer Berücksichtigung von Gemischbildung und Motorkühlung Research project INNOREGIO/MAHREG Automotive Otto von Guericke University Magdeburg 2004