This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Lean Boost and External Exhaust Gas Recirculation for High Load Controlled Auto-Ignition
Technical Paper
2005-01-3744
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This work was concerned with increasing the attainable load during gasoline controlled auto-ignition combustion in a multi-cylinder direct fuel injection research engine. To extend the peak output under naturally aspirated conditions it proved favourable to combine internal and external exhaust gas recirculation under stoichiometric fuelled conditions. During turbocharged high load operation it was beneficial in terms of fuel economy to dilute the charge with a combination of internally re-circulated exhaust gases and excess air. Replacing a proportion of these diluents with externally re-circulated burned gases appeared to facilitate lower emissions of HC and CO. The highest load generated via boost was limited by increasing peak in-cylinder pressure and falling gas exchange efficiency. Regardless, the use of boost increased the load at which CAI could be invoked without lean NOx after-treatment.
Recommended Content
Topic
Citation
Cairns, A. and Blaxill, H., "Lean Boost and External Exhaust Gas Recirculation for High Load Controlled Auto-Ignition," SAE Technical Paper 2005-01-3744, 2005, https://doi.org/10.4271/2005-01-3744.Also In
References
- Onishi, S., Jo, S.H., Shoda, K., Jo, P.D. and Kato, S.: “Active Thermo-Atmosphere Combustion (ATAC) - A New Combustion Process for Internal Combustion Engines”, SAE Paper No. 790501, (1979).
- Noguchi, M., Tanaka, Y., Tanako, T. and Takeuchi, Y.: “A Study on Gasoline Engine Combustion by Observation of Intermediate Reactive Products During Combustion”, SAE Paper No. 790840, (1979).
- Najt, P. and Foster, D.E.: “Compression-Ignited Homogeneous Charge Combustion”, SAE Paper No. 830264, (1983).
- Thring, R.H.: “Homogeneous-Charge Compression Ignition (HCCI) Engines”, SAE Paper No. 892068, (1989).
- Hultqvist, A., Christensen, M. and Johansson, B.: “The Heterogeneous Combustion Process in an HCCI Engine”, Proceedings of the IFP International Congress 2001, p.p. 55-68, (2001).
- Stanglmaier, R.H., Ryan, T.W. and Mehta, D.: “Fuel Introduction Strategies for Pre-Mixed Compression Ignition Combustion”, Proceedings of the IFP International Congress 2001, p.p. 69-76, (2001).
- Olsson, J-O., Tunestal, P., Johansson, B., Fiveland, S., Agama, R., Willi, M. and Assanis, D.: “Compression Ratio Influence on Maximum Load of a Natural Gas Fueled HCCI Engine”, SAE Paper No. 2002-01-0111, (2002).
- Christensen, M., Hultqvist, A. and Johansson, B.: “Demonstrating the Multi Fuel Capability of a Homogeneous Charge Compression Ignition Engine with Variable Compression Ratio”, SAE Paper No. 1999-01-3679, (1999).
- Hyvonen, J., Haraldsson, G. and Johansson, B.: “Balancing Cylinder-to-Cylinder Variations in a Multi-Cylinder VCR-HCCI Engine”, SAE Paper No. 2004-01-1897, (2004).
- Phlips, P., Law, D., Eade, D., Wirth, M. and Schamel, A.: “Mixing processes between Fresh and Residual Gas in Gasoline HCCI engines - Simulation and Multi-cylinder Application”, 20.Internationale VDI/VW-Gemeinschaftstagung Kraftstoffe und Antriebe der Zunkunft Wolfsburg, (2003).
- Thirouard, B., Cherel, J. and Knop, V.: “Investigation of Mixture Quality Effect on CAI Combustion”, SAE Paper NO. 2005-01-0141, (2005).
- Lavy, J., Dabadie, J.C., Angelberger, C., Duret, P., Willand, J., Juretzka, A., Schaflein, J., Ma, T., Lendresse, Y., Satre, A., Schulz, C., Kramer, H., Zhao, H. and Damiano, L.: “Innovative Ultra-low NOx Controlled Auto-Ignition Combustion Process for Gasoline Engines: the 4-SPACE Project”, SAE Paper No. 2000-01-1837, (2000).
- Law, D., Allen, J., Kemp, D. and Williams, P.: “4-Stroke Controlled Auto Ignition Investigations Using a Single Cylinder Engine With Lotus Active Valve Train (AVT)”, Proceedings of the 21st century Emissions Technology Conference, IMechE Paper No. C588/006/2000, (2000).
- Kontarakis, G., Collings, N. and Ma, T.: “Demonstration of HCCI Using a Single Cylinder Four-stroke SI Engine with Modified Valve Timing”, SAE Paper No. 2000-01-2870, (2000).
- Ma, T., Zhao, H., Li, J. and Ladommatos, N.: “Experimental Investigation of Controlled Auto-Ignition (CAI) Combustion in a 4-Stroke Multi-Cylinder Gasoline Engine and Drive Cycle Simulations”, Proceedings of the IFP International Congress 2001, p.p. 115-124, (2001).
- Fuerhapter, A., Piock, W.F. and Fraidl, G.K.: “CSI - Controlled Auto Ignition - the Best Solution for the Fuel Consumption - Versus Emission Trade-Off?”, SAE Paper No.2003-01-0754, (2003).
- Wolters, P., Salber, W., Geiger, J., Duesmann, M. and Dilthey, J.: “Controlled Auto Ignition Combustion Process with an Electromechanical Valve Train”, SAE Paper No. 2003-01-0032, (2003).
- Cairns, A. and Blaxill, H.: “The Effects of Combined Internal and External Exhaust Gas Re-Circulation on Gasoline Controlled Auto-Ignition”, SAE Paper No. 2005-01-0133, (2005).
- Urata, Y., Awasaka, M., Takanashi, J., Kakinuma, T., Hakozaki, T. and Umemoto, A.: “A Study of Gasoline-fuelled HCCI Engine Equipped with an Electromagnetic Valve Train”, SAE Paper NO. 2004-01-1898, (2004).
- Dec, J. E. and Sjöberg, M.: “A Parametric Study of HCCI Combustion - the Sources of Emissions at Low Loads and the Effects of GDI Fuel Injection”, SAE Paper No. 2003-01-0752, (2003).
- Standing, R., Kalian, N., Ma, T., Zhao, H., Wirth, M. and Schamel, A.: “Effects of Injection Timing and Valve Timings on CAI Operation in a Multi-Cylinder DI Gasoline Engine”, SAE Paper No. 2005-01-0132, (2005).
- Salber, W., Pischinger, S., Lang, O., Krebber-Hortmann, K., Bucker, C. and Hann, J.: “Thermodynamical and Mechanical Approach Towards a Variable Valve Train for the Controlled Auto Ignition Combustion Process”, SAE Paper No. 2005-01-0762, (2005).
- Urushihara, T., Hiraya, K., Kakuhou, A. and Itoh, T.: “Expansion of HCCI Operating Region by the Combination of Direct Fuel Injection, Negative Valve Overlap and Internal Fuel Reformation”, SAE Paper No. 2003-01-0749, (2003).
- Christensen, M., Johansson, B., AmnJus, P. and Mauss, F.: “Supercharged Homogeneous Charge Compression Ignition”, SAE Paper No. 980787, (1998).
- Olsson, J-O., Tunestal, P. and Johansson, B.: “Boosting for High Load HCCI”, SAE Paper No. 2004-01-0940, (2004).
- Haraldsson, G., Tunestal, P., Johansson, B. and Hyvonen, J.: “HCCI Combustion Phasing with Closed-Loop Combustion Control Using Variable Compression Ratio in a Multi Cylinder Engine”, SAE Paper No. 2003-01-1830, (2003).
- Urushihara, T., Yamaguchi, K., Yoshizawa, K. and Itoh, T.: “A Study of Gasoline-fueled Compression Ignition Engine - Expansion of HCCI Operation Range Using SI Combustion as a Trigger of Compression Ignition”, SAE Paper No. 2005-01-0180, (2005)
- Osborne, R.J., Li, G., Sapsford, S.M., Stokes, J., Lake, T.H. and Heikal, M.R.: “Evaluation of HCCI for Future Gasoline Powertrains”, SAE Paper No. 2003-01-0750, (2003).
- Milovanovic, N., Blundell, D., Pearson, R. and Turner, J.: “Enlarging the Operational Range of a Gasoline HCCI Engine by Controlling the Coolant Temperature, SAE Paper No. 2005-01-0157, (2005).
- Jeuland, N., Montagne, X. and Duret, P.: “Engine and Fuel Related Issues of Gasoline CAI (Controlled Auto-Ignition) Combustion”, SAE Paper No. 2003-01-1856, (2003).
- Yap, D., Megaritis, A., Peucheret, S., Wyszynski, M. and Xu, H.: “Effect of hydrogen addition on natural gas HCCI combustion”, SAE Paper No. 2004-01-1972, (2004).
- Stenlaas, O., Christensen, M., Egnell, R., Tunestal, P., Johansson, B. and Mauss, F.: “Reformed Methanol Gas as Homogeneous Charge Compression Ignition Engine Fuel”, SAE Paper No. 2004-01-2991, (2004).
- Risberg, P., Kalghatgi, G. and Angstrom, H-E., “The Influence of EGR on Auto-ignition Quality of Gasoline-like Fuels in HCCI Engines”, SAE Paper No. 2004-01-2952, (2004).
- Hyvonen, J., Haraldsson, G. and Johansson, B.: “Operating Conditions Using Spark Assisted HCCI Combustion During Combustion Mode Transfer to SI in a Multi-Cylinder VCR-HCCI Engine”, SAE Paper No. 2005-01-0109, (2005).
- Milovanovic, N., Blundell, D., Gedge, S. and Turner, J.: “SI-HCCI-SI Mode Transition at Different Operating Conditions”, SAE Paper No. 2005-01-0156, (2005).
- Santoso, H., Matthews, J. and Cheng, W.K.: “Managing SI/HCCI Dual-Mode Engine Operation”, SAE Paper No. 2005-01-0162, (2005).
- Haraldsson, G., Tunestal, P., Johansson, B. and Hyvonen, J.: “Transient Control of a Multi Cylinder HCCI Engine During a Drive Cycle”, SAE Paper NO. 2005-01-0153, (2005).
- Agrell, F., Angstrom, H.E., Eriksson, B., Wikander, J. and Linderyd, J.: “Control of HCCI During Engine Transients by Aid of Variable Valve Timings Through the Use of Model Based Non-Linear Compensation”, SAE Paper No. 2005-01-0131, (2005).