This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Numerical Analysis of Optimum Peening Condition in terms of Collision Energy on Coil Spring by Shot Peening
Technical Paper
2005-01-0798
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This subject focuses on the simulated shot peening analysis of the collision energy and simulated collision energy distribution on coil spring. The authors studied hit condition by changing peening angle, and checked relationship between collision energy and residual stress. There have been no report that describe an analysis on the simulated shot peening effect on helical-shaped whereas reports on flat material exist1)2). In this paper, shot size, peening angle, spring wire overlapping are considered. The effectiveness of this analysis is verified in comparison with the previous test result where light was used to check the shadow of shot shower.
Recommended Content
| Technical Paper | Design and Structural Analysis of Bumper for Automobiles |
| Technical Paper | Case Depth for Induction Hardened Slewing Bearing Rings |
| Aerospace Standard | Qualification and Certification of Etch Inspectors |
Authors
Citation
Amano, A., Sakakibara, T., and Wakita, M., "Numerical Analysis of Optimum Peening Condition in terms of Collision Energy on Coil Spring by Shot Peening," SAE Technical Paper 2005-01-0798, 2005, https://doi.org/10.4271/2005-01-0798.Also In
References
- Watanabe, Y. Gifu University 1995
- Fathallah, R. Inglebert, G. Castex, L. Material Science and Technology 1998 631
- Hirose M. TsuTsumi A. Kenkyu-Kai Bane Gijutsu 1983 61
- Mitsubayashi M. Aihara H. Ogino M. Inagaki H. Saito A. Ogawa K. Miyata T. 1995 214