This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Effect of Flow Forces Compensating Profile on the Metering Characteristics of a Conical Seat Valve
Technical Paper
2004-01-2618
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper studies the influence of the discharge chamber geometrical parameters on the steady-state characteristics behavior of a conical seat valve having compensating profile.
More in details, starting from the analysis of the experimental behavior of an actual valve showing inefficient characteristic curves, the metering openings leading to the transition from under to over compensation are individuated.
Then, a 3D CFD steady-state, incompressible and isothermal analysis is involved, mainly to evidence the valve discharge coefficient and flow-forces variations with operating conditions.
After, two alternative valve configurations, presenting a low pressure region designed to optimize the flow-forces compensation, are characterized through the 3D CFD analysis.
Recommended Content
Authors
Citation
Borghi, M., Milani, M., and Paltrinieri, F., "The Effect of Flow Forces Compensating Profile on the Metering Characteristics of a Conical Seat Valve," SAE Technical Paper 2004-01-2618, 2004, https://doi.org/10.4271/2004-01-2618.Also In
References
- Johnston D.N. Edge K.A. Vaughan N.D. Experimental investigation of flow and force characteristics of hydraulic poppet and disc valves Proceedings of the Institution of Mechanical Engineers 205 161 171 1991
- Johnston D.N. Edge K.A. Vaughan N.D. Numerical simulation of fluid power in poppet valves Proceedings of the Institution of Mechanical Engineers 206 119 127 1992
- Sørensen H.L. Experimental and numerical analysis of flow and flow force compensation methods for hydraulic seat valve SICFP The Sixth Scandinavian International Conference on Fluid Power 471 482 Linkoeping, Sweden 1999
- Andersen T.O. Hansen M.R. Sorensen H.L. Conrad F. Using CFD to Establish a Correlation between Design Parameters and Performance Characteristics for Seat Valves Proceedings of the 1st International Conference on Computational Methods in Fluid Power Technology Melbourne, Australia November 26–28 2003
- Borghi M. Milani M. Paoluzzi R. Transient Flow Forces Estimation on the Pilot Stage of a Hydraulic Valve Proceedings of the 1998 IMECE - ASME International Mechanical Engineering Congress and Exposition – Fluid Power systems Technology Division Anaheim, California November 15–20 1998
- Borghi M. Milani M. Paoluzzi R. Stationary and Dynamic Analysis of a Water Relief Valve The Fourth JHPS International Symposium on Fluid Power, JHPS ’99 Ariake, Tokyo, Japan 15–17 November 1999
- Borghi M. Milani M. Paoluzzi R. Stationary axial flow force analysis on compensated spool valves International Journal of Fluid Power 1 1 17 25 March 2000
- Blackburn J.F. Reethof G. Shearer J.L. Fluid Power Control M.I.T. Technology Press & John Wiley & Sons 1960
- Merrit H. E. Hydraulic Control Systems John Wiley & Sons 1967
- Patankar S.V. Numerical Heat Transfer and Fluid Flow Hemisphere Publishing Corporation 1980
- Idelchick Handbook of Hydraulic Resistance Springer-Verlag 1983
- Chapra S.C. Canale R.P. Numerical Methods for Engineers Second Edition McGraw-Hill 1989
- Abbott M.B. Basco D.R. Computational Fluid Dynamics: An introduction for engineers Longman Scientific & Technical 1989