This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Optimization of a Common Rail Diesel Engine Start-up Process
Technical Paper
2004-01-0119
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The high emission level during start-up process of common rail diesel engine is still a problem for ultra low emission control. For the map-based common rail system, engine start-up process goes through the initialization of injection and rail pressure build-up process, so the fuel injection status is not stable. Based on the analysis of the characteristics of rail pressure build-up, engine speed variety and exhausted smoke emission during engine start-up process, it is found that the injection parameters of the initial phase of engine start-up have large effects on the start-up time and smoke emission. To optimize the smoke emission, this paper makes a study on the methods of determining the injection parameters during start-up by means of well-phased investigation of engine speed and orthogonal bench test. The research is carried out on a 6-cylinder 7.8L turbocharged diesel engine equipped with a DENSO ECD-U2 common-rail system. The optimization result shows a one third decrease in engine smoke emission with about the same start-up time, and with little amount of bench tests.
Recommended Content
Authors
- Fuyuan Yang - State Key Lab of Automotive Safety and Energy, Tsinghua University
- Jingyong Zhang - State Key Lab of Automotive Safety and Energy, Tsinghua University
- Qiang Han - State Key Lab of Automotive Safety and Energy, Tsinghua University
- Minggao Ouyang - State Key Lab of Automotive Safety and Energy, Tsinghua University
Topic
Citation
Yang, F., Zhang, J., Han, Q., and Ouyang, M., "Optimization of a Common Rail Diesel Engine Start-up Process," SAE Technical Paper 2004-01-0119, 2004, https://doi.org/10.4271/2004-01-0119.Also In
Diesel Emissions on CD-ROM from the SAE 2004 World Congress
Number: SP-1835CD; Published: 2004-03-08
Number: SP-1835CD; Published: 2004-03-08
References
- Detao LI Fundamental Research and Improvement Measures of Diesel Engine Start- Up[M] Science Publishing Company of Peking 1998
- Shaoan LI The Development and Problems of Common-rail Fuel Injection System[J] Internal Combustion Engine Fuel Injection and Control 1999
- State Automotive Standard Collection Book[S] China Standard Publishing Company 1999
- Jiaxiang LU The Analysis of Electronic Controlled Common-Rail Fuel Injection System Used on Diesel Engine[J] Engine for Automotive 2000
- Kui CHEN Experiment Design and Analysis[M] Tsinghua University Publishing Company 1996
- Fuyuan YANG Engine Ignition Judgement Based on Crank Instantaneous Acceleration Analysis Automotive Engineering 2003