This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of Advanced Plating System for Cylinder Bores of Motorcycles
Technical Paper
2003-32-0054
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
An advanced plating system for cylinder bores of motorcycles has been developed in order to improve production efficiency and to reduce the environmental impact. A new electrochemical etching process, which yields needle-like eutectic silicon on the surface of the alloy of cylinder bore, reduced the pretreatment steps from 5 to 1 because the process plays a key role in the anchoring of the Ni-P-SiC plating layer. It is noteworthy that the deposition rate of Ni-P-SiC layer onto the alloy was 5 times as fast as the conventional process. Also, the waste liquid was reduced to less than 1/10 due to a new recycle system.
Recommended Content
Aerospace Standard | Drive - Studded, Accessory, 2.653 B.C. Square, Design Standard For |
Technical Paper | The DCE Supermileage Engine |
Technical Paper | High Volume Semi-Solid Forming of Aluminum Master Cylinders |
Authors
Citation
Kato, H., Muramatsu, H., Nakamura, T., and Takahashi, N., "Development of Advanced Plating System for Cylinder Bores of Motorcycles," SAE Technical Paper 2003-32-0054, 2003, https://doi.org/10.4271/2003-32-0054.Also In
References
- Ishimori S. Shimizu M. Honda S. Otsuka S. Toyoda M. J.Metal Finishing Society Japan 28 508 1977
- Ishimori S. Otsuka S. JSAE 32 829 1978
- Ishimori S. Otsuka S. Takama M. JSAE 38 875 1984
- Lashmore D.S. Plating and Surface Finishing 37 June 1985
- Tashiro K. Chiba K. Fukuda Y. Nakao H. Honda H. J. Surface Finishing Society Japan 45 720 1994
- Isobe M. Ikegaya H. JSAE 48 89 1994
- Malak C. Metalloberflache 48 232 1994
- Kawasaki M. J.Metal Finishing Society Japan 20 621 1969
- Kurosawa K. J. Surface Finishing Society Japan 41 1990
- Hasegawa K. Takada H. Yamaoka S. Ito T. Yoshida K. J. Surface Finishing Society Japan 40 419 1989