This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Vibration Analysis of Engine Supported by Hydraulic Mounts
Technical Paper
2003-01-1465
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper describes a steady vibration of an engine supported by rubber and hydraulic mounts at a relatively low frequency range, assuming an engine is a rigid body. We identify dynamic characteristics of a hydraulic mount with respect to frequency and amplitude. The equation of motion is solved numerically by the Newton-Raphson method, treating the mount characteristics as functions of frequency and amplitude. The excitation test to simulate an engine shake and an idling vibration was performed using a mass block instead of an actual engine. During the engine shake, we observed that the amplitude dependency of hydraulic mounts strongly influences the vibration, while idling, we investigated rolling vibration especially for the case where the torque axis does not pass through the engine's center of gravity. The theoretical predictions agree closely with the experimental results in both engine shake and idling vibration tests. The influence of the orifice dimensions of the hydraulic mounts on the vibration was also studied, and we found that the current orifice dimensions are optimum in this system.
Recommended Content
Authors
Citation
Tsujiuchi, N., Koizumi, T., Yamazaki, K., and Shibayama, T., "Vibration Analysis of Engine Supported by Hydraulic Mounts," SAE Technical Paper 2003-01-1465, 2003, https://doi.org/10.4271/2003-01-1465.Also In
References
- Sugino, M. Okuzumi, H. Abe, E. Analysis and Application of Hydraulic Engine Mount Nissan Technical Report 9 18 1985
- Seto, K. Ishihama, M. Nagamatsu, A. Optimum Design Method for Hydraulic Engine Mount Trans. Jpn. Soc. Mech. Eng. 57 534 1991 453 459
- Sibayama, T. Takasima, Y. Horioka, T. Theoretical Investigation of Hydraulic Mount Journal of the Society of Automotive Engineers of Japan 983 235 145 148 1998
- Koizumi, T. Tsujiuchi, N. Shibayama, T. A Study of the Dynamic Characteristics of Hydraulic Engine Mount Trans. Jpn. Soc. Mech. Eng. 68 668 2002 1088 1095
- Colgate J.E. Chang C.T. Chiou Y.C. Liu W.K. Keer L.M. “Modelling of a Hydraulic Engine Mount Focusing on Response to Sinusoidal and Composite Excitation, Journal of Sound and Vibration” Journal of Sound and Vibration 1995 503 516
- Hata, H. Iyama, H. Miyake, M. Sakane, H. Engine Mounting Optimization System using Response Surface Methodology Journal of the Society of Automotive Engineers of Japan 23-01 102 1 4 2001
- Sakai, T. Iwahara, M. Shirai, Y. Hagiwara, I. Optimum Designing of Engine Mounting for Heavy Duty Vehicle (5th Report, Optimum Engine Mounting Layout by Genetic Algorism) Trans. Jpn. Soc. Mech. Eng. 67 664 2001 3815 3822