This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Automotive Turbocharger Maps Building using a Flux Test Stand
Technical Paper
2002-01-3542
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This work presents the experimental determination of an automotive turbocharger flow map, by using a flux test stand. This equipment is able to reproduce and measure the main characteristics of an intake and exhaust flows of an automotive engine. To build the compressor and turbine flow maps, the experimental data should be treated through an empirical model. Flow maps of two turbochargers are presented. The first flow map presented was used to validate the data treating method. The validation process made use of published GT12 Garrett turbocharger data. The data treating method was applied on the experimental dada of T2 Garrett turbocharger obtained on the flux test stand. The flow maps build are shown, and operational limits are identified on then. These flow maps give essential information to choose the most suitable turbocharger for a specific internal combustion engine.
Recommended Content
| Technical Paper | Geometry-Based Compressor Data-Maps Prediction |
| Technical Paper | Port Design for Charge Motion Improvement within the Cylinder |
| Technical Paper | Using LES to Investigate Reacting Flow Physics in Engine Design Process |
Authors
- Fernando Antonio Rodrigues Filho - Universidade Federal de Minas Gerais (UFMG)
- Ramón Molina Valle - Universidade Federal de Minas Gerais (UFMG)
- José Eduardo Mautone Barros - Centro Federal de Educação Tecnológica de Minas Gerais (CEFET-MG)
- Sérgio de Morais Hanriot - Universidade Católica de Minas Gerais (PUC-MG)
Citation
Filho, F., Valle, R., Barros, J., and Hanriot, S., "Automotive Turbocharger Maps Building using a Flux Test Stand," SAE Technical Paper 2002-01-3542, 2002, https://doi.org/10.4271/2002-01-3542.Also In
References
- HEYWOOD, J B. “Internal Combustion Engine Fundamentals” McGraw-Hill New York 1988
- OATES, G. C. “Aerothermodynamics of Gas Turbine and Rocket Propulsion” AIAA Education Series AIAA Washington 1988
- RODRIGUES, P. S. B. 1991
- ZUCROW, M. J. HOFFMAN, J. D. “Gas Dynamics” John Wiley & Sons New York 1 1976
- “Test Code on Compressors and Exhausters” ASME Washington 1997
- HANRIOT, S. de M. 2001
- BARROSO, L. C. et al. 1987
- ALVAREZ FILHO, J. GONDIM, R. T. 2 2000