This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Aerodynamic Test and Development of the Corvette C5 for Showroom Stock Racing
Technical Paper
2002-01-3333
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This pager documents a one shift (10 hour) wind tunnel test program conducted on a Corvette C5 prepared for Sports Car Club of America (S.C.C.A.) World Challenge racing. The testing was conducted at the Canadian National Research Center in Ottawa, Canada. Specific areas of test included front fascia and under tray, rear air discharge, rear wing configuration and angle, B-pillar configuration, and ride height. Standard wind tunnel test procedures were followed. In total twenty-six separate configurations were evaluated. Data for front and rear lift, total drag, and lift/drag (L/D) ratio are provided for each test configuration. The cumulative effects of the aerodynamic changes evaluated in this program, calculated at 192 KPH (120 MPH), increased front down force by 318 N (72 Lb.), and rear down force by 770 N (173 Lb.). Lift/drag ratio was improved from -0.597 to -1.016. These changes increased total drag by 381 N (86 Lb.). Further testing lowering ride height 2.5cm rear and 5.0cm front reduced drag by 326 N (73 tb.) and resulted in a L/D Ratio of -1.247. Although data are specific to the Corvette C5, the general principles studied may be applied to any production-based racecar. These modifications should be validated on the racetrack prior to competing to ensure the handling balance can be optimized for the driver and car combination.
Recommended Content
Technical Paper | 2006 Chevrolet Corvette C6 Z06 Aerodynamic Development |
Technical Paper | Ride and Handling Development of the 1997 Chevrolet Corvette |
Technical Paper | Synthesis of Chassis Parameters for Ride and Handling on the 1997 Chevrolet Corvette |