This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Three Dimensional Vibration Characteristics of High-Speed Automobile Diesel Engine Crankshaft System with a Viscous Fluid Damper
Technical Paper
2002-01-0165
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The torsional vibration of diesel engines has become severer with the increase of exciting force by higher pressure. Therefore, the running crankshaft is highly stressed owing to the large torsional vibration. Then, torsional viscous fluid dampers of high performance have been employed in high mean effective pressure diesel engines as a measure for vibration reduction. As the dynamic characteristics of the dampers have such a great influence on the vibration of the engine crankshaft system that they cannot be ignored, the viscosity of the silicone oil and the peripheral and lateral gaps of the dampers are diversely varied in the experiment. As the equipment for the measurement of torsional vibration displacement, a phase-shaft type torsiograph equipment was adopted so as to make it easy to measure simultaneously angular displacements of the casing and the inertia ring. And the waveforms of axial and lateral vibrations were measured by non-contact maicro-displacement vibrographs and laser displacement vibragraphs. In the experiment, the 6 litters, 6 cylinders, in-line high-speed diesel engine whose vibration characteristics are known quite well was regarded as a vibration oscillator of the dampers. The dynamic characteristics of the high viscosity silicone oil damper and the optimum clearance between the casing and the inertia ring were investigated from a quantitative standpoint under full-load conditions, and the useful data in the design stage were gathered. As the result of the experimental study on the three-dimensional dynamic properties of torsional viscous fluid damper filled with silicone oil, the following conclusions are obtained;
- (1)The clearance value determined from BICERA's empirical formula is not always optimum on every viscosity of the filled silicone oil of the viscous fluid damper.
- (2)The optimum viscosity is different, due to the dimensions of the peripheral and lateral gaps between the outside of the inertia ring and the inside of the casing.
- (3)The effect of the amplitude reduction on the axial vibration of the crankshaft system with the typical torsional viscous fluid damper is small.
- (4)The lateral vibration are coupled with the torsional vibration of the crankshaft system.
Recommended Content
Authors
- Tomoaki Kodama - Department of Mechanical Engineering, Faculty of Engineering, Kokushikah University
- Katsuhiko Wakabayashi - Department of Mechanical Engineering, Faculty of Engineering, Kokushikah University
- Yasuhiro Honda - Department of Mechanical Engineering, Faculty of Engineering, Kokushikah University
- Shoichi Iwamoto - Advanced Research Institute for Science and Engineering, Waseda University
Topic
Citation
Kodama, T., Wakabayashi, K., Honda, Y., and Iwamoto, S., "Three Dimensional Vibration Characteristics of High-Speed Automobile Diesel Engine Crankshaft System with a Viscous Fluid Damper," SAE Technical Paper 2002-01-0165, 2002, https://doi.org/10.4271/2002-01-0165.Also In
References
- Wakabayashi Katsuhiko Honda Yasuhiro Kodama Tomoaki Iwamoto Shoichi “The Characteristics of Bending Vibration Stress Coupled with Torsional Vibration of Automotive Diesel Engine Shaftings” 1995 SAE International Congress and Exposition, SAE Paper No. 950543 1995 23 39
- Wakabayashi Katsuhiko Shimoyamada Kunio Kodama Tomoaki Iwamoto Shoichi “A Study on the Characteristics of Bending Vibration Coupled with Torsional Vibration in the Crankshafting of a V-Type, 8 Cylinder Diesel Engine” Transactions of Kokushikan University, Faculty of Engineering 18 1985 35 39
- Wakabayashi Katsuhiko Iwamoto Shoichi Kodama Tomoaki Honda Yasuhiro “An Investigation of Three-Dimensional Vibrations of Diesel Engine Shaftings Using the Transfer Matrix Method” Journal of the Marine Engineering Society in Japan 31 9 1996 670 678
- Wakabayashi Katsuhiko Honda Yasihiro Kodama Tomoaki Iwamoto Shoichi “Three Dimensional Analysis of Forced Vibrations of Diesel Engine Shaftings by the Transfer Matrix Method” Proceedings of International Symposium on Marine Engineering Yokohama '95 II 1995 35 42
- Wakabayashi Katsuhiko “A 3-Dimensional Analysis of Forced Vibrations of Reciprocating Engine Shaftings” Internal Combustion Engine 29 365 1990 44 50
- Naganuma Takeo Okamura Hideo Sogabe Kiyoshi “Experiments and Analyses of the Three-Dimensional Vibrations of the Crankshaft and Torsional Damper in a Four-Cylinder In-Line High Speed Engine” SAE Noise and Vibration Conference, SAE Paper No. 971996 1996 1009 1020
- Rangwala Abdulla S. “ Reciprocating Machinery Dynamics Design and Analysis ” Marcel Dekker, Inc. 2001 400 466 New York
- Iwamoto Shoichi “Study on the Effective Viscosity of Working Oil in Viscous Torsional Vibration Damper of Diesel Engine, Second Report: Complex Viscosity of Working Oil in Damper of High Speed Engine” Journal of the Marine Engineering Society in Japan 18 10 1983 795 800
- Iwamoto Shoichi Yonezawa Tohru Mukawa Yasunori “Study on the Effective Viscosity of Working Oil in Viscous Torsional Vibration Damper of Diesel Engine, Third Report: Complex Viscosity of Working Oil in Damper of Low Speed Engine” Journal of the Marine Engineering Society in Japan 18 12 1983 975 981
- Sugimoto Masao Ohashi Hideo Takenaka Toshihiro “Dynamic Damper with Damping for Torsional Vibration” Journal of the Marine Engineering Society in Japan 18 10 1983 993 998
- Wakabayashi Katsuhiko Iwamoto Shoichi Shimoyamada Kunio “Analysis of Vibrations of Reciprocating Engine Shaftings by the Transfer Matrix Method, The Fourth Report: Torsional Vibration Stress of a Crankshaft with a Viscous Fluid Damper” Journal of the Marine Engineering Society in Japan 19 1 1984 24 33
- Asami Toshihiko lribem Kyosuke Momose Kazunari Hosokawa Yoshinobu “Effect of Compressibility of Oil on an Oil Damper” Transactions of the Japan Society of Mechanical Engineers 58 549 1992 1592 1600
- Sato Yuichi Moriguchi Naoki “Suppression of Torsional Vibrations by a Partitioned Hollow Rotor Containing Liquid” Transactions of the Japan Society of Mechanical Engineers 59 557 1993 17 23
- Sato Yuichi Koshimizu Kengo “Suppression of Torsional Vibrations by a Sectored Hollow Cylinder Containing” Transactions of the Japan Society of Mechanical Engineers 59 569 1994 44 49
- Shimoda Ikuo “Study of High Viscous Damper: Modelling of Viscoelasticity and Proposition of Design Method” Transactions of the Japan Society of Mechanical Engineers 60 570 1994 44 49
- Yamauchi Takahiro Yamazaki Yukimi “Computation and Experiment Analysis for Torsional Vibration of Crankshaft System with Viscous Torsional Damper” Isuzu Technical Review 100 1998 112 119
- Iwamoto Shoichi Wakabayashi Katsuhiko Kodama Tomoaki “A Study for the Characteristics of Torsional Vibration Damping in High-Speed Diesel Engine, The Third Report: Engine Damping in an Engine System with a Viscous Torsional Vibration Damper” The Science and Engineering Reports of Saitama University 16 1983 15 19
- Wakabayashi Katsuhiko Shimoyamada Kunio Kodama Tomoaki Iwamoto Shoichi “A Study on the Torsional Vibration Characteristics of Crankshaftings with a Viscous Fluid Damper, The First Report: Complex Damping Coefficient of Dampers” Transactions of Kokushikan University, Faculty of Engineering 17 1984 54 62
- Wakabayashi Katsuhiko Honda Yasuhiro Kodama Tomoaki Iwamoto Shoichi “The Dynamic Characteristics of Torsional Viscous-Friction Dampers on Reciprocating Engine Shaftings” SAE 1992 Transactions, Journal of Engines 101 SAE Paper No. 921726 1993 1734 1754
- Wakabayashi Katsuhiko Honda Yasuhiro Kodama Tomoaki Iwamoto Shoichi “The Effect of Typical Torsional Viscous-Friction Damper on the Reduction of Vibrations in the Three Dimensional Space of Diesel Engine Shaftings” SAE 1993 Transactions, Journal of Engines 102 SAE Paper No. 932009
- Wakabayashi Katsuhiko Shimoyamada Kunio Kodama Tomoaki Honda Yasuhiro Iwamoto Shoichi “A Study of Torsional Vibration Characteristics of Diesel Engine Shaftings with a Viscous Fluid Damper” Proceedings of Japan Society Automotive Engineers 1991 3.73 3.76
- Wakabayashi Katsuhiko Honda Yasuhiro Kodama Tomoaki Okamura Hirishi “Study on Optimum Torsional Viscous-Friction Damper” Proceedings of the Japan Society of Mechanical Engineers, Dynamics and Design Conference '98 A 1998 92 95
- Wakabayashi Katsuhiko Haraguchi Takayuki Kodana Tomoaki Iwamoto Shoichi “An Investigation into the Dynamic Characteristics of Torsional Viscous-Friction Dampers by Simultaneous Measurement at Two Points” Proceedings of the 6th International Symposium on Marine Engineering Tokyo 2000 569 576
- Kodama Tomoaki Wakabayashi Katsuhiko Honda Yasuhiro Iwamoto Shoichi “Dynamic Characteristics of Viscous-Friction Dampers by Simultaneous Vibration Displacement Measurement at Two Points SAE 2001 World Congress, SAE Paper No. 2001-01-0281 2001 1 12
- Kodama Tomoaki Wakabayashi Katsuhiko Honda Yasuhiro Okamura Hiroshi Iwamoto Shoichi “An Investigation into Dynamic Characteristics of Torsional Viscous-Friction Dampers by Simultaneous Measurement at Two Points” Transactions of the Kokushikan University, Faculty of Engineering 34 2001 23 31
- Kodama Tomoaki Wakabayashi Katsuhiko Honda Yasuhiro “an Experimental Study on the Dynamic Characteristics of Torsional Viscous-Friction Dampers for High-Speed Diesel Engine: Relationship between Damper Clearance and Kinematic Viscosity of Silicone Fluid” Proceedings of the Japan Society of Mechanical Engineers, Dynamics and Design Conference 2001 635 2001
- Kodama Tomoaki Wakabayashi Katsuhiko Honda Yasuhiro Iwamoto Shoichi “An Experimental Study on the Dynamic Characteristics of Torsionbal Viscous-Friction Dampers: Behaviors of Damper Casing and Inertia Ring and Dynamic Characteristics of Damper” Proceedings of the Japan Society of Mechanical Engineers, 2001 Annual Meeting 2001 107 180
- B.I.C.E.R.A. “ A Handbook on Torsional Vibration ” Cambridge at the University Press 1958 520 558