This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Thermal Balance Testing of the Envisat Payload Module
ISSN: 0148-7191, e-ISSN: 2688-3627
Published July 09, 2001 by SAE International in United States
Annotation ability available
The Envisat spacecraft has a launch mass greater than 8.0 tonnes and external dimensions of 10.0 metres x 2.8 metres x 2.1 metres. Due to it’s large size, it was necessary to perform the thermal balance and thermal vacuum testing in two stages. Firstly, there was the testing of the Service Module and, secondly, the testing of the Payload Module (PLM).
This paper discusses the thermal balance testing of the PLM. The PLM, itself, is 7.5 metres tall; too large to fit into a test facility solar beam. Originally, it was intended to conduct two solar beam tests; one for the upper part and the second for the lower part. Following a revision and re-scheduling within the programme, it was decided to perform a single, non-solar beam, thermal balance test. The thermal balance test would be performed using test specific, electrical, heaters and test facility shroud control.
The Envisat PLM supports a complement of 10 earth observation instruments and was successfully tested in July/August 1999 at the Large Space Simulator (LSS), at ESTEC, The Netherlands. The objectives of the thermal balance test were to provide correlation data for the thermal mathematical models and to demonstrate the Thermal Control Subsystem (TCS) performance. Test data, taken from the test, is compared with the test predictions and a correlation performed. The resultant thermal model will be utilised to provide the final flight predictions.
The paper outlines the rationale behind the selection and definition of the test, discusses technical aspects of the test set-up and shows the achieved, thermal mathematical model, correlation.
|Technical Paper||The Solar Simulation Test of the ITALSAT Structural Thermal Model|
|Technical Paper||GOCE Thermal Balance / Vacuum Test|
|Technical Paper||Lessons Learned from the METOP Thermal Analysis and Testing|
CitationPrice, S., Argles, P., Manns, M., and Pieper, B., "Thermal Balance Testing of the Envisat Payload Module," SAE Technical Paper 2001-01-2242, 2001, https://doi.org/10.4271/2001-01-2242.
- Price S.G. Argles P.J. Rouchit P. Pieper B. Dolce S. “Polar Platform Service Module Thermal Balance Testing and Correlation” Paper 972315 th July 1997