This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Comparison of Conversion Efficiency and Flow Restriction Performance of Ceramic and Metallic Catalyst Substrates
Technical Paper
2001-01-0926
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE 2001 World Congress
Language:
English
Abstract
Catalyst systems utilizing ceramic and metallic substrates were compared to assess the influence of various substrate parameters on the exhaust gas conversion efficiency and flow restriction. In particular, the substrate surface area, substrate specific heat capacity, and substrate volume were all evaluated for their importance in estimating the conversion efficiency of the catalyst system. Additionally, substrate open frontal area and cell hydraulic diameter were compared against exhaust restriction performance.
Recommended Content
Citation
Pannone, G. and Mueller, J., "A Comparison of Conversion Efficiency and Flow Restriction Performance of Ceramic and Metallic Catalyst Substrates," SAE Technical Paper 2001-01-0926, 2001, https://doi.org/10.4271/2001-01-0926.Also In
Advanced Catalytic Converters and Substrates for Gasoline Emission Systems
Number: SP-1573; Published: 2001-03-05
Number: SP-1573; Published: 2001-03-05
References
- Umehara K. Yamada T. Hijikata T. Ichikawa Y. Katsube F. “Advanced Ceramic Substrate: Catalytic Performance Improvement by High Geometric Surface Area and Low Heat Capacity,” SAE Paper 971029 1997
- Kikuchi S. Hatcho S. Okayama T. Inose S. Ikeshima K. “High Cell Density and Thin Wall Substrate for Higher Conversion Ratio Catalyst,” SAE Paper 1999-01-0268 1999
- Schmidt J. “The Impact of High Cell Density Ceramic Substrates and Washcoat Properties on the Catalytic Activity of Three Way Catalysts,” SAE Paper 1999-01-0272 1999
- Umehara K. Makino M. Brayer M. Becker E. R. Watson R. “Prediction of Catalytic Performance for Ultra Thin Wall and High Cell Density Substrates,” SAE Paper 2000-01-0494 2000
- Nishizawa K. Masuda K. Horie H. Hirohashi J. “Development of Improved Metal-Supported Catalyst,” SAE Paper 890188 1989
- Brück R. Diewald R. Hirth P. Kaiser F. “Design Criteria for Metallic Substrates for Catalytic Converters,” SAE Paper 950789 1995
- Pfalzgraf B. Rieger M. Ottowitz G. “Close-coupled Catalytic Converters for Compliance with LEV/ULEV and EGIII Legislation - Influence of Support Material, Cell Density and Mass on Emission Results,” SAE Paper 960261 1996
- Day J. P. Socha L. S. “Technique for the Analysis of FTP Emissions,” SAE Paper 920724 1992
- Day J. P. “Substrate Effects on Light-Off - Part I Thermal Energy Requirements,” SAE Paper 962074 1996