This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Vehicular Padding and Head Injury
Technical Paper
2000-05-0188
Annotation ability available
Sector:
Event:
Language:
English
Abstract
The Federal Motor Vehicle Safety Standard 571.201 discusses occupant protection with interior impacts of vehicles. Recent rule making by the National Highway Traffic Safety Administration (NHTSA) has identified padding for potential injury reduction in vehicles. Head injury mitigation with padding on vehicular roll bars was evaluated. After market 2 to 2.5 cm thick padding and metal air gap padding reduced the head injury criterion (HIC) and angular acceleration compared to the stock foam roll bar padding. Studies were conducted with free falling Hybrid 50% male head form drops on the fore head and side of the head. Compared to the stock roll bar material, a nearly 90% reduction in HIC was observed at speeds up to 5.4 m/s. A concomitant 83% reduction in angular acceleration was also observed with the metal air gap padding. A 2 to 2.5 cm thick Simpson roll bar padding produced a 70 to 75% reduction in HIC and a 59 to 73% reduction in angular acceleration. DYNAMAN analysis closely predicted the HIC and angular acceleration results. All HIC values with padding were below 560 for metal air gap padding and Simpson roll bar padding tests. The studies demonstrate that padding can markedly reduce the potential for head injury based on a substantial reduction in HIC and angular acceleration when impacts occurred on a padded surface.
Recommended Content
Technical Paper | Automotive Seat Design Affecting Comfort and Safety |
Technical Paper | Results from Calculating the Acceleration at an ELR in a Steer Induced Rollover Crash Test |
Technical Paper | Analytical Studies of the Head Injury Criterion (HIC) |
Authors
Citation
Sances, A., Carlin, F., Herbst, B., Forrest, S. et al., "Vehicular Padding and Head Injury," SAE Technical Paper 2000-05-0188, 2000.Also In
References
- Becker, E. B. 1998 “Helmet Development and Standards,” Frontiers in Head and Neck Trauma Yoganandan N. et al. 113 130
- Cheng Rizer Obergefell “ATB Model Simulation of a Rollover Accident with Occupant Ejection” SAE 950134
- Cheng Rizer Obergefell “Pickup Truck Rollover Accident Reconstruction Using the ATB Model” SAE 950133
- Digges, K. “Reconstruction of Frontal Accidents Using the CVS-3D Model” SAE 840869
- Digges, K.H. Malliaris, A.C. Ommaya A.K. “The mechanics and biomechanics of rollover casualties” CDC Symposium Proceedings, Prevention Through Biomechanics Wayne State University April 12 1991 51 61
- Eppinger, Rolf Sun, Emily Bandak, Faris Haffner, Mark Khaewpong, Nopporn Maltese, Matt Kuppa, Shashi Nguyen, Thuvan Takhounts, Erik Tannous, Rabih Zhang, Anna Saul, Roger “Development of Improved Injury Criteria for the Assessment of Advanced Automotive Restraint Systems- II” National Higway Traffic Safety Administration November 1999
- Ewing C.L. Thomas D.J. et al. 1975 “The Effect of the Initial Position of the Head and Neck to -Gx Impact Acceleration,” Proceedings of the 19 th Stapp Car Crash Conference, SAE Warrendale, USA
- Fan W. R. S. February 1998 “Head Impacts With Roof - Pillar Support Structures - Problem Identification” J Biomech Eng. 120 1 140 7
- Friedman D. Friedman K. “Final and Summary Comments, FMVSS 201 Head Impact Doc. #92-28; Notice 3, Washington D.C. Proposed Amendment to Standard 201, Occupant Protection in Interior Impact” Federal Register 58 24 7506 7525 February 28 1993
- Grimes, W. “Using ATB in Collision Reconstruction” SAE 950131
- Hertz, Ellen “Note On The Head Injury Criterion (HIC) As A Predictor Of The Risk Of Skull Fracture” 37 th Annual Proceedings Association For The Advancement Of Automotive Medicine November 4-6 1993 San Antonio, Texas
- Khatua et al. “The Use of ATB/DYNAMAN in Injury Biomechanics” ATB Model Users Colloquium Dayton, OH. USAF June 13 1995
- Kleinberger M Yoganandan N Kumaresan S “Biomechanical considerations for child occupant protection” 42 nd AAAM Conf Charlottesville, VA October 1998
- Kleinberger, M. Sun; E. Eppinger, R. Kuppa, S. Saul, R. 1998 “Development of Improved Injury Criteria for the Assessment of Advanced Automotive Restraint Systems,” NHTSA
- Lowenhiem, P 1975 “Brain Susceptibility to Velocity Changes, Relative and Absolute Limits for Brain Tissue Tolerance to trauma and their Relation to Actual Traumatic Situations” Proceedings of an International Interdisciplinary Symposium on Traffic Speed and Casualties at G1 Avemaess Denmark
- McLean A. J. 1996 “Brain injury Without Head impact?” Bandak, F. A. Eppinger, R. H. Ommaya, A.K. Traumatic Brain Injury Bioscience and Mechanics Mary Ann Liebert, Inc. Larchmont, NY 45 49
- Margulies, Susan Sheps Thibault, Lawrence E. “A Proposed Tolerance Criterion For Diffuse Axonal Injury In Man” J Biomechanics 25 8 917 923 1992
- Mishimoto T. Murakami S. February 1998 “Relation Between Diffuse Axonal Injury and internal Head Structures on Blunt Impact,” J Biomech Eng 120 1 140 7
- Monk M. W. Sullivan L. K. “Energy Absorption Material Selection Methodology for Head / A pillar” Society of Automotive Engineers, SAE 861887 185 197
- Myers T. J. Yogananadan N. Sances A. Jr. Pintar F. A. Reinartz J. Battocletti J. H. “Energy Absorption Characteristics of Football Helmets Under Low and High Rates of Loading” Bio-Medical Materials and Engineering 3 15 24 1993
- Newman J.A. 1998 “Kinematics of Head Injury” Yoganandan, N et al. Frontiers in Head and Neck Trauma 200 214
- Obergefell et al. “Articulated Total Body Model Enhancements, Volume 2: User's Guide” Report No. AAMRL-TR-88-043 (NTIS No. A203-566)
- Ommaya A. K. “Head Injury Biomechanics,” George G. Snively Memorial Lecture Association for the Advancement of Automotive Medicine Denver, Colorado 1984
- Partyka, S. “Serious Head Injury in Light Passenger Vehicles from Rail, Header, and Pillar Contact” DOT-88-GR-003
- Pincemaille, Y. Trosseiile, X. Mack, P. Tarriere, C. “Some new data related to human tolerance obtained from volunteer boxers” Proceedings 33 rd Stapp Car Crash Conference Washington, DC 177 190 1989
- Prasad, Priya Mertz, Harold J. “The Position of the United States Delegation to the ISO Working Group on the Use of HIC in the Automotive Environment” Society of Automotive Engineers, Government/Industry Meeting & Exposition Washington, D.C. May 20-23 1985 851246
- Rechnitzer, G. Lane, J. Scott, G “Rollover crash study -vehicle design and occupant injuries” 15 th International Technical Conference on the Enhanced Safety of Vehicles; Paper No. 96-S5-O-10 Melbourne, Australia May 13-17 1996 14
- Sances, A., Jr Yoganandan, N. “Human head injury tolerance” Sances, A. Jr. Thomas, D.J. Ewing, C. L. Larson, S. J. Unterharnscheidt, F. Mechanisms of Head and Spine Trauma Aloray Publisher Goshen, NY 1986 189 218
- Sances, A. Jr. Yoganandan N. Maiman D.J. Myklebust, J.B. Chilbert, M. Larson, S.J. Pech, P. Pintar, F. Myers, T. “Spinal injuries with vertical impact” Sances, A. Jr. Thomas, D.J. Ewing, C. L. Larson, S. J. Unterharnscheidt, F. Mechanisms of Head and Spine Trauma Aloray Publisher Goshen, NY 1986 305 348
- Sances, A., Jr Yoganandan, N. Pintar, F. A. Kumaresan, S. Walsh, P. “Impact biodynamics of human skull fracture” Proceedings AGARD Meeting, Impact head Injury: Responses Mechanisms Tolerance, Treatment and Countermeasures Mescalero, NM Nov 7-9 1996
- Sances, A., Jr. “Biomechanical Analysis of Injury Criterion for Child and Adult Dummies” Critical Reviews in Biomedical Engineering 1999 361 365
- Thibault L. E. Gennarelli T. A. “Brain Injury: An analysis of neural and neurovascular trauma in the nonhuman primate” 34 th Annual Proceedings Association for the Advancement of Automotive Medicine Scottsville, AZ 1990
- Voo, L. Kumaresan, S. Pintar, F.A. Yoganandan, N. Sances, A., Jr “Finite element models of the human head” Medical & Biological Enq and Comput 34 5 375 381 1966
- Yamada, Hiroshi “Strength of Biological Materials” Baltimore Williams & Williams Co. 1970
- Yoganandan, N. Pintar, F. Sances, A. Jr. Harris, G. Chintapalli, K. Myklebust, J. B. Schmaltz, O. Reinartz, J. Kalbfleisch J. Larson S. J. “Steering wheel induced facial trauma” Society of Automotive Engineers Transactions 97 4 1104 1128 1989
- Yoganandan, N. Skrade, D. Pintar, F.A. Reinartz, J. Sances, A., Jr. “Thoracic deformation contours in frontal impact” Proceedings of the 35 th Stapp Conference, SAE 1991
- Yoganandan, N. Pintar, F. A. Sances, A. Jr Walsh, P. R. Reinartz, J. M. Ewing, C. L. Thomas, D. J. Snyder, R. G. “Biomechanics of skull fracture” J Neurotrauma 12 4 659 668 1995
- Yoganandan, N. Pintar, F. A. Sances, A., Jr. Walsh, P. R. Ewing, C. L. Thomas, D. J. Snyder, R. G. “Biomechanics of skull fracture” Ommaya, A. K. Traumatic Brain Injury Bioscience and Mechanics Mary Ann Liebert, Inc. publisher 227 236 1996