This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Performance Analysis and Comparison of a Multivalve SI Engine Running on Either Gasoline or CNG
Technical Paper
2000-05-0086
Annotation ability available
Sector:
Event:
Language:
English
Abstract
A comparative investigation of both fuel consumption and exhaust emissions has been carried out on a production SI engine operated by either gasoline or compressed natural gas (CNG). The engine had the main features of being a multivalve, fast-burn pent-roof chamber engine with a variable intake-system geometry. It was originally designed at Fiat Auto to operate with unleaded gasoline and was then converted at Politecnico di Torino to run on CNG. To that end, in addition to designing and building the CNG fuel plant, the multipoint Bosch Motronic M1.7 electronic module for injection-duration and spark-timing control was replaced with a Magneti-Marelli IAW ECM designed to obtain a multipoint sequential injection. With this new ECM, the engine was modified so as to work with either natural gas or gasoline. For the present study, the engine was not optimized to run on CNG in order to compare the performance of the same compression-ratio engine under different working conditions with the two different fuels. The engine was also interesting as a dual-fuel propeller because of its relatively high compression ratio, ≈ 10.5, which is almost suitable for CNG operation. Besides, the engine features are of particular interest for the use of natural gas as an alternative fuel, due to the lack of data for innovative CNG engine design concepts.
A test bench, previously installed and instrumented in an engine hall for typical dynamometer experiments, was equipped with an upgraded multipurpose exhaust gas analyzer including a device to separate methane from non-methane HC pollutants. The engine performance analysis was carried out in terms of fuel consumption, torque and exhaust emissions, although pressure time-histories were also acquired in the combustion chamber for heat-release studies. The engine tests with the two different fuels were conducted as “spark sweeps” at fixed engine speed and air-fuel ratio. These tests covered a range of different engine speeds, air-fuel ratios around stoichiometric conditions, as well as different loads. Each “sweep” consisted of several spark advances centered around the MBT timing. However, only the results of a demonstrative engine-test sample are here presented and discussed. Operation with CNG basically showed the capability of a substantial reduction in both specific fuel consumption and pollutant emissions.
Recommended Content
Authors
- A.E. Catania - Dipartimento di Energetica, Politecnico di Torino, Torino, Italy
- S. D'Ambrosio - Dipartimento di Energetica, Politecnico di Torino, Torino, Italy
- A. Mittica - Dipartimento di Energetica, Politecnico di Torino, Torino, Italy
- E. Spessa - Dipartimento di Energetica, Politecnico di Torino, Torino, Italy
Topic
Citation
Catania, A., D'Ambrosio, S., Mittica, A., and Spessa, E., "Performance Analysis and Comparison of a Multivalve SI Engine Running on Either Gasoline or CNG," SAE Technical Paper 2000-05-0086, 2000.Also In
References
- Weaver, C.S. “Natural Gas Vehicles--A Review of the State of the Art,” SAE Paper No. 892133 1989
- Kittelson, D.B. Pipho, M.J. Franklin, M.L. “Dynamic Optimization of Spark Advance and Air-Fuel Ratio for a Natural Gas Engine,” SAE Paper No. 892142 1989
- Klimstra, J. “Performance of Lean-Burn Natural-Gas-Fuelled Engines-On Specific Fuel Consumption, Power Capacity and Emissions,” SAE Paper No. 901495 1990
- Meyer, R.C. Cole, J.J. Kienzle, E. Wells, A.D. “Development of a CNG Engine,” SAE Paper No. 910881 1991
- T.J. Callahan, Ryan T.W. III, King, S.R. “Engine Knock Rating of Natural Gas-Methane Number,” ASME ETCE Houston, TX 1993
- Mendis, K.J.S. Stone, C.R. Ladommatos, N. Weller, G. “Modelling and Measurements from a Natural Gas Fuelled Engine,” SAE Paper No. 930927 1993
- Conti, L. Ferrera, M. Garlaseo, R. Volpi, E. Cornetti, G.M. “Rationale of Dedicated Low Emitting CNG Cars,” SAESP-997 ‘Advanced Emission Control Technologies’ 157 177 1993
- Barkhimer R.L. Wong H.-C. “Application of Digital, Pulse-Width-Modulated, Sonic flow Injectors for Gaseous Fuels,” SAE SP-1104 ‘Gaseous-Fuel Engine Technology’ 1 6 1995
- Ting, D.K. Checkel M.D. “The Effects of Turbulence of Spark-Ignited, Ultra Lean, Premixed Methane - Air Flame Growth in a Combustion Chamber,” SAE Paper No. 952410 1995
- Daniels, C.F. “The Comparison of Mass Fraction Burned Obtained from the Cylinder Pressure Signal and Spark Plug Ion Signal,” SAE Paper No. 980140 1998
- Zhang, F.R. Okamoto, K. Morimoto, S. Shoji, F. “Methods of Increasing the BMEP (Power Output) for Natural Gas Spark Ignition Engines,” SAE SP-1371 ‘Combustion Processes in Engines Utilizing Gaseous Fuels’ 11 19 1998
- Zuo, C. Zhao, K. “A Study on the Combustion System of a Spark Ignition Natural Gas Engine,” SAE SP-1371 ‘Combustion Processes in Engines Utilizing Gaseous Fuels’ 21 28 1998
- Brault, J.M. Maymir, D.S. Samimy, M. Matsuki, M. “An Investigation of Mixture Formation Processes During Start-Up of a Natural Gas Powered SI Engine,” SAE SP-1371 ‘Combustion Processes in Engines Utilizing Gaseous Fuels’ 29 41 1998
- Bhargava, S. Clark, N.N. Hildebrand, M.W. “Exhaust Gas Recirculation in a Lean-Burn Natural Gas Engine,” SAE SP-1365 ‘State of Alternative Fuel Technologies’ 83 100 1998
- Sun, X. Lutz, A. Vermiglio, E. Arold, M. Wiedmann, T. “The Development of the GM 2.2L CNG Bi-Fuel Passenger Cars,” SAE SP-1391 ‘Alternative Fuels’ 1 9 1998
- Czerwinski, J. Comte, P. Janach, W. Zuber, P. “Sequential Multipoint Trans-Valve-Injection for Natural Gas Engines,” SAE SP-1436 ‘Combustion in SI Engines’ 1 7 1999
- Jensen, T.K. Schramm, J. Morgen, C. “Unburned Hydrocarbon Emissions from SI Engines Using Gaseous Fuels,” SAE SP-1436 ‘Combustion in SI Engines’ 8 20 1999
- Kato, K. Igarashi, K. Masuda, M. Otsubo, K. Yasuda, A. Takeda, K. Sato, T. “Development of Engine for Natural Gas Vehicle,” SAE SP-1436 ‘Combustion in SI Engines’ 52 60 1999
- Flemming, R.D. O'Neal, G.C. “Potential for Improving the Efficiency of a Spark-Ignition Engine for Natural Gas Fuel,” SAE Paper No. 852073 1985
- Evans, R.L. Blaszcyk, J. “A Comparative Study of the Performance and Exhaust Emissions of a Spark-Ignition Engine Fuelled by Natural Gas and Gasoline,” IMechE 211 39 47 1997
- Catania, A.E. Misul, D. Spessa, E. Martorana, G. “Conversion of a Multivalve Gasoline Engine to Run on CNG,” SAE Paper No. 2000-01-0673 2000
- Heywood, J.B. “Internal Combustion Engine Fundamentals,” McGraw-Hill International Editions 1988
- Ferrari, G. “Motori a combustione interna,” Edizioni «Il Capitello» 1992